D-Link DCS-4705E User manual

This document will guide you through the

basic installation process for your new

D-Link Network Camera.

DCS-4705E

Vigilance 5 Megapixel H.265 Outdoor Bullet Camera

Quick Installation Guide

Краткое руководство по установке

КОРОТКИЙ ПОСІБНИК ЗІ ВСТАНОВЛЕННЯ

5 Мп внешняя сетевая камера, день/ночь,

с ИК-подсветкой до 30 м, РоЕ и WDR

D-Link DCS-4705E Quick Installation Guide 1

ENGLISH

Quick Installation Guide

This installation guide provides basic instructions for installing the Network

Camera on your network. For additional information about how to use the

camera, please see the User Manual which is available on the CD included in

this package or from the D-Link support website.

Package Contents

DCS-4705E Vigilance 5 Megapixel H.265 Outdoor Bullet Camera

Cable Waterprooﬁng Connector

Rubber Power Connector Plug

Mounting Kit

Manual and Software on CD-ROM

Quick Installation Guide

If any of the above items are missing, please contact your reseller.

Safety Notice:

Installation and servicing should be done by certiﬁed technicians so as to

conform to all local codes and prevent voiding your warranty.

2D-Link DCS-4705E Quick Installation Guide

ENGLISH

Hardware Overview

Camera Lens

IR LEDs

Provide illumination for

low-light environments

Adjustment Ring

Loosen to adjust camera

angle and tighten to lock

camera angle

Reset Button

Press and hold for 10

seconds to reset camera

back to the factory default

settings

Grounding Screw

Can be attached to a

grounding wire if desired

Power Connector

Connects to an optional 12 V / 1.5 A power

adapter (not included)

Ethernet Jack

RJ-45 connector for Ethernet, can

also be used to power the camera

using Power over Ethernet (PoE)

D-Link DCS-4705E Quick Installation Guide 3

ENGLISH

Conﬁguring the Camera

Insert the DCS-4705E CD into your computer's CD-ROM drive to begin

the installation. If the Autorun function on your computer is disabled, or if

the D-Link Launcher fails to start automatically, click Start > Run. Type D:\

autorun.exe, where D: represents the drive letter of your CD-ROM drive.

Click on the D-Link Setup Wizard SE icon that

was created in your Windows Start menu (Start >

D-Link > Setup Wizard SE).

The Setup Wizard will appear and display the MAC

address and IP address of your camera(s). If you

have a DHCP server on your network, a valid IP

Address will be displayed. If your network does not

use a DHCP server, the network camera's default

static IP 192.168.0.20 will be displayed.

Select your camera, then click the Wizard button to

continue.

Click Setup Wizard and follow the instructions to

install the Setup Wizard.

Enter the Admin ID and password. When logging in

for the ﬁrst time, the default Admin ID is admin with

the password left blank.

Click the checkboxes if you wish to change the

admin ID and password for the camera, and enter

the new ID and password you wish to use.

Click Next to continue.

Select DHCP if your camera obtains an IP address

automatically from a DHCP server such as a router.

Select Static IP if you want to manually enter the IP

settings for the camera.

Click Next to continue.

4D-Link DCS-4705E Quick Installation Guide

ENGLISH

Take a moment to conﬁrm your settings and click

Restart.

ViewingYour Camera via Web Browser

Click on the D-Link Setup Wizard SE icon that

was created in your Windows Start menu (Start >

D-Link > Setup Wizard SE).

Select the camera and click Link to access the web

conﬁguration.

The Setup Wizard will automatically open your web

browser to the IP address of the camera.

This section displays your camera’s live video.You

can select your video proﬁle and view or operate

the camera. For additional information about web

conﬁguration, please refer to the user manual

included on the CD-ROM or the D-Link website.

Enter admin as the default username and leave the

password blank. Click OK to continue.

D-Link DCS-4705E Quick Installation Guide 5

ENGLISH

Mounting Instructions

It is highly recommended that you conﬁgure and test your camera before

mounting it.

If you need to waterproof your installation, please continue to the next page.

Place the mounting sticker where you want to

position the camera. Make sure the camera base

will be positioned so that the cable channel is on

the bottom.

Use a 6 mm drill bit to make the required holes

approximately 25 mm deep, then insert the wall

anchors into the holes.

If you are running the camera cables through

the wall, drill a hole in the center and pull the

cables through the hole.

Connect the power and Ethernet cables, or just the

Ethernet cable if you are using a PoE connection.

Use the screws provided to mount the camera to

the wall.

If you are running the camera cables out the

side of the camera, guide the camera cables

through the cable channel on the base.

To adjust the camera's angle, turn the adjustment

ring counterclockwise to loosen it, then move the

camera to the desired position and angle. When you

are ﬁnished, turn the adjustment ring clockwise to

tighten it.

6D-Link DCS-4705E Quick Installation Guide

ENGLISH

To waterproof your camera installation, follow the instructions below. Round

Ethernet cable, a crimping tool, and RJ-45 plugs are required for this

procedure.

Waterprooﬁng Your Installation

Place the washer around the base of the Ethernet

connector as shown.

