Assa Abloy Yale 6100 User manual

Exit Devices

in whole or in part without the express written permission of Yale Security Inc. is prohibited.

An ASSA ABLOY Group Brand

6100 / 6200

Series

For technical support contact Yale® at

800.438.1951 x5033 or [email protected]

80-9460-6016-000 10/15

ELECTRIC LATCH RETRACTION

Installation Instructions for

P Function and/or Monitors

Table 1:

Wires from Power Supply to Device

(Minimum Gauge of Two-Conductor Cable)

Up to 40 Feet of Wire 16 Gauge

Up to 60 Feet of Wire 14 Gauge

Up to 100 Feet of Wire 12 Gauge

1. Install the System Peripheral Components (782 Controller, Controlling

Switches, Power Transfer Hinge(s), etc.) and Raceways (Table 1).

IMPORTANT:

Do not connect power until all components are installed.

Integral Power Supply: Connect the wires from the Power Transfer

Hinge, Controlling Switch(es) Console and Power (120 VAC) input to the

782 Controller, as described in the controller installation instructions.

Power Transfer Hinge: Follow the manufacturers’ installation in-

structions. The door leaf wires must exit through the door access

hole, underneath the device rear clamp.

2. Install Device (and optional Trim): Follow the installation instruc-

tions for device (and trim). The Rear Clamp and End Cap are NOT

to be installed at this time.

3. Prepare Wiring Access Hole: Drill a 3/4˝ (19mm) diameter hole in

the door using the rear clamp center hole as a guide (Figure 1).

4. Install the rear clamp screws and fully tighten all device screws.

5. Check Device Action: Actuate the device by the touchbar (and

trim). Be sure that the door and device are operating properly and

that the door is opening freely and closing securely.

6. Connect Device ELR Wires: The red (+) and black (–) polarized

wires from the inactive (hinge) end of the device connect to

DEV 1 on the 782 (see the wiring diagram).

7. Connect Monitors (if used): Follow the connections shown in

Figure 2. Wire nuts are not supplied.

8. Coordinated Door Operation: When two (2) devices are

hooked to the same 782, repeat steps 2. through 7. and con-

nect the second device to DEV 2.

9. Test System: With the power disconnected, verify there are no

short circuits throughout.

Apply power to console (if used) and to integral power supply.

Test the device; bolt should retract when the controlling switch

closes contacts and extend when the switch contacts open.

During momentary or continued operation the device status will

correspond to the switch contact status.

Note:

The 782 Controller has an adjustable delay which causes the elec-

tric latch to remain retracted while the controlling switch is open.

The Troubleshooting Guide (Table 2) provides modiﬁcations.

Figure 1: Door Preparation

Exit Device Rear clamp

Mounting Holes

(for reference only)

Conducting Hinge

or Approved Power

Transfer (by others)

Inside Face of Door

Clear Channel Access

Required for Wire Connection

3/4˝(19mm) Dia.

Wiring Access)

Horizontal Reference

Device Centerline

Hinge Edge

of Door

Exit Device

4˝ Max.

Product Support Tel 800.438.1951 • www.yalelocks.com

Yale®is a registered trademark of Yale Security Inc., an ASSA ABLOY Group Company.

Other products’ brand names may be trademarks or registered trademarks of their respective owners and are mentioned for reference purposes only.

These materials are protected under U.S. copyright laws.

All contents current at time of publication. Yale Security Inc. reserves the right to change availability of any item in this catalog, its design, construction, and/or its materials.

Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.

Yale Locks & Hardware is a division of Yale Security Inc., an ASSA ABLOY Group company.

Yale Locks & Hardware

An ASSA ABLOY Group Brand

Table 2:

Troubleshooting Guide

Problem

Solutions

follow in sequence

(deﬁned below)

Device Does Not Work 1, 2, 3, 6, 8

Latchbolt(s) Are Not Retracting, But Relay Click Is Audible 2, 4, 5, 6, 7, 8, 9

Sluggish Bolt Retraction 2, 4, 5, 6, 7, 9

Bar Hot (Not Warm) 2, 6, 8

Bolt(s) Hangs Retracted 1, 2, 5, 7, 8

Bolt(s) Not Fully Retracting 5, 7, 9

Intermittent Action 1, 4, 5, 6, 8, 9

Solution Deﬁnitions

1. Check Remote Switch(es)

2. Check Circuit Continuity

3. Check Fuses

4. Be Sure That The Door Swings Freely

5. Be Sure That The Manual Device Action Works Properly

6. Check Wiring (Connection and Insulation)

7. Check For Foreign Materials (Device Should Be Free From Obstructions)

8. Check Circuit Board Operation

9. Check Wires To Device (Gauge Vs. Length)

B MONITOR

Contains a Touchbar Actuated, Single Pull Double Throw

(SPDT) Switch which Indicates Egress in Progress.

