Unplug mains lead before opening the housing!
For your own safety, please read this user manual carefully before you initially start-up.
Every person involved with the installation, operation and maintenance of this device has to
- be qualified
- follow the instructions of this manual
1. INTRODUCTION
Thank you for having chosen
LED CONTROLLER II
. You will see you acquired a powerful and
versatile device. Unpack your item. Before you initial start-up, please make sure that there is no
damage caused by transportation. Should there be any, consult your dealer and do not use the
device.
2. SAFETY INSTRUCTIONS
This device has left our premises in absolutely perfect condition. In order to maintain this condi
and to ensure a safe operation, it is absolutely necessary for the user to follow the safety
instructions and warning notes written in this user manual. Always disconnect from the mains,
when the device is not in use or before cleaning it. Keep away children and amateurs from the
device! There are no serviceable parts inside the device. Maintenance and service operation
only to be carried out by authorized dealers.
3. FEATURES
A microprocessor-driven programmable console, designed to power and control a wide range of
solid-state LED color-changing fixtures. It is able to create a 24-bit full-range color palette when
driving RGB LED fixtures, as well as a variety of special effects such as strobing, chasing and
fading. Output voltage is DC24V, with three channels for independently powering and dimming
green and blue LEDs. With it's built-in functions and program library, the controller may function as
a stand-alone controller. It may also be controlled by a master DMX console, allowing it to be
integrated into existing DMX systems.
1) Choose the mode by pressing the MODE button to select: DMX, Manual, Roll or Auto modes.
A) DMX Mode:
In DMX mode, press the FUNCTION button. The LED menu display will show
either d001 or d-P1. "d001" denotes that controller initiative address to receive DMX signals. Press
UP or DOWN to adjust the address between 001 to 512; enter d-P1, denotes the mode of
reception of DMX signal, press UP or DOWN to choose P1 or P2, the work mode as following.
B) Manual Mode: In Manual Mode, press the FUNCTION button after entering this mode, the
LED menu display will show correspondingly R000 or G000 or B000. R denotes red output, G
denotes green output and B denotes blue output. Press UP or DOWN to adjust
from 000 to 225.
C) Roll mode:In Roll mode, press the FUNCTION button after entering this mode, the displayer
will display correspondingly ro-1 or SP01 or FS00. "ro", "SP", "FS" denotes roll mode, roll speed
and strobe speed respectively. Press UP and DOWN to adjust respectively the ROLL mode
between 1 to 4, ROLL speed between 01 to FL, corresponding time between 0.12S to 6S, strobe
speed 00 to 99, corresponding speed between 25Hz to 0.5Hz.
CAUTION!
