Bixpy Hobie Pro Angler User manual
VIDEO: www.bixpy.com/po-assembly
Bixpy Hobie®Pro Angler™Adapter
1Replace your rudder cover with the
Bixpy Rudder cover with ball mount
2Attach your horizontal pipe using the mount clamp
DO NOT OVERTIGHTEN the four screws!
3Use the provided pipe clamp to secure the horizontal pipe to the H-Rail on the back of your
Hobie®Pro Angler. Adjust and move as necessary to get the best fit possible.
VIDEO: www.bixpy.com/po-assembly
Bixpy Hobie®Pro Angler™Adapter
5Attach your Bixpy adapter to your Bixpy Jet
1.Align connector pins
2. Pull nose latch forward to allow metal toe to sit flush
3.Attach power cord (turn 180° and “click”closed)
4. Close rear spring latch 3
2
4
1
6Adjust your tilt and height
1.Adjust your tilt using the five holes provided
2. Use the pipe clamps to adjust the height of your motor.
3. If you set your motor too low, it will not lift out of water
when you pull your motor lift cord. Adjust the height
with your kayak loaded.
The top of your motor should be about 3” below water.
1
1
2
4Assemble your adapter
1. Use the two knurled bolts to assemble the vertical and
horizontal assemblies together
2. Since you will use your Hobie
3. Take special care to make sure you do not damage your
power cord when drilling your pipe. DO NOT DRILL THROUGH!!!
®rudder for steering, you
can lock your vertical pipe and prevent turning. Use
the provided threaded screws to lock down your vertical pipe.
You will need to drill a 1/8” hole into the aluminum pipe.
See step 6 for height adjustment BEFORE drilling your holes. 2
1
Motorizing your personal craft may require you to register your craft. Please check your local rules and regulations. Further
information at: www.bixpy.com. Always wear a life jacket when on water and carry your paddle with you at all times. NEVER
motor further than you can paddle back under your own power. Always consider that malfunctions with your equipment can
happen and ensure you can get back safely in case of such malfunctions. You MUST read your motor and battery user manual
prior to using Bixpy products and agree to all the conditions. Respect others and wildlife at all times - on and off water.
8Connect your battery
1. Run your power cable to your battery output connector
2.Attached power cord (turn 180° and “click”closed)
3. Secure battery on board in a safe and secure manner
4. If you need, extension cords are available at: www.bixpy.com
9Turn on your system and have fun!
1. Use your magnetic kill switch to turn on your system
2. Use your Bixpy remote to run your motor (forward/reverse/stop)
3. Use your Hobie®rudder to steer you kayak as normal
4. Have fun on the water and be safe!
7Pulling up your motor
1. Use the provided “pull-cord” and secure it through the eye loop
2. Secure the provided clam cleat on your vessel ensuring that
it is within reach of yourself and the pull-cord.
3. If and when you need to pull your motor out of water, give the
pull-cord a tug and lock down using the clam cleat.
1
Bixpy Hobie®Pro Angler™Adapter
VIDEO: www.bixpy.com/po-assembly
Table of contents
Other Bixpy Adapter manuals
