Dimplex DCTF81R User manual

For domestic household use only.

INSTRUCTION MANUAL

81cm Tower Fan with Remote

Model: DCTF81R

IMPORTANT

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND

RETAINED FOR FUTURE REFERENCE.

Note also the information presented on the appliance

CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE

INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY

Please read the operating instructions carefully before using your fan for

the rst time and keep them in a safe place.

WARNING – This appliance must not be used in a bathroom.

WARNING – Do not use this appliance in the immediate surroundings of a

bath, a shower or a swimming pool.

• If the mains lead is damaged it must only be replaced by the manufacturers

service agent or a similarly qualied person in order to avoid a hazard.

• This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure they do not play with the

appliance.

• Prior to cleaning or other maintenance, the appliance must be

disconnected from the supply mains.

• Never immerse the appliance in water or other liquids.

• Operate this unit only on a rm, at surface.

• Do not place on soft, unstable or non-horizontal/angled surfaces.

• Never operate the appliance if a cable or connector has been damaged,

after appliance malfunction or if the appliance was dropped or is

otherwise damaged.

• Please ask a professional service agent to repair the product. Improper

repair may cause danger to users.

• Disconnect the appliance from mains power whenever it is not in use,

before relocating it, and before cleaning.

• Operate the appliance only at the voltage specied on the rating label.

• Only connect the unit to a properly installed and easily accessible socket

so that you can quickly disconnect the plug if necessary.

• Do not connect this product to the mains using an extension lead.

• This fan is only intended for INDOOR RESIDENTIAL applications. This

fan should not be used for commercial or industrial or leisure applications

or in small enclosed spaces.

• Never use the mains lead as a carrying strap or pulling lead.

• To avoid a re or electrocution hazard, NEVER put the cord near heat

registers, radiator, stoves or heaters.

• DO NOT cover cord with carpeting, throw rugs, runners, or similar

coverings.

• DO NOT route cord under furniture or appliances. Take care to position

the cord away from trac areas and where it will not be a tripping

hazard.

• DO NOT use the unit near windows or where water collects. Rain and

water collection may lead to a risk of re or electric shock.

• Only operate this appliance with a minimum of 50cm clearance all

around i.e. away from walls, furniture and overhanging objects such as

curtains or a shelf.

• WARNING: To avoid danger of suocation please remove all packaging

materials particularly plastic and EPS and keep these away from

vulnerable people, children and babies.

• NEVER drop or insert any object or ngers into any openings.

• Do not use the appliance in locations where paint, petrol or other

ammable liquids are used or stored.

• If the supply cord is damaged, it must be replaced by the manufacturer,

its service agent or similarly qualied persons in order to avoid a hazard.

• Do not use bug sprays or other ammable cleansers/vapour sprays on

or around the unit.

• Always switch o the unit and take the plug out of the socket:

•

If you are not using the unit

•

Before you clean or carry out maintenance on the unit

•

If a fault occurs

•

In the event of an electrical storm.

• Avoid electromagnetic interference. Keep the unit at least 1 metre away

from electrical appliances such as televisions & radios.

WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN

• Swallowing may lead to serious injury in as little as 2 hours or death, due

to chemical burns and potential perforation of the oesophagus.

• If you suspect your child has swallowed or inserted a button battery

immediately call the 24-hour Poisons Information Centre on 13 11 26 (in

Australia) or 0800 764 766 (in New Zealand) for fast, expert advice.

• Examine devices and make sure the battery compartment is correctly

secured, e.g. that the screw or other mechanical fastener is tightened.

Do not use if the compartment is not secure.

• Dispose of used button batteries immediately and safely. Flat batteries

can still be dangerous.

Using the Remote Control

1. Open the battery cover of the remote control, and insert a CR2025

battery.

2. Please point to the receiver and be within 10m when using the remote

control.

3. When the battery voltage starts to become low, please open the

battery cover and replace with a new battery (CR2025). Then replace

the battery cover.

