2. Warning and safety information
2.1 Danger warnings
For safety reasons your warewasher MUST be bonded to adjacent
metalwork or earthed so that it is at the same potential (i.e.
voltage).
A means for disconnection that has all poles separation of more
than 3mm must be incorporated in the fixed wiring in accordance
with wiring rules (►4.4).
If the supply cord is damaged, it must replace by the CLASSEQ
recommended, its service agent or similar qualified person in order
to avoid a hazard.
All mains electrical work must be carried out in accordance with
local and national regulations, and by a qualified electrician
(►5.3.1).
The warewasher MUST be disconnected from its power source
during cleaning, servicing or replacing parts (►8).
Ensure the base of the warewasher is never submerged or
standing in water when operating the warewasher (►8).
2.2 Warnings
The warewasher should only be operated at or within the voltage
specified on the rating plate (►4.4).
Old existing, defective or damaged water supply hoses are NOT
to be used when installing your warewasher. Use CLASSEQ
supplied hose. (►4.5.1).
The installer and user are responsible for ensuring the installation
and operation of this warewasher are in accordance with this
manual and local and national regulation (►5).
DO NOT use electrical extension lead(s) to supply power to your
warewasher (►5.3.1).
DO NOT run the warewasher if there is no salt in the salt reservoir,
as this will allow lime scale to build up, also any lime scale will
invalidate your warranty (►6.5) (►8.4.1).
DO NOT add any chemicals, such as detergent or rinse aid to the
reservoir. These will cause damage to the warewasher (►6.5)
