DeLonghi DRAGON HM3 User manual
DRAGON HM3
We were thinking of you
when we thought of it
IMPORTANT
DO NOT OPERATE WITHOUT READING
INSTRUCTIONS FIRST
Spare copies of this leaflet can be obtained
from your dealer
Proudly distributed by
De’Longhi Australia Pty Limited
P.O. BOX 4540
CASULA MALL NSW 2170
Customer Service Ph: 1800 126 659
Fax: 1800 706932
www.delonghi.co.au
e-mail: [email protected]
De’Longhi New Zealand Limited
25 Carbine Road
Mt Wellington
Auckland, New Zealand
P.O. Box 58-056 Botany
MANUKAU 2163
Customer Service Ph: 0508 200 300
Fax: 0508 200 301
www.delonghi.co.nz
e-mail:[email protected].nz
Fig.1
2
Thank you for choosing this De’Longhi radiator. To get
the very best out of your new radiator it is advisable to
read these instructions before using it.This will ensure
that you gain optimum results and use the appliance
safely.
General instructions
Take the radiator out of its packing box and remove any poly-
styrene pieces or any other packaging material that might be
lodged inside it.
Make sure that the radiator has not been damaged during
transit and that the mains cable is in working order. Do not
operate the radiator if damaged.
“Easy wheel”system
Turn the radiator upside-down on a rug or a soft surface in order
to prevent damaging the paint finish. Fully unfold the castors by
turning them outwards (Fig. 1).Turn the radiator back to its upright
position.
Electrical connection
- Before plugging the radiator into the mains, check that
your supply voltage is the same as that shown on the rating
plate of the radiator.
- If using more than one appliance at a time, it is important
to ensure that the ring main is adequate to cope with the
power requirements.
- It is important to ensure that the socket is adequately
earthed.
- THIS APPLIANCE COMPLIES WITH DIRECTIVE
2004/108/EEC ON RADIO INTERFERENCE SUPPRES-
SION.
How to use it
Switching on
Plug the radiator in and position the thermostat slider to
maximum and turn the radiator on as follows using the power
selector:
• Turn the power selector to position 1 to select minimum
output (the light on the left will come on).
• Turn the power selector to position 2 to select medium
output (the light on the right will come on).
• Turn the power selector to position 3 to select maximum
output (both lights will come on).
3
Adjusting the thermostat
Leave the thermostat at its highest setting until the room has
reached the required temperature.Then slowly turn the ther-
mostat slider back until you hear a click.The temperature
selected in this way will then be regulated automatically and
kept constant by the thermostat.
Frost protection function
With the thermostat slider in the minimum position and a
power selected, the unit maintains the room at a temperature
of about 5˚C, preventing freezing with minimum energy con-
sumption.
Models with 24-hour timer
Using the timer
If you wish to use the timer, position the switch in the middle
position (Fig. 4).
Setting the correct time
Check the time on your watch. If for example it is 4.00 pm.
(16.00), turn the dial in a clockwise direction until the number
16 is lined up with the triangular pointer (fig.2).
N.B.: Never turn the dial in an anti-clockwise direction!
The timer is in effect an electric clock and works only if the
plug is connected to the power supply. Whenever the plug is
disconnected or there is a power failure, the clock must be
re-set.
To program the timer
1) Set the operating times by pushing in with your thumbnail
to the outer rim, the notches on the dial corresponding to
the period required (fig.3) (each notch represents 15 mins.)
2) Make sure that the timer indicates the correct time (see
instructions on setting the correct time).
3) Turn the radiatior on and set it to the heat setting and temper-
ature level on the thermostat as required.
Once programmed in this way, the appliance will repeat the
pre-established program every day, if the selector is in the
position.
Timer override
If you wish to override the timer settings, push the timer
switch to position 1 (fig.4) manual (timer override).To return
to timed operation push the switch back to the middle posi-
tion (fig.4).
Fig.2
fig.3
fig.3
21
20
19
16
NOTE: if the timer switch is at the 0position (fig.4), the
heater is off and will not operate).
Cleaning and maintenance
Your oil filled raditor is absolutely free from maintenance, fully
reliable and will give many years of trouble free service.Wipe
radiator with soft damp cloth; do not use detergents or abra-
sives.
If necessary, use a vacuum cleaner to remove any built-up dirt.
Important notes
- Do not use your radiator close to bath, wash-basin, shower and
swimming pool.
- Do not use your radiator to dry laundry.
- Never place the power cable on top of the radiator while it is
hot.
- Only use the radiator in an upright position.
- The heater must be positioned at least 50 cm from furniture or
other objects.
- If the power cable has been damaged, it must be replaced by
the manufacturer or the technical service centre or by a quali-
fied person so as to avoid all risks.
- In order to eliminate the radiator’s “new” smell, set it to maxi-
mum power for at least a few hours when used for the first time.
During this operation, the room in which the radiator is located
must be ventilated.
- The power cord should be fully removed from the cord storage
unit when in use.
- The appliance is not intended for use by persons (including chil-
dren) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be super-
vised to ensure that they do not play with the appliance.
- The appliance is fitted with a tilt-switch which turns the appli-
ance off if it should fall over.
To restart the appliance, simply place it upright again.
- It is perfectly normal for the radiator to make “creacking”
fig.4
4
sounds when used for the first time. (or in the case of unfre-
quent use).
- The radiator must not be located immediately below a fixed
socket-outlet.
- The body of this radiator is filled with a precise quantity of spe-
cial oil, so that repairs requiring the opening of the oil body
must only be made by the service agent. Any oil leakage must
be reported to the service agent.
- Do not use this appliance in rooms having a floor area of less
than 4m2as this can lead to overheating.
- If the appliance is scrapped, provisions on the disposal of oil
must be respected.
- The use of an extension lead is not recommended, as overheat-
ing of the extension lead may occur during the operation of the
radiator.
- As with any electrical appliance, whilst the instructions aim to
cover as many eventualities as possible, caution and common
sense should be applied when operating your appliance, particu-
larly in the vicinity of young children.
A safety device will turn the radiator off. To
reset, contact the technical assistance service.
ATTENTION: in order to avoid any danger caused by an
accidental resetting of the safety system, this appliance must
not be powered through an external timer.
IMPORTANT: Do not cover the radiator during
operation as this could lead to dangerous overheating,
5
5711010191/11.10
Table of contents
Other DeLonghi Heater manuals
DeLonghi
DeLonghi TRV Series User manual
DeLonghi
DeLonghi HSX4324E User manual
DeLonghi
DeLonghi HCM2030 User manual
DeLonghi
DeLonghi CERAMIC FAN HEATER User manual
DeLonghi
DeLonghi TRN User manual
DeLonghi
DeLonghi DFH550R User manual
DeLonghi
DeLonghi HOR KH590715 User manual
DeLonghi
DeLonghi MTR2000 User manual
DeLonghi
DeLonghi HBC Series User manual
DeLonghi
DeLonghi DFH333MT User manual
DeLonghi
DeLonghi TRN0812T User manual
DeLonghi
DeLonghi TRH0715 User manual
DeLonghi
DeLonghi HCX3320FTS User manual
DeLonghi
DeLonghi TRDX4 User manual
DeLonghi
DeLonghi HMP1500 User manual
DeLonghi
DeLonghi HVA1120 User manual
DeLonghi
DeLonghi TCH7915ER User manual
DeLonghi
DeLonghi TRRS0715E User manual
DeLonghi
DeLonghi HTM023C User manual
DeLonghi
DeLonghi DCH4120 User manual
Popular Heater manuals by other brands
oventrop
oventrop Regucor Series quick start guide
Blaze King
Blaze King CLARITY CL2118.IPI.1 Operation & installation manual
ELMEKO
ELMEKO ML 150 Installation and operating manual
BN Thermic
BN Thermic 830T instructions
KING
KING K Series Installation, operation & maintenance instructions
Empire Comfort Systems
Empire Comfort Systems RH-50-5 Installation instructions and owner's manual
Empire Heating Systems
Empire Heating Systems WCC65 Installation and owner's instructions
Wetekom
Wetekom 92 86 43 Original instructions
Desa
Desa SPC170-F owner's manual
Watlow
Watlow Watrod Electric Tubular Heaters Specifications
Haverland
Haverland ECO-DRY GPS Series Instruction & installation manual
Stelpro
Stelpro ASILVC2060 Series user guide