P/N 735.028 Rev N • 05/18 ©copyright 2006-2018 7
ACTIVATE USERS
1. Enter Default Manager combination (all 5’s to length of combination) and
hold down last digit of combination until lock double signals twice release and
the LED stays on.
2. PRESS 1.
3. Enter User number (1 - 9.)
4. Enter the NEW User combination
5. Re-enter the User combination to confirm.
6. Repeat steps 1- 5 for each User to be added.
NOTE: If a User is not enrolled during setup, the User is blocked and cannot
be added later. New combinations are rejected when less than 2 digits are
different from existing combinations.
Set Time Delay Values:
The Delay and Open Periods may be set up at this time or later by the
Manager. To set the Time Delay Periods follow the instructions below or refer
to Manager Instructions 732.018.
1. Enter Manager combination and hold down last digit of combination until
lock double signals release and the LED stays on.
2. PRESS 9.
3. Enter two-digit Delay Period value (00 to 99 minutes) followed by the
two-digit Open Period value (00 to 19 minutes).
4. Re-enter the Delay and Open Period values to confirm.
ACTIVATE THE LOCK
To complete the activation of the lock and freeze the configuration, the
Manager combination MUST be changed
To change the Manager combination, follow the steps below:
WARNING: Add all required Users and complete Setup Configuration before
changing the Manager’s default combination from 5-5-5-5-5-5. Once the
combination is changed, NO ADDITIONAL USERS can be added.
CAUTION: Always perform this operation with the door open!
1. Enter the default Manager combination and hold down the last digit until
unit double signals twice release and the LED stays on.
2. PRESS 0.
3. Enter your NEW combination,
4. Re-enter your NEW combination to confirm.
5. The lock is now active and the configuration is frozen.
6. Test lock operation several times before closing the door.
NOTE: If default combinations are used, it is recommended that they be
changed. New combination will not be accepted if it varies from the current
combination by only one digit (+/-). When selecting a combination, do not
use a birthday or other predictable information that could give correlation
between the user and the combination.
