Ei Electronics Ei 151TLR Ionisation User manual

Shannon Free Zone, Shannon, Co. Clare, Ireland.

Ph.+353 61 471277 Fx.+353 61 471053

Web: www.eielectronics.com

E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice. Ei151TLR DataSht RevB

Model Ei 151TLR Ionisation

Remote control capability

Tamper proof rechargeable lithium battery back up

High performance ionisation chamber

Test/Hush button

Advanced suppression and calibration technology

Interconnectable to other Ei mains powered alarms

Low power cell warning

Kitemarked to BS EN 14604:2005

5 year guarantee

Product Description

The Ei151TLR is an Ionisation Smoke Alarm that runs on

230V AC mains power, and has built in tamper proof

rechargeable lithium cells that act as a battery back up in

the event of mains failure. These rechargeable lithium

cells are designed to have a ten year life and outlast the

life of the smoke alarm itself, whilst providing up to six

months of smoke alarm operation without mains power.

The Ei151TLR allows the detector to be controlled

remotely by either a “Test/Hush” Switch (Ei152), a

“Locate” Switch (Ei159) or a Manual Call Point

(MCP400). If the Ei151TLR is also interconnected to

other Ei mains powered alarms then the whole system

will be controllable remotely.

The Ei151TLR has the ability to interconnect up to twelve

alarms to allow all alarms to sound if just one of the

interconnected alarms should be triggered.

The Ei151TLR has built in circuitry to aid suppression of

voltage transients and RF interference to further reduce

the chances of false alarms under such conditions.

Operation

The green indicator will illuminate to show mains

power is present

The red indicator will flash rapidly to show an alarm

condition for the smoke detector

The “Test/Hush” button will either silence false

alarms or perform a unit self test. In “Test” mode the

alarm will perform a self test and sound the horn

In “Hush” mode the alarm enters a ten minute period

of reduced sensitivity to overcome false alarm

conditions, and will then automatically reset itself

When interconnected to other Ei mains powered

alarms, an alarm on one detector will trigger all other

interconnected alarms within one second (only the

triggered alarm will flash a red indicator)

The smoke detector will emit a beep and flash the

red light every 40 seconds to indicate that the

battery back up is depleted and needs recharging

The detector can be controlled remotely by either a

“Test/Hush” Switch (Ei152), a “Locate” Switch

(Ei159) or a Manual Call Point (MCP400).

MAINS POWERED 230V~

Rechargeable Battery Back-Up

Shannon Free Zone, Shannon, Co. Clare, Ireland.

Ph.+353 61 471277 Fx.+353 61 471053

Email. [email protected]

Web: www.eielectronics.com

E & OE As our policy is one of continuous product development, we reserve the right to alter product details without prior notice. Ei151TLR DataSht RevB

Model Ei151TLR Ionisation

Installation & Placement

Wiring for Interconnected Alarms

Be very careful about correctly wiring the alarms as mixing Live and Neutral

will blow/damage interconnected alarms.

Alarms should be placed in accordance with the general guidelines shown in

the diagram above. These recommendations are based on the problem of

areas of “dead air” close to corners of rooms and apexes of ceilings, which

could result in the prevention of smoke reaching the smoke detector

Please consult instruction booklet for specific installation details

Important Precaution:

Do not install the actual smoke/heat

alarm itself in new or renovated

buildings until all work is completed

(including floor coverings) and the

building has been fully cleaned. The

wiring can be installed when

appropriate. (Excessive dust and debris

from building work can contaminate the

smoke chamber and cause problems,

and it will also invalidate the guarantee).

If it must be installed, cover it

completely, particularly around the

edges, with a dust cover (eg. a plastic

bag), until all cleaning is finished..

Connect wires to the unit as in wiring

diagram. All wiring must comply with

local codes.

Technical Specification

Sensor Ionisation

Sensitivity: Complies with BS 5446 Part 1:

2000

Source: Americium 241

Button Test: Simulates the effect of smoke and

checks electronics and horn.

Supply Voltage: 230V AC

Battery back-up: Rechargeable lithium cells

Power-On Indicator: Continuous green LED

Alarm: Electronic Piezoelectric horn

in unit

Alarm Sound Output: 85dB (minimum) at 3m

Alarm Status: Red LED flashes every second on

unit sensing fire

Temperature Range: 0° to 40°C

Humidity Range: 15% to 95% Relative Humidity

Remote control: Ei152, Ei159 or MCP400

Interconnect: Up to 12 interconnected

Ei150/151TL/151TLR/154TL/155/1

56TLH/156TLR smoke or heat

alarms, along with an EI158 relay

base

Fixing: Screw fixings supplied

Plastic material: UL94VO flame retardant

Dimensions: 140mm x 120mm x 46mm

Weight: 227g

Warranty: 5 year (limited) warranty

Approvals: Kitemarked to BS EN 14604:2005,

CE Approved

Specifications are subject to change

Table of contents

Other Ei Electronics Smoke Alarm manuals

Ei Electronics

Ei Electronics Ei140RC Series User manual

Ei Electronics

Ei Electronics Ei100BNX Manual

Ei Electronics

Ei Electronics Ei603MRF User manual

Ei Electronics

Ei Electronics EI 100C Interconnect User manual

Ei Electronics

Ei Electronics Ei160e Series User manual

Ei Electronics

Ei Electronics Ei 169 Manual

Ei Electronics

Ei Electronics Ei154TL User manual

Ei Electronics

Ei Electronics EI 159 User manual

Ei Electronics

Ei Electronics Ei603CRF User manual

Ei Electronics

Ei Electronics EI 100L Emergency Light User manual

Ei Electronics

Ei Electronics Ei 156TLR Optical User manual

Ei Electronics

Ei Electronics Heat Alarm Ei 103R User manual

Ei Electronics

Ei Electronics EI 100B Standard Manual

Ei Electronics

Ei Electronics Ei3105RF Optical Manual

Ei Electronics

Ei Electronics EI 103C Manual

Ei Electronics

Ei Electronics Ei405TY RF Optical User manual

Ei Electronics

Ei Electronics Ei 100R Ionisation User manual

Ei Electronics

Ei Electronics BROOKS EIB160e Series User manual

Ei Electronics

Ei Electronics Ei156TLH Optical User manual

Ei Electronics

Ei Electronics Ei 176 Optical User manual

Ei Electronics

Ei Electronics Ei146 Optical User manual

Ei Electronics

Ei Electronics Ei 184 User manual

Ei Electronics

Ei Electronics RF Tool User manual

Ei Electronics

Ei Electronics Ei605MTYRF User manual

Popular Smoke Alarm manuals by other brands

x-sense

x-sense SD19-W user manual

BRK electronic

BRK electronic First Alert P1010 quick start guide

FireAngel

FireAngel Thermoptek ST-622 user manual

teko

teko Astra-42A user guide

Safetec

Safetec SDS-2/6 Additional Fault Finding Instructions

Siemens

Siemens PE-11C installation instructions

System Sensor

System Sensor DH500ACDC Installation and maintenance instructions

Resolution Products

Resolution Products RE612 CryptiX quick start guide

First Alert

First Alert PC900V user manual

Eminent

Eminent EM6590 E-Domotica user manual

Carrier

Carrier Kidde Quell Q301 user manual

VESDA

VESDA VLF-500 Product guide

ELRO

ELRO FS8110 instruction manual

Heiman

Heiman SMOKI NS-626PHS user manual

Regin

Regin SDD-S65 instruction manual

Family Gard

Family Gard FG225 user manual

Greystone

Greystone DSD120 Installation and maintenance instructions

Aparton

Aparton ASD-10 Instructions for use