Danfoss 140F1080 User manual

www.DEVI.com

Installation Guide

DEVIreg™ 610

Electronic Thermostat

DEVIreg™ 610

Installation Guide2

DEVIreg™ 610

Installation Guide 3

1 Introduction

DEVIreg™ 610 is an electronic thermostat to be installed

directly on the wall. It is provided with a 2-pole switch and a

wire sensor to control the desired temperature.

The thermostat has a button for adjusting the temperature

setting with a scale from -10 °C to +50 °C, and an LED

indicator that shows standby periods (green light) and

heating periods (red light).

More information on this product can also be found at:

devireg.devi.com

Table of Contents

1 Introduction . . . . . . . . . . . . . . . . . . . . . . . 3

1.1 Technical Speciﬁcations . . . . . . . . . . . . 4

1.2 Safety Instructions . . . . . . . . . . . . . . . . 5

2 Mounting Instructions . . . . . . . . . . . . . . . . 6

3 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . 10

4 Disposal Instruction . . . . . . . . . . . . . . . . . . 13

DEVIreg™ 610

Installation Guide4

1.1 Technical Speciﬁcations

-30°C to +50°C 220-240V~, 50Hz

Standby power consumption Max. 0,93W

Relay:

Resistive load

Inductive load

Max 10A / 2300W @ 230V

cos φ= 0.3 max 1A

Sensing units NTC 15kOhm at 25°C

Sensing values:

0 °C

25 °C

50 °C

42 kOhm

15 kOhm

6 kOhm

Hysteresis ±0,2 °C

Ambient temperature -30 °C to +50 °C

Temperature range -10 °C to +50 °C

Cable speciﬁcation max 1 x 4 mm² or 2 x 2,5 mm²

Ball pressure temperature 75 °C

Pollution degree 2 (domestic use)

Type 1C

Storage temperature -20 °C to +65 °C

IP class 44

Protection class Class II -

DEVIreg™ 610

Installation Guide 5

Dimensions 100 x 69,5 x 45 mm

Weight 165 g

The product complies with the EN/IEC Standard“Automatic

electrical controls for household and similar use”:

• EN/IEC 60730-1 (general)

• EN/IEC 60730-2-9 (thermostat)

1.2 Safety Instructions

Make sure the mains supply to the thermostat is turned oﬀ

before installation.

Please also note the following:

• The installation of the thermostat must be done by an

authorized and qualiﬁed installer according to local

regulations.

• The thermostat must be connected to a power supply

via an all-pole disconnection switch.

• The sensor is to be considered as live voltage. Have

this in mind if the sensor must be extended.

• Always connect the thermostat to continuous power

supply.

• Do not expose the thermostat to moisture, water,

dust, and excessive heat.

DEVIreg™ 610

Installation Guide6

2 Mounting Instructions

Please observe the following placement guidelines:

• The thermostat can be placed both indoors and

outdoors.

• Place the thermostat on a wall, pole, steel/wooden

plate or pipe.

In wet rooms, place the thermostat according to

local regulation on IP classes.

DEVIreg™ 610

Installation Guide 7

Follow the steps below to mount the thermostat.

1. Open the thermostat:

• Set adjustment button to minimum temperature.

• Loosen the 2 screws and open the front cover.

DEVIreg™ 610

Installation Guide8

2. Fasten the thermostat:

• Drive the screws through the holes in the bottom

corners of the thermostat.

• Seal the holes with the enclosed screw stopper to

maintain the density.

3. Connect the thermostat according to the connection

diagram.

IP44

-10T50

D610

LNNNONC NTC

Mains

220-240V~

Sensor

Max.Load

10 (1) A

• Heating: (L-main, N-main, L-load, NO (normally open)

- load).

• Cooling: (L-main, N-main, L-load, NC (normally closed)

- load).

DEVIreg™ 610

Installation Guide 9

The screen of the heating cable must be connected to

the earth conductor of the power supply cable by using

a separate connector.

4. Reinstall the front cover.

5. Ensure that the adjustment button can be adjusted

within full temperature range, i.e. from -10 °C to

+50 °C.

6. Install sensor using the supplied sensor cable - spec.

NTC 15 kΩ @ 25°C.

• Press out the blanket located at the bottom of the

thermostat and insert the seal nipple.

• Connect sensor to terminals 6+7.

The sensor cable can be extended up to 50 m with

1,5 mm² installation cable without aﬀecting the

accuracy of the thermostat.

Do not place the cable parallel to other installation

cables as undesirable signals may be induced.

The installation must be permanent.