Blue

White / Yellow

Yellow

* All Devices

All Devices

COM

O MONITOR

Contains a Device Actuated, SPDT Switch

which Indicates Door Open from Outside.

Gray

White / Brown

Brown

* Rim & Vertical

Open Mortise

Rim & Vertical

Closed Mortise

COM

Violet

White / Orange

Orange

* Rim & Vertical

Rim & Vertical

S MONITOR

Contains a Slider Actuated, SPDT Switch

which Indicates Bolt(s) Extended - Retracted.

NOTE:

• Connect as Shown to the Device Speciﬁed on the System Schematic.

• Discard Unused Lead (Seal End with Wire Nut).

* Switch Position with Door Secure and Device Latch Engaged.

Figure 2: Monitor Connections

This manual suits for next models

Table of contents

Other Assa Abloy Door Lock manuals

Assa Abloy

Assa Abloy Effeff 843G User manual

Assa Abloy

Assa Abloy CLIQ eCLIQ Connect key User manual

Assa Abloy

Assa Abloy effeff 827A-IP User manual

Assa Abloy

Assa Abloy Yale Delayed Egress User manual

Assa Abloy

Assa Abloy Yale Assure Lock SL Technical specifications

Assa Abloy

Assa Abloy Yale Real Living YRDZW Technical specifications

Assa Abloy

Assa Abloy ASSA 88x Series User manual

Assa Abloy

Assa Abloy Norton 6000 Series Quick guide

Assa Abloy

Assa Abloy effeff MAGAC-L Series User manual

Assa Abloy

Assa Abloy Lockwood Cavity Lock User manual

Assa Abloy

Assa Abloy Corbin Russwin CLX3361 User manual

Assa Abloy

Assa Abloy Yale AYRD110 User manual

Assa Abloy

Assa Abloy ABLOY EL654 User manual

Assa Abloy

Assa Abloy Lockwood Onyx 9A1A2/5PBLK User manual

Assa Abloy

Assa Abloy Lockwood 1220 Series User manual

Assa Abloy

Assa Abloy Lockwood 530 DX Series User manual

Assa Abloy

Assa Abloy Valencia Bella User manual

Assa Abloy

Assa Abloy Sargent IN220 User manual

Assa Abloy

Assa Abloy HES Aperio ES100-15 Manual

Assa Abloy

Assa Abloy Hes 5200 Series User manual

Assa Abloy

Assa Abloy SARGENT 5300 Series User manual

Assa Abloy

Assa Abloy Corbin Russwin MP9800 Series User manual

Assa Abloy

Assa Abloy MSL mFlipLock basis User manual

Assa Abloy

Assa Abloy Corbin Russwin ED5800 Series User manual

Popular Door Lock manuals by other brands

We.lock

We.lock SECBNEBL51 instructions

Iseo

Iseo MA1A installation guide

ID Lock

ID Lock 150 user manual

Lockly

Lockly ACCESS TOUCH PRO user manual

iLoq

iLoq G50S user guide

SDC

SDC Z7835 installation instructions

ilco

ilco 452 Installation

Samsung

Samsung shs-h705 user guide

TRU-BOLT

TRU-BOLT 08102017 user manual

CDVI

CDVI 500-LADJ quick start guide

Igloohome

Igloohome Deadbolt 2S Metal Grey Installer/user guide

eSSL

eSSL FL-300 user manual

JAKO

JAKO JKBTNX4 installation guide

Dorma

Dorma MUNDUS PREMIUM GK 50 Mounting instruction

SCOOP

SCOOP Pullbloc 4.1 FS Panik Assembly instruction

Yale

Yale MORTISE 8800 SERIES installation instructions

Siegenia

Siegenia KFV AS3500 Assembly instructions

Saflok

Saflok Quantum ädesē RFID installation instructions