Page 10
Note: When a ON timer is set, all
function buttons (except SLEEP,
DISPLAY and Zone Follow can't be
set ) are valid and when the ON
time set is up, the unit will operate
as pre-set.
7. Self Clean +
x Press this button with the unit OFF, the
remote controller will display “CL” and the
unit will automatically clean dust off the
evaporator and dry it, to increase the
cooling and heating efficiency.
x The iCLEAN function runs for
approximately 30 minutes, during which if
the unit is turned on with the remote
controller or this button is pressed again,
the iCLEAN will be deactivated.
8. aor b
x Each time the “a” is pressed, the
temperature setting will increase by 1°C
and each time the “b” is pressed, it will
decrease by 1°C.
x The temperature setting ranges from 16°C
(60°F)~32°C (90°F).
Note: The temperature cannot be
set in AUTO or FAN mode, thus
these two buttons are not
functional.
10. Mode
x Press this button in order to set the
running mode as follows:
Auto - Cool - Dry - Heat - Fan
Note: Heat mode is not available
for cool only units
11. Sleep
x Press this button to enter SLEEP mode,
which the unit will exit after 10 hours of
continuous operation and restore to the
previous status.
Note: The sleep function cannot be
activated in FAN mode
12. Swing
x Press this button to activate up/down
swing and press it again to fix the swing
position.
13. Swing (Optional)
x Press this button to activate left/right
swing and press it again to fix the swing
position.
14. Self Clean
x The Self Clean functions when the unit is
turned off with the remote controller in
COOL, DRY or AUTO mode. It will
operate in HEAT mode (FAN mode for
cool only units), with the internal fan
running with weak flow for 3 minute before
stop, to remove the moisture within the
evaporator so as to prevent it from giving
off bad smell from mould.
x This function is not set in the factory. You
may set it or cancel it any time you want
as follows: With both the unit and the
remote controller OFF, point the remote
controller at the unit and press “Self
Clean” button once, the buzzer will sound
5 times after 5 times, indicating this
function is set. Once set, this function will
remain valid except when the unit is
power off or until it is cancelled.
9. Turbo
x Press this button only in COOL or HEAT
mode to set TURBO on or off to increase
cooling or heating speed.
x When TURBO is on, the air speed is
HIGH.
x When TURBO is off, the air speed will
default to the previous setting.
