ElectrIQ ECOSILENT8-V2 User manual

USER MANUAL

electriQ PORTABLE AIR CONDITIONER

ECOSILENT8-V2

8,000 BTU

ECOSILENT10-V2

10,000 BTU

Thank you for choosing electriQ

Please read this user manual before using this innovative Air Conditioner and keep it

safe for future reference.

Visit our page www.electriQ.co.uk for our entire range of Intelligent Electricals

CONTENTS

SAFETY

FEATURES AND PARTS LIST

INSTALLATION

OPERATION

REMOTE CONTROL

CLEANING AND MAINTENANCE

EMPTYING THE INTERNAL WATER TANK

TROUBLESHOOTING

ERROR CODES

SUPPORT

TECHNICAL SPECIFICATION

SAFETY INSTRUCTIONS

Important!

•Carefully read the instructions before operating the unit

•This appliance is for indoor use only.

•Rating: This unit must be only connected to a 220-240 V / 50 Hz

earthed outlet.

•Installation must be in accordance with regulations of the country where the unit is

used.

•If you are in any doubt about the suitability of your electrical supply have it checked

and, if necessary, modified by a qualified electrician.

•This air conditioner has been tested and is safe to use. However, as with any electrical

appliance - use it with care.

•Disconnect the power from the appliance before dismantling, assembling or cleaning.

•Avoid touching any moving parts of the appliance.

•Never insert fingers, pencils or any other objects though the guard

•This appliance is not intended for use by persons (including children) with reduced

physical, sensory or mental capabilities. It is also not intended for use by those with a

lack of experience and knowledge, unless they have been given supervision or

instruction concerning the use of the appliance by a person responsible for their

safety.

•Do not leave children unsupervised with this appliance.

•Do not clean the unit by spraying it or immersing it in water.

•Never connect the unit to an electrical outlet using an extension cord. If an outlet is

not available, one should be installed by a qualified electrician.

•Never operate this appliance if the cord or plug is damaged. Ensure the power cord is

not stretched or exposed to sharp objects/edges.

•A damaged supply cord should be replaced by the manufacturer or a qualified

electrician in order to avoid a hazard.

•Any service other than regular cleaning or filter replacement should be performed by

an authorised service representative. Failure to comply could result in a voided

warranty.

•Do not use the appliance for any purpose other than its intended use.

•The air conditioner unit must always be stored and transported upright, otherwise

irreparable damage may be caused to the compressor; if in doubt we suggest waiting

at least 24 hours before starting the unit.

•Avoid restarting the air conditioning unit unless 3 minutes have passed since being

turned off. This prevents damage to the compressor.

•Never use the mains plug as a switch to start and turn off the air conditioning unit. Use

the provided ON/OFF button located on the control panel.

•Always place the unit on a dry and stable surface.

•The appliance should not be installed in laundry or wet rooms.

•The appliance must be placed in a room without sources of ignition (for example: open

flames, an operating gas appliance or an operating electric heater).

•R290 refrigerant gas complies with European environmental directives.

•R290 has a low GWP (Global Warming Potential) of 3.

•The ECOSILENT8 contains about 180 g of R290 refrigerant gas.

•The ECOSILENT10 contains about 240 g of R290 refrigerant gas.

•Do not use or store in an unventilated space with an area smaller than 8.7 m2per unit

(ECOSILENT8) or 11.5 m2per unit (ECOSILENT10).

•The room must be such as to prevent stagnation of possible leaks of refrigerant gas as

there could be a danger of fire or explosion should the refrigerant come into contact

with electric heaters, stoves or other sources of ignition.

•Refrigerant gas may be odourless.

•Do not use the product and contact the retailer for advice, if damage has occurred to

the unit which may have compromised the refrigerant system.

•Any repairs or maintenance must only be carried out on the unit by a suitably qualified

engineer. Before opening and servicing the unit the authorised engineer must be in

possession of a copy of the manufacturer’s service manual and must follow the safety

information contained within it to ensure all hazards are minimized.

