DeLonghi HWB Series User manual

FAN HEATER

A) If your appliance comes tted with a plug, it will incorporate a 13 Amp fuse. If it does not t your socket, the plug should

be cut o from the mains lead, and an appropriate plug tted, as below.

WARNING:Very carefully dispose of the cut o plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in

the house as this could cause a shock hazard.

With alternative plugs not incorporating a fuse, the circuit must be re-tted when changing the fuse using a 13 Amp Asta

approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover

can be obtained from your nearest electrical dealer.The colour of the correct replacement fuse cover is that as marked on

the base of the plug.

B) If your appliance is not tted with a plug, please follow the instructions provided below:

Important

The wires in the mains lead are coloured in accordance with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal which si marked with the letter L or coloured red.

ELECTRICAL CONNECTION (UK ONLY)

IMPORTANT INFORMATION

Danger!

Failure to observe the warnings may result in life-threatening

injury by electric shock.

- The device should not be placed im-

mediately under a xed power socket.

- Do not use the appliance near show-

ers, bathtubs, sinks, swimming pools,

etc.

- If the power cable is damaged, it must

be replaced by the manufacturer, its

service centre or a qualied electrician

so as to eliminate all risk.

- Theappliance mustbeinstalled so that

the controls are not accessible by those

who are using a bath or shower.

Important!

Failure to observe the warning could result in injury or dam-

age to the appliance.

-This appliance can be used by children

at least 8 years old and by persons with

reduced physical, mental and sensory

capacities or with inadequate experi-

ence and knowledge, as long as they

are carefully supervised or instructed

on how to safely use the appliance and

the hazards involved.

Make sure that children do not play

with the appliance. Cleaning and

maintenance performed by the user

must not be performed by children

without supervision.

- Children less than 3 years old should

be kept away from the appliance un-

less continuously supervised.

- Children between 3 and 8 years old

may only switch the appliance on and

o, provided that it has been placed or

installed in its normal operating posi-

tion, they are carefully supervised and

instructed concerning use of the ap-

pliance in a safe way and they under-

stand the hazards involved.

Children between 3 and 8 years old

should not insert the plug, adjust and

clean the appliance or perform main-

tenance on it.

ATTENTION: Some parts of the ap-

pliance can become very hot and

cause burns. Pay particular atten-

tion when children and vulner-

able persons are present.

- IMPORTANT: To avoid the risk of

the safety cuto device resetting ac-

cidentally, this appliance must not be

powered through an external on/o

device such as a timer, nor connected

to a circuit which is turned on and o

regularly by the energy supplier.

Danger of burns!!

Failure to observe the warning could result in burns.

- IMPORTANT: To avoid over-

heating, never under any cir-

cumstances cover the appliance

during operation as this would lead to

a dangerous rise in temperature.

Note:

This symbol indicates recommendations and important infor-

mation for the user.

- Always use the appliance in an upright position.

- The use of extension leads is not recommended. How-

ever if they cannot be avoided, carefully follow the in-

structions accompanyingthe extension lead,takingcare

to not exceed the power limit marked on the extension

lead.

- There must be no furniture or other objects in the 50 cm

in front of the appliance.

- Do not use the appliance in rooms whose surface area is

less than 4 m².

- Before moving the appliance, make sure it is completely

turned o and it is unplugged from the power socket.

- Do not position it in dusty atmospheres.

- Do not rest anything on the appliance.

- Do not obstruct the air intake and outlet grilles (danger

of overheating).

- Do not use the appliance near walls, furniture, curtains,

etc.

- When you rst use the device it may release an odour

due to heating up. It is advisable to ventilate the room.

Safety features

- Safety device: the appliance is tted with a safety cut-

o device which switches it o in the event of accidental

overheating (e.g. obstruction of air intake and outlet

grilles, motor turning slowly or not at all).

To reset the cuto, disconnect the appliance from the

power socket for a few minutes, remove the cause of

overheating then reconnect to the power supply.

If the problem persists or the appliance does not return

to normal operation, do not use it and contact an au-

thorised service centre to resolve the problem.

Disposing of the appliance

The appliance must not be disposed of with house-

hold waste but must be taken to an authorised waste

separation and recycling centre.

DESCRIPTION

(see p. 3)

A Function selector

B Warning lamp

C Room thermostat

D Timer (if provided)

ETowel rail (select models only)

F Pedestal (select models only)

USE

Electrical connection

-Before plugging into the power socket, make sure that

the voltage of your power system corresponds to the

value in Volts indicated on the appliance and that the

power socket and power line are suitable for the electri-

cal load.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/

EC ON ELECTROMAGNETIC COMPATIBILITY.

Installation

The device should only be used in an upright position.

Models with towel rail

Some models are equipped with a towel rail (E) that provides

a drying function and can be used only with the appliance

xed to the wall.

If the unit is used in a bathroom, to avoid hazards, it must be

installed as shown in g. 4. If installed in another room the

minimum distances shown must be respected.

The wall-mount kit includes:

1 bracket

2 x screws

2 x wall plugs (0.6x30)

Install as follows:

1. Remove the bracket mounted on the back, pulling it

downwards.

2. Choose the point to install the appliance ensuring that:

a. The plug and the socket are easily accessible after instal-

lation.

b. Neither the electrical cables nor other pipework can be

damaged.

c. Curtains or other ammable material are kept away

from the appliance.

3. Before drilling the wall, mark the exact points as shown

in g.1.

4. For brick walls, use a 6 mm masonry bit. Drill and insert

the wall plugs provided. (For plasterboard or false walls

we suggest that you locate the wooden battens behind

and use wood screws size 6 directly into the wood or

special anchors.

For any other type of wall ask the advice of a specialist.

5. Secure the bracket with the two screws provided.

Next, insert the appliance into the top and bottom

hooks of the bracket, and then lightly press the unit

down.

Slowly lift the rail (E) to the rst stop. To avoid overheating

problems in this mode, the heat setting should not exceed

1000W.

At this point you can hang towels or sheets on the rail for dry-

ing. When the appliance is not used in drying mode lift the

arm upwards up to the top which unlocks it and then bring

it down.

Attention! Do not overload the towel rail (E) and pay

special attention to drying of delicate fabrics.

Models with pedestal

Models equipped with pedestal (F) can be used in a portable

version with the pedestal or wall-mounted, excluding the

need for the pedestal in the second case.

To remove the pedestal (F) press the two tabs on the back of

thebase whilepushing theheater forwardsthenraise theap-

6TM

pliance.The two tabs are identied by the word "PUSH" (g-

ure 2/3). If you want to install it to the wall, however, proceed

as described for models with towel rail.

OPERATION AND USE

1. Make sure the appliance is turned o before insert-

ing the plug into the power socket and turning on the

socket switch if necessary.

2. Turn on the appliance by placing the thermostat (C) in

the maximum position and the function selector (A) in

one of the following positions:

/1/2.

- Summer (fan only): turn the function selector (A) knob

clockwise to position.

- Min power operation: Turn the function selector (A)

to position "1". The red warning lamp lights up.

- Max power operation: Turn the function selector (A)

to position "2".

- To switch o the appliance: Turn the function selec-

tor to position "l".

Adjusting the thermostat

When the room has reached the desired temperature, slowly

move the thermostat counterclockwise until the indicator

light turns o and no further.

The temperature thus xed will be automatically maintained

by the thermostat.

Freezing prevention

With the thermostat knob at the minimum position

and

the function selector at pos. 2 the appliance keeps the am-

bient temperature at about 5°C, preventing freezing with a

minimum expenditure of energy.

MODELS WITH 24-HOUR TIMER (if provided)

To program the heating proceed in the following way:

Look at the time on your watch. If it is 10.00 for example, turn

the numbered programmer disk until the number 10 coin-

cides with the index mark s imprinted on the programmer.

Set the periods of time that you want the appliance to func-

tion, pushing the teeth toward the centre. Each tooth corre-

sponds to a period of time of 15 min. At this point you will see

the red sectors that correspond to the periods of operation.

Set up in this way, the unit will work automatically every day

during the scheduled periods. (Important: the plug must be

always inserted in the power socket and the socket switched

on if necessary).

- To change the programming, simply return the red teeth

to the initial position and set the new operating periods.

- If you want to operate the appliance without program-

ming, push all the teeth toward the centre. In this case,

for total shutdown of the appliance, as well as turning

o the switches, it is also necessary to remove the plug

from the power socket, to avoid unnecessary operation

of the programmer.

MAINTENANCE

- Before cleaning, always remove the plug from the pow-

er socket.

- Regularly clean the air intake and outlet grilles.

- Never use abrasive powders or solvents.

TECHNICAL CHARACTERISTICS

Power supply See appliance rating plate

Power consumption “

This manual suits for next models

Table of contents

Other DeLonghi Heater manuals

DeLonghi

DeLonghi HMP1500 Installation instructions manual

DeLonghi

DeLonghi TRRS0920C User manual

DeLonghi

DeLonghi HFX30 Series User manual

DeLonghi

DeLonghi HSX Series User manual

DeLonghi

DeLonghi HCX Series User manual

DeLonghi

DeLonghi HCX3120FS User manual

DeLonghi

DeLonghi HFS30 Series User manual

DeLonghi

DeLonghi CATALYTIC HEATER User manual

DeLonghi

DeLonghi ELECTRIC HEATING CONVECTOR User manual

DeLonghi

DeLonghi TRD40615E-6A User manual

DeLonghi

DeLonghi DCH6031 User manual

DeLonghi

DeLonghi EW 7707CM User manual

DeLonghi

DeLonghi DFH333MT User manual

DeLonghi

DeLonghi EW7507EB User manual

DeLonghi

DeLonghi DCH7093ERBCA User manual

DeLonghi

DeLonghi HCO620FT User manual

DeLonghi

DeLonghi SCF 1000 User manual

DeLonghi

DeLonghi Electric oil Filled Radiator User manual

DeLonghi

DeLonghi DCH 4590 ER User manual

DeLonghi

DeLonghi ECLIPSE SDH2000 User manual

DeLonghi

DeLonghi DCH5915ER User manual

DeLonghi

DeLonghi FAN HEATER User manual

DeLonghi

DeLonghi HCA324FS User manual

DeLonghi

DeLonghi HS User manual

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide