Dimplex DCPF40CH User manual

For domestic household use

only.

INSTRUCTION MANUAL

40cm HV Pedestal Fan

Model: DCPF40CH

IMPORTANT

THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND

RETAINED FOR FUTURE REFERENCE. Note also the information

presented on the appliance

CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY

AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY

Please read the operating instructions carefully before using your fan for

the first time and keep them in a safe place.

WARNING – This appliance must not be used in a bathroom.

WARNING – Do not use this appliance in the immediate surroundings of a

bath, a shower or a swimming pool.

• If the mains lead is damaged it must only be replaced by the manufacturers

service agent or a similarly qualified person in order to avoid a hazard.

• This appliance is not intended for use by persons (including children) with

reduced physical, sensory or mental capabilities, or lack of experience

and knowledge, unless they have been given supervision or instruction

concerning use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure they do not play with the

appliance.

• The fan must always be switched OFF and disconnected from a power

supply before removing the guard for cleaning.

• Never immerse the appliance in water or other liquids.

• Operate this unit only on a firm, flat surface.

• Do not place on soft, unstable or non-horizontal/angled surfaces.

• Never operate the appliance if a cable or connector has been damaged,

after appliance malfunction or if the appliance was dropped or is

otherwise damaged.

• Please ask a professional service agent to repair the product. Improper

repair may cause danger to users.

• Disconnect the appliance from mains power whenever it is not in use,

before relocating it, and before cleaning.

• Operate the appliance only at the voltage specified on the rating label.

• Only connect the unit to a properly installed and easily accessible socket

so that you can quickly disconnect the plug if necessary.

• Do not connect this product to the mains using an extension lead.

• This fan is only intended for INDOOR RESIDENTIAL applications. This fan

should not be used for commercial or industrial or leisure applications

or in small enclosed spaces.

• Never use the mains lead as a carrying strap or pulling lead.

• To avoid a fire or electrocution hazard, NEVER put the cord near heat

registers, radiator, stoves or heaters.

• DO NOT cover cord with carpeting, throw rugs, runners, or similar

coverings.

• DO NOT route cord under furniture or appliances. Take care to position

the cord away from traffic areas and where it will not be a tripping

hazard.

• DO NOT use the unit near windows or where water collects. Rain and

water collection may lead to a risk of fire or electric shock.

• Only operate this appliance with a minimum of 50cm clearance all

around i.e. away from walls, furniture and overhanging objects such as

curtains or a shelf.

• WARNING: To avoid danger of suffocation please remove all packaging

materials particularly plastic and EPS and keep these away from

vulnerable people, children and babies.

• NEVER drop or insert any object or fingers into any openings.

• Do not use the appliance in locations where paint, petrol or other

flammable liquids are used or stored.

• Do not use bug sprays or other flammable cleansers/vapour sprays on

or around the unit.

• Always switch off the unit and take the plug out of the socket:

•

If you are not using the unit

•

Before you clean or carry out maintenance on the unit

•

If a fault occurs

•

In the event of an electrical storm.

• Avoid electromagnetic interference. Keep the unit at least 1 metre away

from electrical appliances such as televisions & radios.

• DO NOT use this appliance with an extension lead or power board.

Exposed to the

weather outdoors

Near water If the power cable

wires are frayed or cut

Where small children

may be left unattended

No extension leads or

power boards.

Where there is risk

of fire or close to

a naked flame

Where the power

cable may be

damaged

On a slope or

uneven surface

Where it may be

damaged by

chemicals

If there is a risk

of water falling on

the unit

Where there is a risk

of interference by

foreign objects

This product is not

made for DIY repair

Model no. DCPF40CH

Colour

Chrome

Power supply

220-240V~, 50Hz

Rated power

45W

Speed settings

Modes -

Timer -

Air volume 50m3/min

Adjustable height Yes - Max height 1.16m

Tilt adjustable head Y

Horizontal oscillation Y

Noise level (MAX)

65dB(A)

Weight (net) 5.9kg

Dimensions (w x d x h) 450 x 368 x 1160mm

Specification

• For greater precision, please always refer to the rating label placed on the product.

Parts

Rear Guard

Motor housing

Stand base

Main pillar

Height adjustment

knob

Upper pillar

Bolt

Power cord

Speed control

Fixing screws

Motor shaft

Fan blade screw

Fan blade

Front guard

Weight

Speed control

Clamping washer

L-shaped screw

Retaining clip

Pivot knob

Adjustment knob

Neck Retaining

screw

Screw

Nut

Assembly

First assemble the base to the main pillar - refer to Fig. 1 & instructions below:

Power cord

1. First unscrew the L-shaped screw (18) and remove it and the clamping washer

(17) from the bottom of the main pillar (6).

2. Turn over the stand base (15). Place the weight (16) in its place on the underside

of the base and place the clamping washer (17) in the centre of the weighted

base (16).

3. Thread the L-shaped screw (18) through the assembly and into the thread of

the main pillar (6). Tighten firmly, but do not overtighten.

4. Loosen the height adjustment knob and pull the upper pillar out of the main

pillar and secure the knob to the desired height.

Secondly, attach the motor housing to the base & upper/main pillar - refer to Fig 2

& the instructions below:

1. First remove the pivot knob (7) and the bolt (20) from the top of the upper

pillar (6), then remove the neck retaining screw (8) and small adjustment knob

(19) from the motor housing bracket.

