E2S D1*CP1-PS Series User manual

D1xCP1-PS SERIES

EXPLOSION PROOF MANUAL PULL STATIONS

The D1xCP1-PS Series of Explosion Proof Manual Pull Stations is UL and FM listed for use in

hazardous environments, and for Nema Type 4X weatherproof applications. The unit also complies

with ADA standards when installed at less than 48 inches above the floor for front wheelchair access,

and less than 54 inches for side wheelchair access. All Installations must comply with local codes and

regulations.

Ratings: Listed By: UL, FM, CSFM, MEA

Enclosure: Class I, Groups B, C, and D. Class II, Groups E, F, and G. Class III.

NEMA 4X (Weatherproof), MARINE.

Contacts: D.P.D.T 10 Amps, 120 VAC

1 Amp, 30 VDC

Installation:

(Please refer to assembly diagram and installation notes on the back side)

The D1xCP1-PS model station includes a front housing, a back box, a switch plate, and all the

necessary hardware to assemble the station.

•Install the back box onto its mounting surface using the 4 holes provided on the mounting tabs. The

tabs are designed to accept a screw size of up to 1/4".

•The back box is supplied with two 3/4"-14 NPT conduit entries. Threaded joints between conduit and

back box must be made with a minimum of 5 threads fully engaged. Seal unused conduit entry with a

UL listed close-up plug for use in the hazardous locations listed above in the ratings section. Joint

sealing material may be used if it is a non-drying slushing compound, petroleum jelly or soap-thickened

mineral oil.

•Connect the field wiring to the terminal blocks on the adaptor plate. Use the insulated terminal lug

supplied to ground the box properly. Each wire or terminal lug must be placed under its corresponding

clamping plate for proper connection.

•Install the switch plate onto the back box using the 4 1/4-20x7/8 pan head screws provided. Make

sure that the o-ring seals on the screws and around the edge of the switch plate are properly seated.

•Open the front housing, align its mounting plate with the pins provided on the switch plate and attach

it using the two 6-32 screws provided into the slotted holes.

This manual suits for next models

Table of contents

Popular Security System manuals by other brands

Inner Range

Inner Range Concept 2000 user manual

Climax

Climax Mobile Lite R32 Installer's guide

CADDX

CADDX NX-6 user manual

FBII

FBII XL-31 Series installation instructions

Johnson Controls

Johnson Controls PENN Connected PC10 Install and Commissioning Guide

Aeotec

Aeotec Siren Gen5 quick start guide

Blaupunkt

Blaupunkt SA 2700 quick start guide

IDEAL

IDEAL Accenta Engineering information

AJAX

AJAX DoubleButton user manual

Swann

Swann SW-P-MC2 Specifications

Ecolink

Ecolink Siren+Chime user manual

Digital Monitoring Products

Digital Monitoring Products XR150 user guide

EDM

EDM Solution 6+6 Wireless-AE installation manual

Highway Safety Group

Highway Safety Group EA401 user manual

Siren

Siren LED GSM operating manual

Detection Systems

Detection Systems 7090i Installation and programming manual

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 instructions

Siemens

Siemens FDM273 manual