Dimplex LKD20-AU User manual

8/54652/0 Issue 1

The product complies with the European Safety Standards and the European Standard Electromagnetic Compatibility (EMC). These cover the

essential requirements of EEC Directives.

AUS/NZ

LECKFORD

LKD20-AU

ABCDEF

General

Unpack the heater carefully and retain the packaging for

possible future use, in the event of moving or returning

the re to your supplier.

These models are designed to be free standing and are

normally positioned against a wall.

The re incorporates a ame effect, which can be used

with or without heating, so that the comforting effect may

be enjoyed at any time of the year. Using the ame effect

on its own only requires little electricity.

Please note: Used in an environment where background

noise is very low, it may be possible to hear a sound

which is related to the operation of the ame effect. This

is normal and should not be a cause for concern.

IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE

Important Safety Advice

When using electrical appliances, basic

precautions should be followed to reduce

the risk of re, electric shock, and injury to

persons, including the following:

If the appliance is damaged, check imme-

diately with the supplier before installation

and operation.

Do not use this appliance in the immediate

surroundings of a bath, shower or swimming

pool.

Do not use outdoors.

This appliance must not be located imme-

diately above or below a xed socket outlet

or connection box.

WARNING : The appliance carries

the Warning Symbol indicating that it must

not be covered or has a Do not cover label.

Do not cover or obstruct in any way the heat

outlet grille located underneath the appli-

ance Overheating will result if the appliance

is accidentally covered. Do not place materi-

al or garments on the appliance, or obstruct

the air circulation around the appliance, for

instance by curtains or furniture, as this

could cause overheating and a re risk.

In the event of a fault unplug the heater.

Unplug the appliance when not required

for long periods. The supply cord must be

placed on the right hand side of the heater

away from the heat outlet underneath the

appliance.

This appliance is not intended for use by

persons (including children) with reduced

physical, sensory or mental capabilities,

or lack of experience and knowledge,

unless they have been given supervision

or instruction concerning use of the appliance

by a person responsible for their safety.

Children shall not play with the appliance.

Cleaning and user maintenance shall not

be made by Children without supervision.

Children should be kept away unless con-

tinuously supervised. Children shall not

turn on/off the appliance. Children shall not

plug in, regulate and clean the appliance or

perform user maintenance.

The appliance must be positioned so that

the plug is accessible.

Although this appliance complies with safety

standards, we do not recommend its use on

deep pile carpets or on long hair type of rugs.

If the supply cord is damaged it must be

replaced by the manufacturer or service

agent or similarly qualied person in order

to avoid a hazard.

CAUTION: In order to avoid a hazard due

to inadvertent resetting of the thermal cut-

out, this appliance must not be supplied

through an external switching device, such

as a timer, or connected to a circuit that is

regularly switched on and off by the utility.

CAUTION - Some parts of this product

can become very hot and cause burns.

Particular attention has to be given where

children and vulnerable people are present.

Operating Instructions - See Fig. 2&3

Icon Display Funtion Description

A-Power /

Standby

Press Once to turn the product ‘ON’.

Press a second time to put the product into ‘STANDBY’

(When returning from ‘STANDBY’ mode the product will return to previous settings unless

the product has been unplugged, in which case it will reset to factory settings)

‘FLAME EFFECT’ button this turns the ame effect ON or OFF independently of the

products other features.

+ Flame

This Button will increase the brightness of the ame effect. There are 5 brightness settings

shown as F1, F2, F3, F4, F5. This button will ONLY increase the brightness level.

- Flame

Down

This Button will decrease the brightness of the ame effect. There are 5 brightness settings

shown as F1, F2, F3, F4, F5. This button will ONLY decrease the brightness level.

-Flame

Cycling

This setting is set by pressing the Flame Up button once more after F5. this will cause the

brightness of the ame effect to cycle from F2 to F5 in a continuous Loop.

-Off

This will turn the ame effect off. If the heater is ON, the display will activate and remain

active to read the set temperature and show if the product is on LOW HEAT/ HIGH HEAT/

COOL BLOW.

