Product overview & operating instructions
The ZM8 DW Wall Plate is a remote control panel that works together with the ZM8 console
to allow remote microphone sources and control of bass and treble.
ZM8 Matrix Controller DW Wall Plate
1 2 3 4 5
6 7 8 9
12
3
MIC1
MIC2
MUSIC
MUTE
ON
12
3
-+
HF LF
-+
-+
HF LF
-+
2
3
45
0
1
6
7
8
10
9
2
3
45
0
1
6
7
8
10
9
10
11 12
Net Interface 1
24V
GND
GND
Av-
Av+
GND
Specications
Serial communication speed 4800bps
Communication port RJ45
Communication protocol RS485
Serial communication distance 1km maximum
MIC input sensitivity 5mV/600Ω
Audio output 0dB/600Ω
Frequency response 50Hz-18kHz (±1dB)
S/N ratio >65dB
THD <0.1% @ 1kHz
Power consumption 5W
Power supply DC 24V
Dimensions (H x W x D) 86 x 146 x 48mm
Weight 150g
Order code CRAM19C
a. 1
2
3
4
5
6
7
8
485-B
485-A
RED
GND
24V1
24V1
Audio
Audio
b.
6
5
4
3
2
1
+24V
GND
GND
Audio -
Audio +
GND
01 - MIC1 input - This is the microphone input for MIC1 via the XLR
type connector.
02 - MIC1 treble control - This adjusts the tone control of the MIC1 input.
Clockwise adjustment will increase the treble from low to high.
03 - MIC1 bass control - This adjusts the tone control of the MIC1 input.
Clockwise adjustment will increase the bass from low to high.
04 - MIC1 master volume control - This is for the adjustment of the volume
of the MIC1 input. Clockwise adjustment will increase the volume from
low to high.
05 - Music mute button - This button is used to override the local input
microphone over the background music system when it is enabled.
06 - MIC1 input - This is the microphone input for MIC1 via the XLR
type connector.
07 - MIC1 treble control - This adjusts the tone control of the MIC1 input.
Clockwise adjustment will increase the treble from low to high.
08 - MIC1 bass control - This adjusts the tone control of the MIC1 input.
Clockwise adjustment will increase the bass from low to high.
09 - MIC1 master volume control - This is for the adjustment of the volume
of the MIC1 input. Clockwise adjustment will increase the volume from
low to high.
10 - DC 24V input - DC 24V input required to power the wall plate when the
cable length is greater than 50m (see ‘b’ below).
11 - RJ45 communications port - The RJ45 communication port is used to
communicate between the wall plate and the Matrix. It will also be used
to used to power the wall plate when the distance is less than or equal
to 50m (see ‘a’ below).
12 - AUX output - (see ‘b’ below).
