2UNIQUIN locks 2018-10
WN 059607 45532
dormakaba Mounting instructions About this manual
1 About this
manual
1.1 Information about the
manual
This manual describes the installation of
UNIQUIN locks onto a glass door as part of
a UNIQUIN door frame system and includes
maintenance and care information.
For the complete installation of the
UNIQUIN partition wall unit, further unit
components and installation manuals may
be required as specified in the project-
related unit drawing, e.g. for the door frame
system. The illustrated unit components and
configurations are exemplary and do not
show every possible installation scenario.
The components illustrated are shown in one
opening direction as an example.
1.2 Other applicable
documents
Refer to the following technical documents
for the product:
• The project-related unit drawing
• The enclosed installation manual for the
unit components included with delivery
• The installation manuals of all unit
components
• The UNIQUIN system manual
1.3 Target group
The target group of these installation
manual is qualified personnel specially
trained in glass fitting.
1.4 Symbols used
1.4.1 Safety instructions
Safety instructions are marked with
symbols. The safety instructions are
introduced by signal words that express the
extent of the hazard, e.g.:
CAUTION
This signal word indicates a
situation of potential risk, which
could lead to minor or slight
injury if not averted.
ATTENTION
This signal word indicates a
situation of potential risk, which
could lead to damage to property
or the environment if not
averted.
TIPS AND RECOMMENDATIONS
This signal word indicates useful
information for efficient and
trouble-free operation.
1.4.2 Further labeling
2.1. Step-by-step graphics
1 2 Position numbers for parts
in diagrams
2 Safety
2.1 Intended use
This product is designed to be used to
facilitate the opening and closing of a glass
door in a door frame system as part of a
UNIQUIN unit.
• The product may only be installed with
unit components designed by dormakaba
for the installation situation and approved
according to the project-related unit
drawing.