CSleep

Timer

Press multiple times to change the ‘SLEEP TIMER’ in 0.5 hr increments from 0.5

hr to 8.0 hr before turning off. The remaining time on the ‘SLEEP TIMER’ displa

ys. (This icon is Green in Colour)

‘HEAT’ button cycles the unit sequentially through the 4 settings: LOW HEAT, HIGH HEAT,

COOL BLOW and OFF. The heat setting will be indicated by an icon in the display see Fig.1.

When the ame effect is ‘ON’ the display will turn off after 5 seconds, however if the

heater is being used independently of the ame effect. The low heat or high heat icon

will appear continuously in the display.

Low

Heat

This setting will run the heater at ‘LOW HEAT’ this setting will be indicated by the ‘LOW

HEAT’ icon. To Adjust the temperature setting the Temp Down or Temp Up buttons de-

scribed below must be used.

(This icon is Orange in Colour)

High

Heat

This icon in the display indicates ‘HIGH HEAT’ this setting will be indicated by the ‘HIGH

HEAT’ icon. To Adjust the temperature setting the Temp Down or Temp Up buttons de-

scribed below must be used.

(This icon is Red in Colour)

Cool

Blow

This icon in the oating display indicates ‘COOL BLOW’ this setting will be indicated by

the ‘COOL BLOW’ icon and the letters ‘CB’ appearing in the display.

(This icon is Blue in Colour)

- Off This switches the heater and blower ‘OFF’, no icon will be displayed in the display. Note

the blower will run for 5-10 seconds after being turned off, this is to ensure the product

cools down safely.

E-Temp

Press multiple times to increase the heater temperature in 10C in-

crements. The highest temperature that can be set 300C .

When High Heat is selected, the letters ‘HH’ appear in the display, this means

the heat will remain ON continusously and is not controlled by the thermostat.

F-Temp

Down Press multiple times to lower the heater temperature in 10C in-

crements. The lowest temperature that can be set is180C .

-‘Top light’ button this turns the top light ON or OFF independently of the products other

features.

User Modes:

Mode Name /Discription Action (Actions cannot be input by remote control)

Change Celsius (0C) to Fahrenheit (0F) Press both Temp down ( ) and Temp up ( ) on the unit and hold until

beep is heard and display flashes. (To revert back to Celsius repeat this action)

Thermal Safety Cut-out

The built-in overheat cut-out switches off the appliance automatically in

the event of a fault. If this occurs switch off the appliance or disconnect

the mains plug from the socket. After a short cooling down phase, the

appliance is ready for use again. If the fault should occur again, see

your local dealer.

Cleaning

WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY

BEFORE CLEANING THE HEATER.

For general cleaning use a soft clean duster – never use abrasive

cleaners. The glass viewing screen should be cleaned carefully with a

soft cloth. DO NOT use proprietary glass cleaners.

To remove any accumulation of dust or uff the soft brush attachment of

a vacuum cleaner should occasionally be used to clean the outlet grille

of the fan heater.

Recycling

At the end of the electrical products useful life it should not

be disposed of with household waste. Please recycle where

facilities exist. Check with your Local Authority or retailer for

recycling advice in your country.

After Sales Service

Should you require after sales service or should you need to

purchase any spares, please contact the retailer from whom

the appliance was purchased or contact the service number

relevant to your country on the warranty card.

Please do not return a faulty product to us in the rst instance

as this may result in loss or damage and delay in providing

you with a satisfactory service. Please retain your receipt as

proof of purchase.

Electrical connection

WARNING – THIS APPLIANCE MUST BE EARTHED.

This heater must be used on an AC ~ supply only and the voltage

marked on the heater must correspond to the supply voltage.

Before switching on, please read the safety warnings and operating

instructions.

Remote control - see Fig. 3

The maximum range of use is ~ 5metres.

Warning: It takes time for the receiver to respond to the transmitter.

Do not press the buttons more than once within two seconds for

correct operation.

Battery information - see Fig. 3

1. To activate the remote control remove the battery isolation strip,

which is used to ensure your remote control reaches you fully charged.

2. To replace the remote control battery, turn over the remote control,

and follow the diagram embossed on the remote control

3. Only use CR2025 size of batteries.

Discard leaking batteries

Dispose of batteries in the proper manner according to provincial

and local regulations.

Any battery may leak electrolyte if mixed with a different battery

type, if inserted incorrectly, if all the batteries are not replaced at the

same time, if disposed of in a re, or if an attempt is made to charge

a battery not intended to be recharged.

