Digital Equipment LN15 User manual
DIGITAL Laser Printer LN15
User Manual
DIGITAL Laser Printer LN15 User Manual 1-1
1
CHAPTER
Getting Acquainted
The illustrations on the following pages identify the main parts of the
printer and two routes of paper feeding.
These parts are referred to
throughout the manual, so take some time to become familiar with
them.
DIGITAL Laser Printer LN15 User Manual 1-2
Figure 1–1 Front and right side view
Figure 1–2 Rear and left side view
Control panel
Slide cover
(Font/emulation card slot
and RAM card slots inside)
Multi-function feeder
cable
Paper tray
Front cover
(opened)
Upper door
Top cover
(Paper stacker)
Stacker-full sensor
Multi-function feeder
(Optional)
Paper guides
for manual feeding
Paper guides
for stack feeding
Rear stacker
Power switch
Power cord
connector
Centronics parallel
interface connector
Interface board
slot cover
DIGITAL Laser Printer LN15 User Manual 1-3
From optional paper tray
Figure 1–3 Interior view
The path from the paper tray to the top cover is for ordinary paper.
The straight path from the manual feed slot or optional multi-
function feeder to the rear stacker is for transparencies and envelopes.
Figure 1–4 Paper paths
Toner cartridge
Print density dial
Print unit
Paper tray
Top cover
(main stacker)
Rear
stacker
Manual
feed
slot
DIGITAL Laser Printer LN15 User Manual 1-4
Getting Ready
below
+10
°C
above
+35
°C
This section will help you:
• Choose a suitable location for the printer
• Identify the parts of the printer as you unpack it
Picking a Suitable Location
The first step is to pick a suitable location for your printer. For peak
performance and usability, follow these guidelines:
• Place the printer on a
sturdy, level surface.
• Choose a room that is well
ventilated and free of
excessive dust. Leave space
on either side of the printer
for proper ventilation.
• To avoid exposing the
printer to extremes of
temperature, do not put the
printer in direct sunlight or
near a heater. Ideal room
temperature is from 10°C
to 35°C (50°F to 95°F).
Humidity should be
between 20% and 80% RH
(no condensation).
• Use a grounded AC power
outlet. Do not use a three-
pronged adapter in an
ungrounded outlet.
DIGITAL Laser Printer LN15 User Manual 1-5
• Use only the power cord
furnished with the printer.
Do not use an extension
cord.
• Do not touch any
connector contacts and
corona wires to avoid
possible electrostatic
damage to the printer.
• Do not use a circuit shared
with equipment that causes
electrical noise, such as
motors.
• Do not use a circuit shared
with equipment that uses a
lot of power, such as a
copier or a coffee maker.
Unpacking and Checking Your Printer
As you unpack the printer, check each item carefully for damage. If
you find damage, notify your dealer. Check also that you have
received all the items.
This printer comes with everything you need except an interface
cable. If you do not yet have a cable, you must purchase one before
you can connect the printer to your computer.
Important:
Save the original carton and packing materials in case you need to
store or transport your printer.
✍
DIGITAL Laser Printer LN15 User Manual 1-6
• An interface cable is not a standard accessory. Please purchase
an appropriate cable according to the interface you intend to
use.
• The power cord may differ slightly from this figure depending
on the country where you purchased the printer.
Print unit
(placed in printer)
Printer
Toner
cartridge
Paper size
label
Cleaning
brush
Cleaner and
cleaner pad
Power
cord
Figure 1-5 Printer inventory
DIGITAL Laser Printer LN15 User Manual 1-7
This section describes how to assemble the printer and connect the
power cord after choosing a suitable location for the printer and
checking that you received all the parts.
Preparing the Print Unit and Installing the Toner Cartridge
This printer is shipped with the print unit mounted and protective
materials attached. Be sure to remove the two protective materials
from the print unit. This operation is possible with the print unit
mounted. First prepare and install the following two components:
• Print unit (photoconductor drum, developing unit, etc.)
• Toner cartridge
The toner cartridge first installed after you purchase the printer will
last about 2,500 printed pages under the condition of 5% coverage
on A4 paper. The succeeding toner cartridges last about 5,000
printed pages each.
Notice:
Do not touch any connector contacts and corona wires to avoid
possible electrostatic damage to the printer.
Be careful with the print unit’s drum (the green surface). The drum
is easily damaged by contamination or by exposure to light for more
than three minutes. Follow these guidelines:
• Never touch or scratch the drum surface.
• When the print unit is not in the printer, store it in a dark place or
cover it with a clean sheet of paper.
• When the print unit is in the printer, keep the printer top cover
closed. If you must work inside the printer for more than three
minutes, remove the print unit with the toner cartridge mounted
and store it in a dark place.
Setting Up
☞
DIGITAL Laser Printer LN15 User Manual 1-8
Projecting guide
To prepare the print unit and install the toner cartridge, follow these
steps:
1. Open the upper door. Lift
the milled portions at the
front left and right of the
upper door to open it.
2. Remove the protective
materials from the print unit.
Remove protective sheet q.
Pull clear tape wuntil its blue
end is visible and remove it.
Remove two restraint
cushions e.
3. Remove the toner cartridge
from its bag.
4. Shake the toner cartridge by
moving it back and forth in a
horizontal motion several
times.
5. Remove the plastic seal from
the toner cartridge. Gently
pull off the seal being careful
not to spill toner. Handle the
seal carefully to avoid staining
your hands or clothes.
6. Install toner cartridge. Slide
q
e
w
DIGITAL Laser Printer LN15 User Manual 1-9
both projecting guides of the
toner cartridge into the
grooves of the print unit.
Notice:
If you have installed the toner cartridge, do not remove it from the print
unit until it is empty. This could cause toner to spill into the printer.
7. Lock the toner cartridge.
Push the toner cartridge
forward until it clicks into
place. (The cartridge stands
nearly upright when installed
correctly.)
8. Close the printer’s upper
door. Press down firmly on
the front portion of the upper
door and make sure the upper
door is locked completely.
☞
Other manuals for LN15
1
Table of contents
Other Digital Equipment Printer manuals
Digital Equipment
Digital Equipment LB12 Installation instructions
Digital Equipment
Digital Equipment DEClaser 2100 User manual
Digital Equipment
Digital Equipment DEClaser 3200 Manual
Digital Equipment
Digital Equipment DEClaser 1100 Series User manual
Digital Equipment
Digital Equipment DEClaser 1100 Series Manual
Digital Equipment
Digital Equipment DEClaser 3200 User manual
Digital Equipment
Digital Equipment LSR 2000 User manual
Digital Equipment
Digital Equipment LJ250 User manual
Digital Equipment
Digital Equipment LA50 User manual
Digital Equipment
Digital Equipment LN15 Troubleshooting guide
Digital Equipment
Digital Equipment LGplus Series User manual
Digital Equipment
Digital Equipment LN17 User manual
Digital Equipment
Digital Equipment DECLASER 1152 User manual
Digital Equipment
Digital Equipment DEClaser 2200 Manual
Digital Equipment
Digital Equipment LA600 MultiPrinter Quick start guide
Digital Equipment
Digital Equipment LG06 Manual
Digital Equipment
Digital Equipment DECwriter 110i User manual
Digital Equipment
Digital Equipment LA50 Guide
Digital Equipment
Digital Equipment DEClaser 2200 User manual
Digital Equipment
Digital Equipment LA310 User manual