2. Place the motor housing on the top of the upper pillar and thread the large

pivot bolt (20) through the bracket. Screw in the small retaining screw (8) and

tighten, but do not overtighten.

3. Fit the large pivot knob (7) onto the end of the bolt (20) and the small

adjustment knob (19) at the other side above the bolt. Tighten the knobs while

holding the fan motor upright.

Adjustment knob

Assembly

Lastly, attach the fan head to the motor - refer to Fig. 3 & the instructions below:

1. Remove the protective sleeve from the motor shaft (12) and the four fixing

screws from the motor housing. Attach the rear guard (4) to the motor housing

(9) using the four screws you just removed. Ensure the handle is at the top.

2. Place the fan blade (3) over the motor shaft (12) and tighten the fan blade

screw completely, ensuring that it tightens against the flat part of the motor

shaft.

3. Remove the front guard screw and nut (2, 5) from the front guard and release

the guard retaining clips (14) around the outside edge outwards.

4. Hang the front guard (1) by its hook over the top of the rear guard (4). Bring the

front guard down to meet the rear guard and fit the guard screw (2) through

the holes in the bottom edge of the guard and tighten with the nut (5). Finally

push the clips inwards until the front guard is attached to the rear guard.

1. Place the fan on a firm level surface. Connect the plug to a power supply and

switch on the power.

2. Turn the fan ON by rotating the speed control knob on the motor housing in

clockwise direction.

3. The fan has 3 SPEEDS to choose from, "1" - Low, "2" - Medium, "3" - High.

4. The airflow direction can be adjusted upward/downward by lifting up or pressing

down the motor housing.

NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your

fingers through the guard.

5. Push the oscillating knob on the motor housing down to start OSCILLATION. Pull

the oscillation knob up to stop OSCILLATION.

6. Turn the speed control knob anti-clockwise to the “0” position to turn the fan

OFF.

Operation

Cleaning

Over time, dust can accumulate on the front & rear grille cover and fan blades, which

can affect the fans performance. It is recommended to clean the fan at least once a

month.

1. Turn the unit OFF and disconnect the appliance from the power supply.

2. Remove any dust build up with a soft brush.

3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used

for any stubborn marks.

Do not use abrasive sponges, scouring pads, or a stiff brush to clean this product.

IMPORTANT

The control panel and other parts must not come into contact with water or any

other liquids.

Storage

If not using the unit for an extended period of time. After cleaning please:

• Turn the unit off, unplug and take care of the mains lead & plug.

•

Cover the unit and store it upright in a location where it will not receive direct

sunlight. NB- Prolonged exposure to direct sunlight will discolour the enclosure.

Other manuals for DCPF40CH

Table of contents

Other Dimplex Fan manuals

Dimplex

Dimplex DCMFBHSH User manual

Dimplex

Dimplex DCPF40 User manual

Dimplex

Dimplex GDC-DF30PMW User manual

Dimplex

Dimplex DCACP30DC User manual

Dimplex

Dimplex DCBOX50MBK User manual

Dimplex

Dimplex GDC-PF46HVC User manual

Dimplex

Dimplex DCPF46 User manual

Dimplex

Dimplex DCMIST25 User manual

Dimplex

Dimplex DCTFP92 User manual

Dimplex

Dimplex DCACE20R User manual

Dimplex

Dimplex DCMIST30 User manual

Dimplex

Dimplex DCTF3HCP User manual

Dimplex

Dimplex DCTF3HCH User manual

Dimplex

Dimplex DCPF50MB User manual

Dimplex

Dimplex DCDF30A User manual

Dimplex

Dimplex Mont Blanc DXMBCF User manual

Dimplex

Dimplex DCTFTT106 User manual

Dimplex

Dimplex DCPF40C User manual

Dimplex

Dimplex DCFF40B User manual

Dimplex

Dimplex DCPFQ35 User manual

Dimplex

Dimplex DCFF46B User manual

Dimplex

Dimplex DCTFDC97 User manual

Dimplex

Dimplex DCACP23 User manual

Dimplex

Dimplex DCPF40CH User manual

Popular Fan manuals by other brands

ELTA FANS

ELTA FANS H03VV-F installation guide

Hunter

Hunter 20714 Owner's guide and installation manual

Emerson

Emerson CARRERA VERANDA CF542ORB00 owner's manual

Hunter

Hunter Caraway Owner's guide and installation manual

Panasonic

Panasonic FV-15NLFS1 Service manual

Kompernass

Kompernass KH 1150 operating instructions

VES

VES FALA100/12V/TR Original instructions

Vertiv

Vertiv Liebert DCD user manual

Westinghouse

Westinghouse GFP Series owner's manual

Venmar

Venmar KUBIX HRV PLUS Series user guide

Maico

Maico ECR 31 installation instructions

Sonnenkonig

Sonnenkonig Dinky instruction manual

S&P

S&P ECOWATT HXBR manual

Wider

Wider IMP03369BH instruction manual

Panasonic

Panasonic F-60DHN Operating and installation instructions

Hinkley

Hinkley HIGHLAND instruction manual

Broan

Broan 766BN installation guide

Premium

Premium PFS16022 Use manual