•The refrigerant system should not be perforated or punctured.

Energy Saving and Unit Safety Protection Tips

•Do not cover or restrict the airflow from the outlet or inlet grills.

•For maximum performance the minimum distance from a wall or objects should be

50cm.

•Keep the filters clean. Under normal conditions, filters should only need cleaning once

every three weeks (approximately). Since the filters remove airborne particles, more

frequent cleaning maybe necessary, depending on the air quality.

•For the initial start-up set the fan speed to maximum and the thermostat to 5 degrees

lower than the current room temperature. After, set appliance to your desired

settings.

•To protect the unit, we recommend not using the cooling function when the ambient

temperature is higher than 35oC.

FEATURES AND PARTS LIST

FEATURES

•3 in 1 Cooling, Fan, Dehumidifier great for rooms up to 20 sqm.

•5 speed fan: Balancing quiet operation with performance.

•24 Hours Start / Stop Timer

•Digital Thermostat: Set the temperature between 17°C and 30°C.

•Remote Control.

•Castors and Handles for Enhanced Portability.

•Auto-Restart to retain the settings in the event of power failure.

PART LIST

Control Panel

Louvres

Top Cover

Rear Housing

Front Cover

Castors

Upper Air Inlet

Handle

Lower Air Inlet

Exhaust Outlet

Power Cable

Slide Bar

Outlet Adaptor

Front Display

Fishtail Adaptor

Exhaust Hose

Drainage Port

Remote Control

Note: Exhaust components require assembly.

Drain Pipe

Slide Bar Fittings

(Plate with thread, Washer and

wing nut)

INSTALLATION

WARNING: Before using this unit, please keep it upright for at least 3-4 hours.

This unit can easily be moved from one room to another.

While moving the unit please note that it must always be kept upright and then placed on an even surface.

1. Attach the fishtail connector to the end of

the hose, by extending the end of the hose

and twisting until firmly attached to the

connector (At least 3 full rotations).

2. Attach the Hose to the Outlet adaptor, in the

same way by extending the end of the hose

and twisting until firmly attached (At least 3

full rotations).

3. Slide the Outlet adaptor into position on the

rear of the unit. The two slips on the unit will

hold it in place. (To remove the adaptor

press the two clips down to release it from

the unit)

4.Make sure the unit is upright and there are no

obstructions to the air inlets and outlet grills, with

at least 50cm of space to the sides and rear of the

unit.

INSTALLATION OF WINDOW KIT

The window kit (slide bar and fishtail) can be used

with sliding windows and doors. For other types of

window, the fishtail should be used on its own.

NOTES:

•The window kit is only designed to be installed with sliding or sash windows or doors. The window

kit is not designed to be used with any other style of windows.

•The fish tail adaptor can be used without the slide bar with most windows / doors.

•When using the air conditioner ensure that the opening around the fishtail adaptor is as small as

possible to ensure the efficiency of the unit is not reduced.

•The best form of installation is through a wall duct. By properly venting you expel hot air from your

room while efficiently cooling it.

•Your air conditioner should be used without the vent pipe in dry mode. When using dry mode

ensure that an external water tank is used, monitored and regularly emptied before overflowing.

Permanent plumbing can be also installed or an external uplift water pump can be set up to allow

for uninterrupted use.

1. Push the screw thread of the plate through

the hole in the rear of the front slide bar

section.

2. Slide the rear section of the slide bar onto the

front section lining up the plate so it runs

within the groove. Extend the bar to the

required length, and use the supplied wing nut

to secure

3. Partially open the

window and place the

extended slide bar in

position before closing

the window onto it.

4. Fix the fishtail adaptor

into the opening on

the slide bar.

