D-Link DSN-6000 Series User manual

DSN-6000 Series

iSCSi iP SAN StorAge

Quick Installation Guide+

Installations-Anleitung+

Guide d’installation+

Guía de instalación+

Guida di Installazione+

ENGLISH

Quick Installation Guide

DSN-6000 series

IP SAN storage HDD trays

If any of the items are missing, please contact your reseller.

iSCSI IP SAN storage

Package Contents

RS-232 cables

Before installation

Before starting, prepare the following items.

1. A host with a Gigabit Ethernet NIC or iSCSI HBA.

2. CAT 5e, or CAT 6 network cables for management port and iSCSI data ports.

3. Prepare storage system conguration plan.

4. Prepare management port and iSCSI data ports network information. When using static IP, please

prepare static IP addresses, subnet mask, and default gateway.

5. 10GbE switches (recommended). Or 10GbE switches with LCAP / Trunking (optional).

6. CHAP security information, including CHAP username and secret (optional).

Power cords

CD Keys, screws for

drives and rail kit

Rail kitGBIC transceiver

and cable for

DSN-6410/ 6420

only

ENGLISH

Install drives

Note : Skip this section if you purchased a solution populated with drives.

To install SAS or SATA drives with no Bridge Board use the front mounting holes:

To install SATA drives with Bridge Board (DSN-654), t the Bridge Board rst.

Then install the drive using the rear mounting holes:

Drive slot numbering

Slot 1 Slot 4 Slot 7 Slot 10

Slot 2 Slot 5 Slot 8 Slot 11

Slot 3 Slot 6 Slot 9 Slot 12

Hard drives can be installed into any slot in the enclosure. Slot numbering will be reected in

web UI.

Note: It is advisable to install at least one drive in slots 1 ~ 4. System event logs are saved

to drives in these slots; If no drives are tted the event logs will be lost in the event of a

system reboot.

ENGLISH

Deployment

Please refer to the following topology and have all the connections ready.

1. Setup the hardware connection before powering on servers. Connect console cable, management

port cable, and iSCSI data port cables in advance.

2. In addition, installing an iSNS server is recommended for dual controller system.

3. Power on IP SAN storage and JBOD (optional) rst, and then power on hosts and iSNS server.

4. To ensure MPIO is set-up automatically it is recommended that you log on the target twice (from

controller 1 then controller 2).

Note: iSNS server is recommended for dual controller system.

DSN-6110: 1GbE to SAS/ SATA IP SAN storage, Single controller.

DSN-6120: 1GbE to SAS/ SATA IP SAN storage, Dual redundant controller.

ENGLISH

DSN-6410: 10GbE to SAS/ SATA IP SAN storage, Single controller.

DSN-6420: 10GbE to SAS/ SATA IP SAN storage, Dual redundant controller.

ENGLISH

1.Web UI

The D-Link DSN-6000 family includes a simple to use Graphical User Interface (GUI)

for integration and management. Be sure to connect the LAN cable, open a browser

and enter:

http://192.168.0.32

A dialog box for authentication will pop up.

User name: admin

Default password: 123456

After login, choose the functions that list on the left hand side to start your conguration.

2.Quick installation

Please make sure that there are some free drives installed in this system. Please check the

hard drive details in “/ Volume conguration / Physical disk”.

Step1: Click the “Quick installation”; follow the steps to set up system name and date / time.

Step2: Conrm the management port and DNS IP addresses are correct, and click “Next”.

Conguration

Step 1 Step 2

ENGLISH

Step 3: Set up the data port IP and click “Next”.

Step 4: Set up the RAID level and volume size and click “Next”.

Step 3 Step 4

Step 5: Check all items, and click “Finish”.

Step 6: Done.

3.Logon Microsoft iSCSI initiator

Here are the step by step instructions to setup Microsoft iSCSI Initiator. Please visit Microsoft

website for latest iSCSI initiator. This example is based on Microsoft Windows Server 2008 R2.

Step 5

ENGLISH

Connect

1.Run Microsoft iSCSI Initiator.

2.Input IP address or DNS name of the target. And

then click “Quick Connect”.

3.Click “Done”.

4.Your Computer can now connect to an iSCSI disk.

Technical Support

United Kingdom (Mon-Fri)

Home Wireless/Broadband 0871 873 3000 (9.00am–06.00pm, Sat 10.00am-02.00pm)

Managed, Smart, & Wireless Switches, or Firewalls 0871 873 0909 (09.00am – 05.30pm)

(BT 10ppm, other carriers may vary.)

Ireland (Mon-Fri)

All Products 1890 886 899 (09.00am-06.00pm, Sat 10.00am-02.00pm)

€0.05ppm peak, €0.045ppm off peak Times

Internet

http://www.dlink.co.uk

ftp://ftp.dlink.co.uk

DEUTSCH

Installationsanleitung

DSN-6000 Produktreihe

IP SAN

(Speichernetzwerk-

Gerät)

Festplatten-

Einschübe

Wenn eines dieser Elemente fehlt, wenden Sie sich bitte an Ihren Vertriebspartner oder

Fachhändler.

iSCSI IP SAN (Speichernetzwerk)

Packungsinhalt

RS-232 Kabel

Vor der Installation

Stellen Sie vor dem Start die folgenden Elemente bereit.