WARNING - KEEP BATTERIES OUT OF REACH

OF CHILDREN

1. Swallowing may lead to serious injury in as little as 2 hours or death,

due to the chemical burns and potential perforation of the oesophagus.

2. If you suspect your child has swallowed or inserted a button battery

immediately call the 24-hour Poisons Inforation Centre on 13 11 26 (in

Australia) or 0800 764 766 (in New Zealand) for fast, expert advice.

3. Examine devices and make sure the battery compartment is

correctly secured, e.g. that the screw or other mechanical fastener

is tightened. Do not use if the compartment is not secure.

4. Dispose of used button batteries immediately and safely. at

batteries can still be dangerous.

Maintenance

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY

BEFORE ATTEMPTING ANY MAINTENANCE.

Light Emitting Diode

This re is tted with LED (Light Emitting Diode) lamps. These LED

lamps are maintenance-free and should not require replacing during

the life of the product.

Glen Dimplex Australia Pty Ltd.

1340 Ferntree Gully Road,

Scoresby,

VIC 3179,

Australia

www.dimplex.com.au

[email protected]

Ph: 1300 556 816

Fax: 1800 058 900

Glen Dimplex Australasia Ltd.

35 Harris Road,

East Tamaki,

Auckland

New Zealand

www.dimplex.co.nz

[email protected]

Ph: 09 274 8265

Fax: 09 274 8472

Other manuals for LKD20-AU

This manual suits for next models

Table of contents

Other Dimplex Indoor Fireplace manuals

Dimplex

Dimplex YEO20 User manual

Dimplex

Dimplex DWF1146GP User manual

Dimplex

Dimplex VCX1525-EU User manual

Dimplex

Dimplex DIMPLEX ELECTRIC FIREPLACE Operating instructions

Dimplex

Dimplex Optiflame MiniMozart FGA15E Instruction Manual

Dimplex

Dimplex 314CHE User manual

Dimplex

Dimplex DFB4047 User manual

Dimplex

Dimplex Opti-myst User manual

Dimplex

Dimplex DWF3651B User manual

Dimplex

Dimplex 6911540100 User manual

Dimplex

Dimplex Eltham Mantel 2kW User manual

Dimplex

Dimplex XHD23 User manual

Dimplex

Dimplex DFI400R User manual

Dimplex

Dimplex DWF1215B User manual

Dimplex

Dimplex OLF46-AM User manual

Dimplex

Dimplex Revillusion RLG20 EU User manual

Dimplex

Dimplex Cavendish CSH20 User manual

Dimplex

Dimplex DF2624L User manual

Dimplex

Dimplex CASSETTE M User manual

Dimplex

Dimplex SYMPHONY SF5598 Quick start guide

Dimplex

Dimplex DF2608 User manual

Dimplex

Dimplex DF2000L User manual

Dimplex

Dimplex MULTIFIRE DF3015 User manual

Dimplex

Dimplex Cassette L Pebble User manual

Popular Indoor Fireplace manuals by other brands

Brigantia

Brigantia 35-DVRS31N-2 User's installation, operation and maintenance manual

Nordpeis

Nordpeis Bergen Installation and user manual

Superior

Superior BCT2536TMN Installation and operation instructions

Quadra-Fire

Quadra-Fire 5100I-GD-B owner's manual

Renaissance

Renaissance RUMFORD 1000 user manual

Lacunza

Lacunza IV-800 Instruction book

Baxi

Baxi 940 Installer and owner guide

Dru

Dru Maestro 60/2 Tall RCH installation manual

Diamond Fireglass

Diamond Fireglass SS-O22 General assembly, installation, and operation instructions

HearthStone

HearthStone Windsor Bay 8830 Owner's manual and installation guide

Napoleon

Napoleon ASCENT B42 quick start guide

Enviro

Enviro E33GI owner's manual

Smeg

Smeg L30 FABE Installation & user's instructions

KEDDY

KEDDY K700 Installation instructions care and firing instructions

Godin

Godin 3451 manual

Jøtul

Jøtul Jotul GI 535 DV IPI New Harbor Installation and operation instructions

Austro Flamm

Austro Flamm Heidi Back 2.0 945048 operating manual

Desa

Desa CCFPDFT Owner's operating & installation manual