Exposed to the

weather outdoors

Near water If the power cable

wires are frayed or cut

Where small children

may be left unattended

If an extension

lead may become

overloaded

Where there is risk

of re or close to

a naked ame

Where the power

cable may be

damaged

On a slope or

uneven surface

Where it may be

damaged by

chemicals

If there is a risk

of water falling on

the unit

Where there is a risk

of interference by

foreign objects

This product is not

made for DIY repair

Model no. DCTF81R

Colour

Black

Power supply

220-240V~, 50Hz

Rated power

45W

Speed settings

Modes 3

Timer 0-7.5 hours

Air volume 18.10m³/min

Oscillating 70 degrees

Controls Button or remote

Cord storage N

Noise level (MAX)

54dB(A)

Weight (net) 1.9kg

Dimensions (w x d x h) 240 x 240 x 810mm

Specication

• For greater precision, please always refer to the rating label placed on the product.

Parts

Air outlet

LED Display

Remote control &

storage slot

Base

Remote

Rear cover

POWER

SPEED/ON OSC

TIMER MODE

POWER

SPEED/ON OSC

TIMER MODE

Assembly

Please refer to the below instructions & diagram to assemble the base to the body

of the tower fan.

1. Remove the base locking collar (4) (twist anti-clockwise).

2. Position the two base shells together (2 & 3) and feed the power cord (1) through

the opening.

3. Close the base together by rmly tightening the 4 screws provided.

4. Attach the base onto the bottom of the tower fan by aligning the locking tabs

with the corresponding slots.

5. Secure it into position by twisting the base locking collar (clockwise direction).

6. Plug into an appropriate power supply.

Base Assembly

1h0.5h 4h2h MEDHI ModeLO

1h0.5h 4h2h MH ModeL

Operation

This tower fan can be operated by the control panel or remote control. Please refer to

the below diagrams for descriptions.

Timer button

Remote storage

Oscillation button

Mode button

Button Controls

LED Display

On/Speed button

1h0.5h 4h2h MEDHI ModeLO

1h0.5h 4h2h MH ModeL

OFF button

Normal: When this mode is selected, the fan will operate as normal, in the settings

selected (red indicator light).

Natural: This mode cycles through Low, Medium, High for 5 seconds each (green

indicator light).

Sleep: The sleep mode varies depending on what speed the fan is working in at the

time of selection (yellow indicator light). Refer to the below examples:

Low Speed - the fan will work at this speed without change until it is

turned o (either manually or by the timer).

Medium speed - the fan will work at medium speed for 30 minutes, then

switch to low speed until it is turned o.

High Speed - the fan will work at high speed for 30 minutes, then switch

to medium speed for 30 minutes, and nally work in low speed before

it is turned o.

Operation

Note: All functions of the unit can be operated by the control panel or remote

control.

1. Place the fan on a at stable surface and plug into a power outlet.

2. Press the SPEED/ON button to turn the unit ON and select the desired speed

setting.

3. There are 3 SPEED settings – 1 (Low), 2 (Medium) and 3 (High).

4. Press the TIMER button the set the auto-o timer in 0.5 hour increments, up to a

maximum of 7.5 hours.

5. Press the MODE button to seclect either Normal, Natural, or Sleep modes. Note:

The MODE LED indicator light changes color depending on the MODE selected.

Red = Normal mode, Green = Natural mode & Yellow = Sleep mode.

6. Press the OSC button to start/stop the left to right oscillation function.

7. Press the OFF button to turn the unit o.

Mode Description

Table of contents

Other Dimplex Fan manuals

Popular Fan manuals by other brands

ELTA FANS

ELTA FANS H03VV-F installation guide

Hunter

Hunter 20714 Owner's guide and installation manual

Emerson

Emerson CARRERA VERANDA CF542ORB00 owner's manual

Hunter

Hunter Caraway Owner's guide and installation manual

Panasonic

Panasonic FV-15NLFS1 Service manual

Kompernass

Kompernass KH 1150 operating instructions

VES

VES FALA100/12V/TR Original instructions

Vertiv

Vertiv Liebert DCD user manual

Westinghouse

Westinghouse GFP Series owner's manual

Venmar

Venmar KUBIX HRV PLUS Series user guide

Maico

Maico ECR 31 installation instructions

Sonnenkonig

Sonnenkonig Dinky instruction manual

S&P

S&P ECOWATT HXBR manual

Wider

Wider IMP03369BH instruction manual

Panasonic

Panasonic F-60DHN Operating and installation instructions

Hinkley

Hinkley HIGHLAND instruction manual

Broan

Broan 766BN installation guide

Premium

Premium PFS16022 Use manual