Danfoss AMI 140 Series User manual

Data sheet AMI 140

Actuator for two point control

DH-SMT/SI VD.KH.B1.02 © Danfoss 03/2008 1

Description AMI 140 is 2 point 3 wires actuator used with

AB-QM (DN 10-32) and VZ, VZL, VRBZ valves.

The actuator can be used with fan coil units,

induction units, small re-heaters, re-coolers and

zone applications in which hot/cold water is the

controlled medium. The actuator provides with

factory default setting (actuators spindle fully

stem up):

- normally closed function for AB-QM and

- normally open function for VZ, VZL, and VRBZ

Note: it is possible to change setting from normally closed

to normally open function (see “Wiring” part jumper

setting, page 2.

Main data:

• 2-point3wiresversions

• Forceswitch-oatstemdownposition

prevents overload of actuator and valve

• Notoolsrequiredformounting

• Maintenancefreeduringlifetime

• Lownoiseoperation

• Supplied with 1.5 m cable.

Ordering

Type Supply

voltage Speed Code No.

AMI 140 24 V~ 12 s/mm 082H8048

230 V~ 082H8049

Technical data

Power supply 24 Vac, 230 Vac; +10 to –15%

Power consumption 1 VA - 24 Vac; 8 VA - 230 Vac

Frequency 50 Hz / 60 Hz

Close of force 200 N

Stroke 5.5 mm

Speed 12 s/mm

Max. medium temperature inside the pipe 130 °C

Ambient temperature 0 … 55 °C

Storage and transport temperature –40 … +70 °C

Protection code IP 42

Weight 0.3 kg

- marking in accordance with standards

Low Voltage Directive 73/23/EEC, EMC-Directive 2006/95/EEC:

- EN 60730-1, EN 60730-2-14

Spare parts

Type Code No.

Cable (5m) - 24 V 082H8052

Cable (5m) - 230 V 082H8053

Actuator for two point control AMI 140Data sheet

DH-SMT/SI

VD.KH.B1.02 © Danfoss 03/2008

Installation Mechanical

The actuator should be mounted with the valve

stem in either horizontal position or pointing

upwards.

The actuator is ﬁxed to the valve body by means

ofamountingringwhichrequiresnotoolsfor

mounting. The ring should be tightened by hand.

Electrical

Important: It is strongly recommended that the

mechanical installation is completed before the

electrical installation.

Each actuator is supplied with the connecting

cable for the controller.

Wiring

AMI 140 - 230VAMI 140 - 24V

Commissioning The factory setting of the spindle is the fully

stem up position because of easier mechanical

connection of the actuator on the valve.

Disposal The actuator must be dismantled and the

elements sorted into various material groups

before disposal.

BLACK

RED

GRAY

Top view

Jumper setting

sw=OFFactuatorretracted

sw=ON actuator extracted sw=OFFactuatorextracted(pushed)

sw=ON actuator retracted (pulled)

default setting for use with ABQM valve

BLUE

BLACK

BROWN

Top view

Jumper setting

sw=OFFactuatorretracted

sw=ON actuator extracted sw=OFFactuatorextracted(pushed)

sw=ON actuator retracted (pulled)

default setting for use with ABQM valve

Common

Black

Bed

Gray

Common

Blue

Black

Brown

Data sheet

DH-SMT/SI VD.KH.B1.02 © Danfoss 03/2008 3

Actuator for two point control AMI 140

a) Check the valve’s neck. The actuator should

be in steam up position (factory setting) .

Ensure that the actuator is mounted securely

on the valve body.

b) Energise the actuator according to the wiring

diagram - see page 2.

c) The direction of stem movement can be

observed on the position indicator .

Installation and

commissioning procedure

(if required)

Manual override

(for service purposes only)

1. Remove the cover.

2. Insert the Allen key 6 into the spindle.

3. Press and hold the button (on the bottom side

of the actuator) during manual override.

4. Pull out the tool.

5. Place cover back on the actuator.

Do not touch anything on

the PCB! Before removing

the cover in need of hand

operation with Allen key

power supply must be

disconnected.

Lethal voltage!

Caution:

Do not manually operate the

drive under power! Remark:

A ”click” sound after energizing the actuator

means that the gear wheel has jumped into

normal position.





position indicator

push 



Allen key 6mm



stem up

stem down

Actuator for two point control AMI 140Data sheet

VD.KH.B1.02 Produced by Danfoss A/S © 03/2008

Dimensions (mm)

Actuator - valve

combinations

AMI 140 + AMI 140 + AMI 140 + AMI 140 + AMI 140 +

VZ 2, VZL 2 VZ 3, VZL 3 VZ 4, VZL 4 VRBZ AB-QM

Other manuals for AMI 140 Series

Other Danfoss Controllers manuals

Danfoss

Danfoss AME 410 User manual

Danfoss

Danfoss vlt soft starter mcd 500 User manual

Danfoss

Danfoss AK2-SC 255 User manual

Danfoss

Danfoss MCO 305 User manual

Danfoss

Danfoss VLT AutomationDrive FC 300 User manual

Danfoss

Danfoss VLT 6000 series User manual

Danfoss

Danfoss VLT HVAC User manual

Danfoss

Danfoss CF-MC User manual

Danfoss

Danfoss EKC 312 User manual

Danfoss

Danfoss PVE 7 Series User manual

Danfoss

Danfoss AMV 110 NL User manual

Danfoss

Danfoss ERC 214 User manual

Danfoss

Danfoss AMV 655 User manual

Danfoss

Danfoss VLT AutomationDrive FC 302 User manual

Danfoss

Danfoss MCI 3 User manual

Danfoss

Danfoss AMV 610 User manual

Danfoss

Danfoss AK-PC 420 User manual

Danfoss

Danfoss Icon Master Controller 24 V User manual

Danfoss

Danfoss MCD3000 Series User manual

Danfoss

Danfoss EKE 1B User manual

Danfoss

Danfoss 087H3803 User manual

Danfoss

Danfoss ECL Comfort 210 User manual

Danfoss

Danfoss VLT AutomationDrive FC 302 User manual

Danfoss

Danfoss Cascade User manual

Popular Controllers manuals by other brands

Digiplex

Digiplex DGP-848 Programming guide

YASKAWA

YASKAWA SGM series user manual

Sinope

Sinope Calypso RM3500ZB installation guide

Isimet

Isimet DLA Series Style 2 Installation, Operations, Start-up and Maintenance Instructions

LSIS

LSIS sv-ip5a user manual

Rockwell Automation

Rockwell Automation 1769-L31 installation instructions

Airflow

Airflow Uno hab Installation and operating instructions

ABB

ABB ACS580-01 drives Hardware manual

Panasonic

Panasonic GM1 Series Reference manual

Emerson

Emerson SW93 owner's manual

AutoAqua

AutoAqua Smart ATO micro SATO-120P manual

Panasonic

Panasonic FP? Positioning Unit RTEX Technical manual

Samson

Samson Type 5824 Mounting and operating instructions

Alpha IP

Alpha IP MIOB 21001 manual

Siemens

Siemens OpenAir GMA 1 Series Mounting instructions

Surecom

Surecom SR-629 user manual

Fishman

Fishman TriplePlay installation guide

Regulus

Regulus SRS1 T Installation and operation manual