Connect the RJ-45 plug into the Ethernet

connector, then screw the waterproof connector

to the Ethernet connector by turning it about a

half-turn clockwise.

Thread bare Ethernet cable through the waterproof

connector as shown, then crimp an RJ-45 plug onto

the cable.

D-Link DCS-4705E Quick Installation Guide 7

ENGLISH

If you are using PoE to power your camera, use

the included rubber power connector plug to the

power connector.

If you are using a power adapter(not included)

to power your camera, wind waterproof tape

around the connection in an overlapping manner to

cover it.

Additional Information

Additional help and product information is available online at

http://www.dlink.com.

Warranty Information

Please visit http://warranty.dlink.com/ for warranty information for your region.

Screw the back part of the waterproof connector

clockwise until there is a tight seal around the

Ethernet cable.

8D-Link DCS-4705E Quick Installation Guide

РУССКИЙ

Краткое руководство по установке

Данное руководство содержит основные инструкции по установке камеры

DCS-4705E в сети. Для получения дополнительной информации по

настройке камеры, пожалуйста, обратитесь к руководству пользователя

на CD-диске из комплекта поставки или через Web-сайт D-Link.

Комплект поставки

Внешняя сетевая камера DCS-4705E

Водонепроницаемый коннектор для кабеля

Резиновая заглушка для разъема питания

Комплект для монтажа

CD-диск с руководством пользователя и программным

обеспечением

Краткое руководство по установке

Если что-либо из перечисленного отсутствует, обратитесь к поставщику.

Меры безопасности

Во избежание прекращения гарантии установку и обслуживание

должны проводить сертифицированные специалисты в соответствии с

региональными нормами и правилами.

D-Link DCS-4705E Quick Installation Guide

РУССКИЙ

Обзор аппаратной части

Объектив

камеры

Инфракрасная

подсветка

Используется для работы

камеры в ночное время

Кольцо для

регулировки

Ослабьте кольцо,

чтобы отрегулировать

положение камеры, а

затем затяните кольцо

для фиксации камеры в

требуемом положении

Кнопка Reset

Нажмите и удерживайте

кнопку Reset в течение

10 секунд, чтобы

сбросить настройки

камеры к заводским

Винт для заземления

Винтом заземления

можно прикрутить

клемму заземляющего

провода к камере

Разъем питания

Разъем для подключения 12 В / 1,5 А

адаптера питания (адаптер не входит

в комплект поставки)

Ethernet-разъем

Разъем RJ-45 для подключения

Ethernet-кабеля, а также для подачи

питания камеры по технологии Power

over Ethernet (PoE)

Other manuals for DCS-4705E

Table of contents

Languages:

Other D-Link Security Camera manuals

D-Link

D-Link DCS-930L User manual

D-Link

D-Link DCS-4802E User manual

D-Link

D-Link DCS-931L Cloud Camera 1050 User manual

D-Link

D-Link DCS-5009L User manual

D-Link

D-Link DCS-1201 User manual

D-Link

D-Link Mydlink DCS-8200LH User manual

D-Link

D-Link DCS-2310L User manual

D-Link

D-Link DCS-820L User manual

D-Link

D-Link SECURICAM DCS-910 User manual

D-Link

D-Link DCS-1130 - mydlink-enabled Wireless N Network... User manual

D-Link

D-Link DCS-7517 User manual

D-Link

D-Link DCS-7010L User manual

D-Link

D-Link DCS-2210L/UPA User manual

D-Link

D-Link DCS-4712E User manual

D-Link

D-Link DCS-4633EV User manual

D-Link

D-Link DCS-5615 User manual

D-Link

D-Link DCS-850L User manual

D-Link

D-Link DCS-5220 User manual

D-Link

D-Link DCS-8000LHV3 User manual

D-Link

D-Link DCS 6210 User manual

D-Link

D-Link DCS 6210 User manual

D-Link

D-Link DCS 6513 User manual

D-Link

D-Link DCS-6112 User manual

D-Link

D-Link DCS-3410 User manual

Popular Security Camera manuals by other brands

Okina USA

Okina USA SIR36-870VF650LP user manual

Divio

Divio NDR155PA user manual

Canon

Canon VB-C500D Specifications

Easy Access

Easy Access EasyGuard user manual

Vivotek

Vivotek FD9389-EHV-v2 Quick installation guide

TUYA

TUYA COSMO W2 manual

Eusso

Eusso UNC7500-IR Advanced installation guide

urmet domus

urmet domus 1096/204 user manual

VC VC20 series operating manual

Axis

Axis Q1614 installation guide

ieGeek

ieGeek DD201 manual

VADDIO

VADDIO ClearVIEW HD-USB PTZ 999-6990-000 Installation and user guide

Vicon

Vicon V662-D-1 Installation and operation guide

Grundig

Grundig GCH-K0274P owner's manual

Lorex

Lorex VANTAGE LBC7032 quick start guide

4xem

4xem WPT Specifications

Samsung

Samsung SCV-3082 Specifications

Vitek

Vitek VTC-C544 Specifications