If the sensor is to be built in, used for pipe

applications, or exposed to pressure, always install it

in a conduit.

7. Turn on the power supply.

DEVIreg™ 610

Installation Guide10

3 Warranty

A 2-year product warranty is valid for:

• thermostats: DEVIreg™ 610.

Should you, against all expectations, experience a problem with your DEVI product,

you will ﬁnd that Danfoss oﬀers DEVIwarranty valid from the date of purchase

on the following conditions: During the warranty period Danfoss shall oﬀer a new

comparable product or repair the product if the product is found to be faulty by

reason of defective design, materials or workmanship. The repair or replacement.

The decision to either repair or replace will be solely at the discretion of Danfoss.

Danfoss shall not be liable for any consequential or incidental damages including,

but not limited to, damages to property or extra utility expenses. No extension of the

warranty period following repairs undertaken is granted.

The warranty shall be valid only if the WARRANTY CERTIFICATE is completed

correctly and in accordance with the instructions, the fault is submitted to the

installer or the seller without undue delay and proof of purchase is provided. Please

note that the WARRANTY CERTIFICATE must be ﬁlled in, stamped and signed by the

authorized installer performing the installation (Installation date must be indicated).

After the installation is performed, store and keep the WARRANTY CERTIFICATE and

purchase documents (invoice, receipt or similar) during the whole warranty period.

DEVIwarranty shall not cover any damage caused by incorrect conditions of use,

incorrect installation or if installation has been carried out by non-authorized

electricians. All work will be invoiced in full if Danfoss is required to inspect or

repair faults that have arisen as a result of any of the above.The DEVIwarranty shall

not extend to products which have not been paid in full. Danfoss will, at all times,

provide a rapid and eﬀective response to all complaints and inquiries from our

customers.

The warranty explicitly excludes all claims exceeding the above conditions.

For full warranty text visit www.devi.com.

devi.danfoss.com/en/warranty/

This manual suits for next models

Table of contents

Other Danfoss Thermostat manuals

Danfoss

Danfoss RET2000 B User manual

Danfoss

Danfoss TP5001 series User manual

Danfoss

Danfoss DEVIreg Smart User manual

Danfoss

Danfoss 060L2150 User manual

Danfoss

Danfoss FP715Si User manual

Danfoss

Danfoss CET2000B-RF + RX1-S + CS2 User manual

Danfoss

Danfoss HP75-1 User manual

Danfoss

Danfoss RET2000B-RF User manual

Danfoss

Danfoss ECL Comfort 210 User manual

Danfoss

Danfoss ORT-01 User manual

Danfoss

Danfoss living connect Z User manual

Danfoss

Danfoss 088U0212 User manual

Danfoss

Danfoss FP735Si User manual

Danfoss

Danfoss RT1 Assembly Instructions

Danfoss

Danfoss FH-CWP User manual

Danfoss

Danfoss DEVIreg 610 User manual

Danfoss

Danfoss HC6000 User manual

Danfoss

Danfoss HC75-1 Operating manual

Danfoss

Danfoss 088L5133 User manual

Danfoss

Danfoss ECtemp 531 User manual

Danfoss

Danfoss ECL Comfort 310, A302 User manual

Danfoss

Danfoss ECL Comfort 310 User manual

Danfoss

Danfoss TP7001 series User manual

Danfoss

Danfoss ECtemp 532 User manual

Popular Thermostat manuals by other brands

EWELLY

EWELLY EW-181 manual

Prolon

Prolon T1100 Hardware guide

Computherm

Computherm Q20 operating instructions

Heatmiser

Heatmiser neoStat user manual

Aube Technologies

Aube Technologies TH111GFCI-NP 240 VCA user manual

Mars

Mars HEAT CONTROLLER IR Wireless Thermostat user manual

Saswell

Saswell SAS920XWHB-7-S-RF User manual and warranty card

Aircalo

Aircalo TFP1-ET85P2 operating manual

Honeywell

Honeywell CM721 user manual

Carrier

Carrier DEBONAIR 33CS Installation and operating instructions

Lennox

Lennox iHarmony Zone Thermostat Installation and setup guide

Gemtech

Gemtech GT7000 Operation

Rollei

Rollei Smartes 45000 manual

Sinope

Sinope TH1300RF user guide

Honeywell

Honeywell RLV4305 owner's guide

Honeywell

Honeywell Prestige 2.0 THX9421 manual

NuTone

NuTone NTBZ48 Installation & operation guide

Stelpro

Stelpro MAESTRO ASMT402AD user guide