Plate

Wing nut

Slide Bar

(Front Section)

Slide Bar

(Rear Section)

IMPORTANT SAFEGUARDS

The length of the soft hose extends from approximately 30 cm to 180 cm. If hose is extended above this

length, the unit may malfunction which can invalidate the warranty. The outlet vent must be well

ventilated and not obstructed as this will cause the unit to overheat. Keep the hose as straight and short

as possible and avoid bending the air hose by more than 30 degrees in order to maintain the

performance of the unit. Excessive bends in the hose may prevent the unit from expelling the hot air,

which can lead to internal damage which would invalidate the warranty.

OPERATION

Press the POWER button to turn the unit ON or OFF.

Press the MODE button to cycle between the 4 modes, the indicator for the selected mode will

be illuminated.

COOL: The room is cooled with the cold air expelled through the front air outlet while hot air is

expelled through the vent pipe. The desired room temperature can be set between 17 and 30

degrees using the + and –buttons, and the fan speed can be changed using the SPEED button.

FAN: The fan speed can be changed pressing the SPEED button.

DRY: Should be operated without the vent hose, but with continuous drainage to remove

moisture from the air. The unit will run in low fan speed, with dH shown on the display. Do not

use when the room temperature is below 15 degrees.

AUTO: The unit will work in cooling mode when the room temperature is 24 degrees or higher.

The fan speed will automatically adjust based on the amount of cooling required. When the

temperature is below 24 degrees the unit will work in fan mode.

Press the SPEED button to change between the five fan speeds. The display and LED’s will

indicate the currently selected fan speed. The fan speed cannot be changed in AUTO and DRY

modes.

Display

LED’s

Low

Low + Med

Med

Med + High

High

Press to enter sleep mode. The sleep indicator will be illumined and all other indicators will be

turned off. In sleep mode, the appliance works at low fan speed. Press SLEEP again to exit sleep

mode.

The unit includes a single use power on timer. With the appliance running with the desired

settings, press the TIMER button to set the power-off timer. Use the + and - buttons to adjust

the duration of the timer (1 to 24 hours). The timer indicator will illuminate and the unit will

stop after selected number of hours.

Used to adjust the temperature in COOL/AUTO mode and to set the duration of the TIMER. The

buttons are not used in FAN or DRY modes. Press both buttons together to change between

displaying the temperature in Celsius and Fahrenheit.

Press this button to enable the swing function. The louvres will slowly move from side to side. If

swing is pressed again the louvres will stop in their current position.

This manual suits for next models

Table of contents

Other ElectrIQ Air Conditioner manuals

ElectrIQ

ElectrIQ AC100R User manual

ElectrIQ

ElectrIQ Platinum Series User manual

ElectrIQ

ElectrIQ iQool9B Operating manual

ElectrIQ

ElectrIQ eiQ-9WMINV-V2 Operating manual

ElectrIQ

ElectrIQ ECOSILENT12 User manual

ElectrIQ

ElectrIQ AIRFLEX15-V2 User manual

ElectrIQ

ElectrIQ iQool-2MS9K9K Operating manual

ElectrIQ

ElectrIQ COMPACT User manual

ElectrIQ

ElectrIQ ECOSILENT8W User manual

ElectrIQ

ElectrIQ ECOSILENT12HPW-V2 User manual

ElectrIQ

ElectrIQ SILENT16 User manual

ElectrIQ

ElectrIQ eiQ-3MS9K9K9K Operating manual

ElectrIQ

ElectrIQ CMAC12M User manual

ElectrIQ

ElectrIQ iQool9 User manual

ElectrIQ

ElectrIQ IQOOL-SMART12HP User manual

ElectrIQ

ElectrIQ eIQ-9WMINV Operating manual

ElectrIQ

ElectrIQ eiQ-FC18K Operating manual

ElectrIQ

ElectrIQ P12HPW User manual

ElectrIQ

ElectrIQ P15C User manual

ElectrIQ

ElectrIQ AIRCUBE 10DLX User manual

ElectrIQ

ElectrIQ P15HP User manual

ElectrIQ

ElectrIQ P16HP User manual

ElectrIQ

ElectrIQ AIRFLEX15 User manual

ElectrIQ

ElectrIQ eiQ-CRFC18K Manual

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual