DeLonghi MTR2000 User manual

instructions

RETRO OIL FILLED RADIATOR

MTR2000

Please retain these instructions for future reference

Retrò

Fig.1

Cord storage

Thermostat knob

Carry handle

Display

Switch

Indicator light

3Retrò

Thank you for choosing this De’Longhi radiator. To get the

very best out of your new radiator it is advisable to read

these instructions before using it.This will ensure that you

gain optimum results and use the appliance safely.

General instructions

1. Take the radiator out of its packaging and remove any poly-

styrene pieces or any other packaging material that might be

lodged inside it.

2. Check that neither the radiator nor the power cable has been

damaged in any way during transportation.

3. Do not operate the radiator if damaged.

Easy wheel system

Turn the radiator upside-down on a rug or a soft surface in order to

prevent damaging the paint finish.

Fully unfold the castors by turning them outwards (Fig.1).

Turn the radiator back to its upright position.

Electrical connection

- Before plugging the radiator into the mains, check that your supply

voltage is the same as that shown on the rating plate of the radiator.

- If using more than one appliance at a time, it is important to

ensure that the ring main is adequate to cope with the power

requirements.

- It is important to ensure that the socket is adequately earthed.

- This appliance complies with EEC directive 89/336 regarding

electromagnetic compatibility.

Instruction for use

Using for the first time

On using the radiator for the first time we advise that you turn it

on to the maximum power setting for up to 8 hours. This is to

eliminate the heater’s “new odour”. During this time ensure that

the room is well ventilated.

Operation and use

Turning the appliance on

Insert the plug into the mains socket and switch on turning the ther-

mostat knob clockwise until it can be turned no further, then posi-

tion the switch up in the Iposition (minimum power) or down in the

II position (maximum power).The indicator light will come on.

We suggest that on days when temperatures are not praticularly

cold. Select minimum output to optimize savings on energy con-

sumption.

Retrò

How to switch the radiator off

To switch the radiator OFF position the switch in the "0" position

(in the middle position).

Adjusting the thermostat

When the room has reached the desired temperature, turn the

thermostat knob slowly in an anticlockwise direction until you hear

a click and the radiator turns off (indicator light off).The thermostat

will now keep the temperature in the room constant, turning the

heater on and off as appropriate.

Frost protection function

With the thermostat knob in position and the switch in the II posi-

tion, the radiator maintains the room at a temperature of about 5˚C,

preventing freezing with minimum energy consumption.

Cleaning and maintenance

The heater should not require any maintenance. However before

attempting to clean the heater, unplug from the mains and wait for

it to cool (this should take around 30 minutes). It is sufficient to

remove external dust with a soft, dry cloth. Never use abrasive

powders or solvents. If necessary, remove concentrated areas of

dirt with a vacuum cleaner.

Warnings

- Do not use the heater in a bathroom or in the vicinity of bath-

tubs, wash basins, showers or swimming pools.

- Never use the heater to dry laundry.

- Never rest the power cable on the heater’s elements while it is hot.

- Only use the heater in an upright position.

- The heater must be positioned at least 50cm from furniture or

other objects.

- If the supply cord is damaged, it must be replaced by the manu-

facturer, its service agent or similarly qualified persons in order

to avoid a hazard.

- It is normal for the heater to make ‘crackling’ noises during its first

use (or if it has not been used for a long time).

- The body of the heater is filled with an exact quantity of oil. If repairs

are necessary which call for the opening of the heater, they must be

done only by the manufacturer or an authorised service centre.

- In the unlikely event of oil leakage, contact the manufacturer or an

authorised service centre.

- Do not use this radiator in rooms which have a floor area small-

er than 4m2as this may lead to overheating.

Retrò

- The heater must never be placed immediately under a fixed mains

socket.

- When scrapping the radiator, respect legislation on the disposal of oil.

- The use of an extension lead is not recommended, however if it is

necessary then follow carefully the extension lead’s instructions,

and most importantly ensure that the extension lead is correctly

rated in accordance with the radiator being used and NEVER

overloaded.

- In order to avoid any danger caused by an accidental resetting of

the safety system, this radiator must not be powered through an

external timer.

- As with any electrical radiator, whilst the instructions aim to cover

as many eventualities as possible, caution and common sense

should be applied when operating your radiator, particularly in the

vicinity of young children.

The radiator is fitted with a safety device which turns the radiator

off in case of accidental overheating. To reset, disconnect the plug

from the power for 30 minutes, remove the cause of overheating

then plug the radiator in again.

IMPORTANT: never for any reason cover the radiator

during operation as this could lead to dangerous

overheating.

IMPORTANT INFORMATION FOR CORRECT DISPOSAL

OF THE PRODUCT IN ACCORDANCE WITH EC

DIRECTIVE 2002/96/EC.

At the end of its working life, the product must not be

disposed of as urban waste.

It must be taken to a special local authority differentia-

ted waste collection centre or to a dealer providing this

service. Disposing of a household appliance separately

avoids possible negative consequences for the environ-

ment and health deriving from inappropriate disposal

and enables the constituent materials to be recovered to

obtain significant savings in energy and resources.As a

reminder of the need to dispose of household appliances

separately, the product is marked with a crossed-out

wheeled dustbin.

Retrò

Electrical requirements

Before using this appliance ensure that the voltage indicated

on the product corresponds with the main voltage in your

home, if you are in any doubt about your supply contact your

local electricity company.

The flexible mains lead is supplied connected to a B.S. 1363 fused plug

having a fuse of 13 amp capacity. Should this plug not fit the socket out-

lets in your home, it should be cut off and replaced with a suitable plug,

following the procedure outlined below.

Note: Such a plug cannot be used for any other appliance and should

therefore be properly disposed of and not left where children might find

it and plug it into a supply socket - with the obvious consequent danger.

N.B. We recommend the use of good quality plugs and wall sockets that

can be switched off when the machine is not in use.

Important: the wires in the mains lead fitted to this appliance are

coloured in accordance with the following code:

As the colours of the wires in the mains lead of this appliance may not

correspond with the coloured markings identifying the terminals in your

plug, proceed as follows:

The wire which is coloured green and yellow must be connected to the

terminal in the plug which is marked with the letter E or by the earth

symbol or coloured green or green and yellow.

The wire which is coloured blue must be connected to the terminal

which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the terminal

which is marked with the letter L or coloured red.

When wiring the plug, ensure that all strands of wire are securely

retained in each terminal. Do not forget to tighten the mains lead clamp

on the plug. If your electricity supply point has only two pin socket out-

lets, or if you are in doubt, consult a qualified electrician.

Should the mains lead ever require replacement, it is essential that this

operation be carried out by a qualified electrician and should only be

replaced with a flexible cord of the same size.

After replacement of a fuse in the plug, the fuse cover must be refitted.

If the fuse cover is lost, the plug must not be used until a replacement

cover is obtained. The colour of the correct replacement fuse cover is

that of the coloured insert in the base of the fuse recess or elsewhere

on the plug. Always state this colour when ordering a replacement fuse

cover.

Only 13amp replacement fuses which are asta approved to B.S. 1362

should be fitted.

This appliance conforms to the Norms EN 55014 regarding the sup-

pression of radio interference.

GREEN ANDYELLOW

BLUE

BROWN

EARTH

NEUTRAL

LIVE

Green and Yellow to Earth

Blue to

Neutral

13 amp

Fuse

Brown

to Live

Cord Clamp

Warning - this appliance

must be earthed

5785012900/04.07

This manual suits for next models

Table of contents

Other DeLonghi Heater manuals

DeLonghi

DeLonghi TRD40615T-6A User manual

DeLonghi

DeLonghi TCH Series User manual

DeLonghi

DeLonghi TRD40615T-6A User manual

DeLonghi

DeLonghi HSX4324E User manual

DeLonghi

DeLonghi V550920T User manual

DeLonghi

DeLonghi TOWER CERAMIC HEATER User manual

DeLonghi

DeLonghi HCX Series User manual

DeLonghi

DeLonghi CERAMIC FAN HEATER User manual

DeLonghi

DeLonghi HMP1500 Installation instructions manual

DeLonghi

DeLonghi HFS50D15 User manual

DeLonghi

DeLonghi HVF3032 User manual

DeLonghi

DeLonghi HX65L22 User manual

DeLonghi

DeLonghi RADIANT HEATER Firmware update

DeLonghi

DeLonghi HCX Series User manual

DeLonghi

DeLonghi DFH132 User manual

DeLonghi

DeLonghi HFS70B User manual

DeLonghi

DeLonghi DR18TQP Installation instructions manual

DeLonghi

DeLonghi DRAGON HM3 User manual

DeLonghi

DeLonghi TRD4 User manual

DeLonghi

DeLonghi HVY1030 User manual

DeLonghi

DeLonghi HM24 Installation instructions manual

DeLonghi

DeLonghi Holmo Fluid User manual

DeLonghi

DeLonghi HVF3031 System manual

DeLonghi

DeLonghi FAN HEATER User manual

Popular Heater manuals by other brands

oventrop

oventrop Regucor Series quick start guide

Blaze King

Blaze King CLARITY CL2118.IPI.1 Operation & installation manual

ELMEKO

ELMEKO ML 150 Installation and operating manual

BN Thermic

BN Thermic 830T instructions

KING

KING K Series Installation, operation & maintenance instructions

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Installation instructions and owner's manual

Well Straler

Well Straler RC-16B user guide

EUROM

EUROM 333299 instruction manual

Heylo

Heylo K 170 operating instructions

Eterna

Eterna TR70W installation instructions

Clarke

Clarke GRH15 Operation & maintenance instructions

IRSAP

IRSAP The Radiator Company Ovali Fitting instructions

Empire Heating Systems

Empire Heating Systems WCC65 Installation and owner's instructions

Wetekom

Wetekom 92 86 43 Original instructions

Desa

Desa SPC170-F owner's manual

Watlow

Watlow Watrod Electric Tubular Heaters Specifications

Haverland

Haverland ECO-DRY GPS Series Instruction & installation manual

Stelpro

Stelpro ASILVC2060 Series user guide