DeLonghi DCH6031 User manual

De’Longhi Appliances

via Seitz, 47

31100Treviso Italia

5711411311/01.13_00

CERAMIC FAN HEATER

DCH6031

Instructions

A) This appliance is tted with a plug that will incorporate a 13 Amp fuse. If it does not t your socket, the plug should be cut o from the

mains lead, and an appropriate plug tted, as below.

WARNING: Very carefully dispose of the cut o plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as

this could cause a shock hazard.

With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the

fuse cover must be re-tted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse

cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical

dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.

B) Please follow the instructions provided below.

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:

Blue: Neutral

Brown: Live

As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed

as follows:

The blue wire must be connected to the terminal marked with the letter N or coloured black.The brown wire must be connected to the

terminal marked with the letter L or coloured red. If you have a 3-pins plug, do not connect any wire to the “earth”terminal.

- Voltage and wattage can be found on the rating label on the underside of the machine.

electrical connection (UK only)

Description

Fig. 1

INTRODUCTION

Thank you for choosing a De’Longhi Ceramic fan heater.

Please take a few minutes to read these instructions.

This will avoid all risks and damage to the appliance.

IMPORTANT SAFEGUARDS

- To avoid risk of cable overheating, extension leads must

not be used in powering this appliance.

- Do not use this heater near showers, bathtubs, sinks,

swimming pools, etc.

- Always use the heater in an upright position.

- Do not use the heater to dry laundry. Never obstruct the

intake and outlet grilles (danger of overheating).

The appliance is not intended for use by persons (including

children) with reduced physical, sensory or mental

capabilities, or lack of experience and knowledge, unless

they have been given supervision or instruction concerning

use of the appliance by a person responsible for their safety.

Childrenshould besupervised toensurethat theydo not

play with the appliance.

- If the power cable is damaged, it must be replaced by

the manufacturer. Please contact Customer Experience,

see enclosed guarantee.

- The appliance must not be placed immediately under a

xed power socket.

- The heater must be positioned at least 50 cm from

furniture or other objects. Do not use the appliance in

rooms with a oor area of less than 4 m².

- Before storing the appliance, check it is completely o

and the cable is unplugged. At this point wrap the cord

around the base.

- Do not store in a dusty room.

- The room temperature should be between 0-30°C.

- The heater is tted with a thermal cutout device which

switches the heater o in case of accidental overheating

(eg. obstruction of air intake and outlet grilles, motor

turning slowly or not at all). To reset, unplug the

appliance from the mains socket for a few minutes,

remove the cause of overheating then plug in again.

IMPORTANT: To avoid overheating, never under

any circumstances cover the appliance during

operation as this would lead to a dangerous rise in

temperature.

WARNING: to avoid the safety system resetting accidentally,

this appliance must not be powered through an external on/

o device such as a timer, or connected to a circuit which is

turned o and on regularly by the energy supplier.

Safety functions

-Safety device: the appliance is tted with a safety

device which switches it o in the event of accidental

overheating (e.g. obstruction of air intake and outlet

grilles, motor turning slowly or not at all).

To reset, unplug the appliance from the mains socket for

a few minutes, remove the cause of overheating then

plug in again.

-Tip over safety device: a tip over safety device (D)

turns the appliance o if it falls over or is positioned

inappropriately in such a way as to jeopardise safety.

When the appliance is placed back in a vertical position

it starts again automatically.

Disposing of the appliance

In compliance with European directive 2002/96/EC,

the appliance must not be disposed of with house-

hold waste, but taken to an authorised waste separa-

tion and recycling centre.

Important safeguards

Description/Use

DESCRIPTION

(see g. 1)

A Mode selector

B Thermostat

C Indicator light

D Tip over switch

E Filter protection grille

F Filter

USE

Installation

The appliance can be used on any horizontal surface.

Do not overload the electrical circuit. Avoid using the same

socket for other appliances.

Electrical connection

- Beforepluggingintothemains,makesurethe voltage of

your mains supply corresponds to the V value indicated

on the appliance and that the socket and power line are

appropriate for the load required.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE 2004/108/

EEC ON RADIO INTERFERENCE SUPPRESSION.

Operation and use

1. Make sure the selector (A) is in the “0” position before

plugging the appliance into the mains socket.

2. Plug into the mains socket.

3. Turn the appliance on by placing the thermostat (B) in

the Max position and the mode selector (A) in one of the

following positions: /1/2/3.

The following modes are available:

- Summer mode (fan only): turn the mode selector to the

position (the light comes on).

- Lowpoweroperation:turnthe modeselector toposition

“1”. The appliance operates at low power and energy

consumption to a minimum.

- Medium power operation: turn the mode selector to

position“2”.The appliance operates at medium power.

- High power operation: turn the mode selector to posi-

tion “3”. The appliance operates at high power to heat

the room rapidly.

- To turn the appliance o: turn the mode selector to the

“0”position and the thermostat to the position, then

unplug from the mains.

Adjusting the thermostat

When the room has reached the required temperature, turn

the thermostat (B) slowly anticlockwise until you hear a

“click”. The thermostat will then keep room temperature at

the selected level automatically.

Frost prevention mode

With the thermostat dial at minimum and the mode se-

lector (A) on “3”, the appliance maintains room temperature

at about 5°C, preventing freezing with minimal energy con-

sumption.

MAINTENANCE

- Always unplug from the mains socket before cleaning.

- During the season when the appliance is in use, clean

the air intake and outlet grilles regularly using a vacuum

cleaner.

- To clean the lter, remove the rear grille (E) by pulling it

outwards (g. 1).

Remove the dust lter (F) which retains impurities in

the air drawn in from the room, blow on it lightly then

replace in the appliance.

- Never use abrasive powders or solvents to clean the ap-

pliance.

TECHNICAL CHARACTERISTICS

Power supply See rating plate

Absorbed power “

Max Power 2000W

Table of contents

Other DeLonghi Heater manuals

DeLonghi

DeLonghi TRD40615T-6A User manual

DeLonghi

DeLonghi TCH 7590-8590 User manual

DeLonghi

DeLonghi HFX12 Series User manual

DeLonghi

DeLonghi TRRS0715ECA User manual

DeLonghi

DeLonghi EW7507EB User manual

DeLonghi

DeLonghi DRAGON 4 User manual

DeLonghi

DeLonghi KH39015CMCA User manual

DeLonghi

DeLonghi HFX30 Series User manual

DeLonghi

DeLonghi HWB Series User manual

DeLonghi

DeLonghi CERAMIC FAN HEATER User manual

DeLonghi

DeLonghi DCH5090EL User manual

DeLonghi

DeLonghi TRN User manual

DeLonghi

DeLonghi 6507L Installation instructions manual

DeLonghi

DeLonghi HVF3031 Assembly instructions

DeLonghi

DeLonghi Radia S TRRS Series User manual

DeLonghi

DeLonghi TRD40615T-6A User manual

DeLonghi

DeLonghi HR715 Installation instructions manual

DeLonghi

DeLonghi RCH100 User manual

DeLonghi

DeLonghi TCH7592ER User manual

DeLonghi

DeLonghi HFS70B User manual

DeLonghi

DeLonghi STRETTO User manual

DeLonghi

DeLonghi TRRSE Series User manual

DeLonghi

DeLonghi Professional FDL3-i SLIM Operating instructions

DeLonghi

DeLonghi HSX2320 Series User manual

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide