Dimplex WFE3BE User manual
08/53943/0 ISSUE: 1
WFE Wall Fan Convector
Model: WFE3BE, WFE3SE
INSTRUCTION MANUAL
Installation and Operating
This product is supplied and operated with a Bluetooth Remote Control handset
IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR
FUTURE REFERENCE. Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE ISTRUCTIONS MAY CAUSE INJURY
AND/OR DAMAGE AND MAY INVALIDATE YOUR GUARANTEE
WARNING – This appliance must not be used in a bathroom.
WARNING – Do not use this heater in the immediate surroundings of a bath,
shower or a swimming pool.
WARNING – This heater must not be located immediately above or below a
xed socket outlet.
WARNING - This heater must be earthed
The supply circuit to the heater must incorporate a double pole isolating switch
having a contact separation of at least 3mm in all poles.
WARNING – Ensure all packaging including Bluetooth remote control is
removed from the inside of the product before wall mounting or startup.
DO NOT - Use the heater until it is wall mounted correctly.
The heater carries a warning ‘Do Not Cover’ to alert the user to the risk of
overheating that exists if the heater is accidentally covered.
Keep combustible materials such as drapes and other furnishings clear from the
front of the heater. Do not use heater to dry your laundry.
NEVER cover or obstruct in any way the air inlet slots at the front of the heater
or the heat outlet slots in the base of the heater.
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
expierience or knowledge if they have been given supervision or instruction
concerning the use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without
supervision.
Children of less than 3 years should be kept away unless continuously
supervised.
Children aged from 3 years and less than 8 years shall only switch on/ o
the appliance provided that it has been placed or installed in its intended
2
normal operating position and they have been given supervision or instruction
concerning the use of the appliance in a safe way and understand the hazards
involved.
Children aged from 3 years and less than 8 years shall not plug in, regulate and
clean the appliance or perform user maintenance.
CAUTION: Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vunerable people are
present.
If young children, the aged, or inrm are likely to be left in the vicinity of the
heater, we advise that adequate precautions should be taken. We recommend
that a guard be tted to ensure contact with the heater is avoided and objects
cannot be inserted into the product.
WARNING: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and o by the utility.
DO NOT use where excessive dust or moisture is present. For further
information, please contact our guard supplier direct on Tel. No. 01603 667957,
or in the case of diculty or for further advice contact our Customer Helpline.
WARNING: KEEP BATTERIES OUT OF REACH OF CHILDREN
• Swallowing may lead to serious injury in as little as 2 hours or death, due to
chemical burns and potential perforation of the oesophagus.
• If you suspect your child has swallowed or inserted a battery go straight to a
hospital emergency room.
• Examine devices and make sure the battery compartment is correctly
secured, i.e. that the battery cover is tted securely. Do not use if the
compartment is not secure.
• Dispose of used batteries immediately and safely. Flat batteries can still be
dangerous.
3
Model Identifier(s): WFE3BE WFE3SE
Nominal heat output Pnom 3.0kW 3.0kW
Height (mm) 350 350
Width (mm) 571 571
Depth (mm) 120 120
Minimum heat
output (indicative) Pmin 1.0kW 1.0kW
Maximum continuous heat output Pmax,c 3.0kW 3.0kW
Auxiliary electricity Consumption
At nominal heat output elmax 0.00 0.00
At minimum heat output elmin 0.00 0.00
In standby mode elSB <0.0005 <0.0005
Type of heat output/ room temperature control
Electronic room temperature control plus week timer Yes
With open window detection Yes
With adaptive start control Yes
This product complies with Lot20 of the Energy Eciency Directive (2015/1188).
Energy Related Product Directive
Technical Details
4
All Models
Controls
Digitally controlled, Electronic Thermostat
Timer modes:
7 Day Programmable User Timer
Continuous heat modes:
Frost Protect, Runback, Comfort O
Controller UI
Button to initiate pairing with Bluetooth remote
Controller Functions
• Heat Selection: High / Low
• Adaptive-Start
• Advance time period
• Adjustable SP range (7-30°C)
• Bluetooth for control
Construction Durable epoxy-polyester powder coated steel casing with slotted forward
facing grille
Element Stitched element with integral thermal cut-out
Installation Fixed directly to the wall through the back panel
Safety Eelectrical reset, self-hold cut-out
IP Rating No Rating
Battery Backup
None. However all programmed timer proles will be retained during
short term power losses. In order to ensure their correct operation, it is
necessary to restore the time and date settings,this happens automatically
once paired with the remote.
Supply
~230-240 V, 50Hz Class I, with earth wire
Colour / Finish
• Black body with Cherry wood side panels
• Silver body with Black side panels
Approvals CE, BEAB
Warranty 2 years
Country of Origin British Isles
Manufacturer Glen Dimplex Heating & Ventilation (GDC Group Ltd.)
5
Installation
WARNING: The installation of this appliance should be carried out by a competent
electrician and be in accordance with the current IEE wiring regulations
and any local or insurance regulations.
Before undertaking installation work, ensure the electricity supply is disconnected
from any relevant xed wiring. Supply cable is not provided with this appliance, and
a competent electrician should therefore install it.
The appliance must be tted horizontally with the cable or conduitentry at bottom
right. It should be mounted such that the underside is at least 350mm above the oor
and the top of the heater is 150mm below any overhanging shelf or obstruction.
This heater must be used on an A.C.~ supply only and the voltage marked on the
heater must correspond to the supply voltage.
To comply with the I.E.E. Wiring Regulations, the appliance must be earthed; the supply
circuit must be adequate for the input of the appliance, and the circuit protected by
a suitable 13A fuse. A suitable termination to the xed wiring of the premises must
be provided adjacent to the nal position of the appliance. In this instance, such a
termination can be a double-pole switch with a contact separation of at least 3mm in
all poles.
The heater must not be located immediately below a xed socket-outlet
Procedure
Release the front cover from the unit by undoing the two screws under the bottom
edge. Carefully remove the cover by pulling bottom-front forward, and then lift to
release the top from the retaining slots. Remove packaging containing Bluetooth
remote control.
Mark screw xing positions on the wall in accordance with the dimensions shown on
the diagram in Fig 2. The unit must be secured to the wall with four screws through
the holes provided.
The two upper holes are keyhole shaped to enable the two upper screws to be
positioned rst. The unit can then be hung on these screws while the two lower
screws are positioned. Before nally tightening all four screws, ensure the unit is truly
horizontal. Fit a 3 core 1.5 square millimetre exible cord through the cable entry bush,
connect wires to the appropriate terminals and tighten cable clamp.
Alternatively the heater may be connectedwith conduit through the base after
removing the knockout containing the cable entry bush (see ‘A’ in Fig. 2).
6
Fig. 1
Fig. 2
shelf
571mm
510mm
150mm min
6mm
8mm
10mm
350mm
280
mm
‘A’ 350mm
35mm
571
mm
120
mm
350
mm
350mm
MIN
7
Wiring
See Fig. 3
Component
A. Terminal Block
B. Cable Clamp
C. Power Supply Cable
After ensuring the electricity supply is not live, electrical connections can be made,
either to an adjacent double-pole switch having a contact separation of at least
3mm in all poles or to a plug-top for use in a standard 13A socket.
If the latter: Connect Green and Yellow wire to plug terminal marked Eor Green or
Green and Yellow. Connect Blue wire to plug terminal marked Nor Black. Connect
Brown wire to plug terminal marked L or Red.
Ret cover, rst hooking top over the back of the unit and then securing the bottom
by retting the two screws under the bottom edge.
The appliance is now ready for use and the electricity supply can be reinstated.
WARNING: This appliance must be earthed
Electrical
A
C
B
Fig. 3
8
9
The product is supplied with a Bluetooth remote control, the remote control should be
contained in the carrier bag along with these instructions. This remote control is required
to operate the appliance. When paired with the remote control various operational modes
and features can be accessed.
IMPORTANT NOTE:
The remote control is required to operate the appliance. It is important
that the remote control remains near the appliance at all times.
Remote Control
1Display Screen
2‘Menu’ Button
3‘Back’ Button
4‘Advance’ Button
5‘Up and Down’ Arrows
6‘Enter’ Button
1
3
6
2
4
5
10
This manual suits for next models
1
Table of contents
Other Dimplex Heater manuals
Dimplex
Dimplex IRC 400 A User manual
Dimplex
Dimplex PPC0500 Installation instructions manual
Dimplex
Dimplex XT User manual
Dimplex
Dimplex Q-Rad QRAD050E User manual
Dimplex
Dimplex Alta Series User manual
Dimplex
Dimplex Unidare UPX Series User manual
Dimplex
Dimplex M2GTS User manual
Dimplex
Dimplex Saletto LPP050 User manual
Dimplex
Dimplex OFRC10ECCb User manual
Dimplex
Dimplex EF12 Series User manual
Dimplex
Dimplex DXU2LCD User manual
Dimplex
Dimplex ECR15 User manual
Dimplex
Dimplex FX 20 IPX4 User manual
Dimplex
Dimplex XL6N User manual
Dimplex
Dimplex RCH5031W User manual
Dimplex
Dimplex RSH Series User manual
Dimplex
Dimplex VFMi 20 C User manual
Dimplex
Dimplex OFC2000 User manual
Dimplex
Dimplex EWA-C Series User manual
Dimplex
Dimplex DHCERA15M User manual
Popular Heater manuals by other brands
oventrop
oventrop Regucor Series quick start guide
Blaze King
Blaze King CLARITY CL2118.IPI.1 Operation & installation manual
ELMEKO
ELMEKO ML 150 Installation and operating manual
BN Thermic
BN Thermic 830T instructions
KING
KING K Series Installation, operation & maintenance instructions
Empire Comfort Systems
Empire Comfort Systems RH-50-5 Installation instructions and owner's manual
Empire Heating Systems
Empire Heating Systems WCC65 Installation and owner's instructions
Wetekom
Wetekom 92 86 43 Original instructions
Desa
Desa SPC170-F owner's manual
Watlow
Watlow Watrod Electric Tubular Heaters Specifications
Haverland
Haverland ECO-DRY GPS Series Instruction & installation manual
Stelpro
Stelpro ASILVC2060 Series user guide