1. Ein Host mit Gigabit Ethernet NIC oder iSCSI HBA (Host-Bus-Adapter).

2. CAT 5e oder CAT 6 Netzwerkkabel für den Management-Port und für die iSCSI Datenports.

3. Erstellen Sie einen Kongurationsplan des Speichersystems.

4. Erstellen Sie Netzwerkinformationen für den Management-Port und die iSCSI Datenports. Geben

Sie bei Verwendung einer statischen IP bitte die statischen IP-Adressen, die Subnetzmaske und das

Standard-Gateway an.

5. 10 GigabitE-Switches (empfohlen). Als Alternative 1 GbE-Switches mit LCAP / Trunking (optional).

6. CHAP-Sicherheitsinformationen, einschließlich CHAP-Benutzername und 'Secret' (optional).

Netzkabel

CD Schlüssel,

Schrauben für

Laufwerke und

Führungsschienen

FührungsschienenGBIC-Transceiver

und Kabel nur für

DSN-6410/6420

DEUTSCH

Installation der Laufwerke

Hinweis: Überspringen Sie diesen Abschnitt, wenn Sie das System mit installierten Laufwerken

erworben haben.

Verwenden Sie die vorderen Montagelöcher, um SAS- oder SATA-Laufwerke ohne Bridge-Board zu

installieren:

Um SATA-Laufwerke mit Bridge-Board (DSN-654) zu installieren, montieren Sie zuerst das Bridge-

Board.

Installieren Sie dann das Laufwerk unter Verwendung der hinteren Montagelöcher:

Nummerierung der Laufwerk-Slots

Slot 1 Slot 4 Slot 7 Slot 10

Slot 2 Slot 5 Slot 8 Slot 11

Slot 3 Slot 6 Slot 9 Slot 12

Festplatten können in jedem Slot des Gehäuses installiert werden. Die Slot-Nummerierung

wird auf der Webbenutzeroberäche wiedergegeben.

Hinweis: Es ist ratsam, mindestens ein Laufwerk in den Slots 1 ~ 4 zu installieren.

Systemereignisprotokolle werden auf Laufwerken in diesen Slots gespeichert.

Wenn keine Laufwerke montiert werden, gehen die Ereignisprotokolle im Fall eines

Systemneustarts verloren.

Other manuals for DSN-6000 Series

Table of contents

Languages:

Other D-Link Network Hardware manuals

D-Link

D-Link DNR-2020-04P User manual

D-Link

D-Link COVR-3902 Dimensions

D-Link

D-Link DKVM-2 Service manual

D-Link

D-Link MYDLINK DNR-322L User manual

D-Link

D-Link DIR-505 User manual

D-Link

D-Link DNS-722-4 User manual

D-Link

D-Link DFL-700 - Security Appliance User manual

D-Link

D-Link DNS-722-4 User manual

D-Link

D-Link DNR-326 User manual

D-Link

D-Link MYDLINK DNR-322L User manual

D-Link

D-Link AirPlus DI-614+ User manual

D-Link

D-Link xStack Storage DSN-4000 Series Operating and maintenance manual

D-Link

D-Link xStack Storage DSN-4000 Series Safety guide

D-Link

D-Link NPP-5E1BLK243 User manual

D-Link

D-Link ShareCenterTM + DNS-340L User manual

D-Link

D-Link DHN-1000 User manual

D-Link

D-Link ShareCenter Pulse DNS-320 User manual

D-Link

D-Link DNR-326 User manual

D-Link

D-Link DXS-3610-54S User manual

D-Link

D-Link DIR-505 User manual

D-Link

D-Link ShareCenter Quattro DNS-345 User manual

D-Link

D-Link DSL-2750U Manual

D-Link

D-Link DHP-347AV User manual

D-Link

D-Link POWERLINE DHP-W313AV User manual

Popular Network Hardware manuals by other brands

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL product manual

B&B Electronics

B&B Electronics ZXT9-IO-222R2 product manual

Yudor

Yudor YDS-16 user manual

Samsung

Samsung ES1642dc Hardware user manual

Honeywell Home

Honeywell Home LTEM-PV Installation and setup guide

evertz

evertz 7700 Series manual

Asante

Asante AsanteBridge 1012 user guide

FireBrick

FireBrick FB2700 user manual

Audiovox Electronics

Audiovox Electronics ARWH2T user manual

ADC

ADC DSX-1 Operational Procedures Guide

NetComm

NetComm NF2 user guide

Alcatel-Lucent

Alcatel-Lucent 5620 user guide

Dell EMC

Dell EMC XC6420 Series Solution guide

Lanner

Lanner NCA-1020A user manual

Allied Telesis

Allied Telesis AT-TN121-A Specifications

Arista

Arista CCA-ETM-Q12 quick start guide

Lanner

Lanner NCA-1525 user manual

Cantek

Cantek NR310-4 user manual