Argo AGW52RH U.I. User manual

Thank you for choosing an Air Conditioner.Please read this OWNER'S MA-

NUAL carefully prior to using, keep it for further reference.

OWNER'S MANUAL

SPLIT AIR CONDITIONER

WALL MOUNTED TYPE

AGW52RH U.I./AGE52RH U.E.

CONTENTS

.................................................................22

......................................................................4

........................6

.................................. 7

.....................1212

...........................................1414

....................................................1616

......................................................1717

...................................................................

Contents

Name or Parts

Safety Awareness

Operation procedure

Remote Controller's Preparative Before Operation

Operation Explanations of Air Conditioner

Service and Maintenance of the Air Conditioner

Fault Confirmation and Analysis

Performance Parameters

Installation Explanations

WARNING

Absolutely no

Must connect grounding line

Must unplug plug Must be done

Read and understand thoroughly this safety awareness before use.

The items indicated here are very important safety precautions, which must be followed.

Do not let cool air blow directly at you for long

time.Possible health problems may occur.

Do not pull power cable. Hold plug to unplug

when removing power, or part of the line in

the power cable may break and cause fire.

Do not connect at the middle of the power

cable or extend it. Do not use multi - hole

sockets. Possible fire electric shock may

occur for poor connection,bad insulation and

excessive allowable current.

Do not plug power cable when in operation.

(Spark may appear, and cause fire.) Pull the

power plug out from the outlet or cut off the

power supply when you don't use the air

conditioner for a long time. (Accumulated dirt

will cause fire.)

Do not damage power cable, or do joining

work.By putting stuffs on the power cable,

heating it or do joining works,a possible short

circuit may cause fire and electric shock.

Provide a power outlet to be used exclusively

for each unit, and a power supply disconnect

and circuit breaker and current fuse protector

should be provided in the exclusive line.

SAFETY AWARENESS

WARNING

Clean the air conditioner with a soft and dry

cloth. Do not use chemical solvent,insecticide,

Inflammable-spraying material or which da-

mage the appearance of air conditioner for c-

leaning.

Do not put burning appliances at the place

where can be blown directly by the air,

insufficient burning may occur.

Do not install the air conditioner in where leak

flammable gas. If there is electrical leakage

accidentally from air conditioner, it is easy to

cause fire or explosion ,as is very dangerous.

Stop operation and unplug power cable imm-

ediately if abnormality is found ( burned smell

etc ).

Do not use for special purposes. Do not use to

store precision equipment,food,painting etc, w-

hich are required humidity and temperature, for

their quality may be affected.

Close doors and windows ( better using cont-

ains )while operating air conditioner for a long

time,if room air is quite turbid,you should open

a door and window for a moment to get some

outdoor fresh air.

Do not operate air conditioner at COOL/DRY

mode for a long time under high humidity

( above 80%), if door/window is open or under

high humidity condition, condensation may

drop from the unit.

Do not install, service or move the Air Conditioner on your own. Improper process can cause fire,

electric shock, the falling unit can injure people or water leakage. Contact our air conditioner specially

engaged service center.

SAFETY AWARENESS

The appliance shall be installed in accordance

with national wiring regulations.

The appliance must not be installed in the laundry.

The appliance must be installed 2.3m above

the floor.

An all-pole disconnection device which has at

least 3mm separation distance in all pole shall

be in corporated in the fixed wiring according

to the national rule.

Air inlet

Connecting pipe

Drain hose

Drain opening

Air outlet

OUTDOOR UNIT

NAME OF PARTS

Filter Front panel

Display Remote

controller

Air inlet

Manual operation

(open the Front panel)

INDOOR UNIT

Time indicator

Sleep indicator

Run indicator

Power supply cord

Deflector

Left / Right deflector

SWINGSWING

MANUALMANUAL

OFFOFF ONON

CANCELCANCEL SETSET

SLEEPSLEEP

FAN SPEEDFAN SPEED

OPERATIONOPERATION

MODEMODE

I/OI/O

TIMETIME

Emergency operation

switch

Check switch

NAME OF PARTS

OPERATION

DISPLAY

TEMPERATURE

ADJUSTMNT

BUTTON

RUN/STOP

BUTTON

FAN SPEED

BUTTON

SLEEP

BUTTON

RESET PIECE

TIME SET

BUTTON

TIME CANCEL

BUTTON

TIME ON

BUTTON

TIME OFF

BUTTON

OPERATION

MODE BUTTON

MANUAL SWING

BUTTON

SWING

BUTTON

NOTICE

REMOTE CONTROLLER

Signal ejecting window

cool only type hasn't HEAT mode

REMOTE CONTROLLER PREPARATION

Open back cover, put in batteries. Short RESET piece with forceps.

(Short two RESET piece after

changing the batteries.)

•If the remote controller can't be operated normally, short two RESET piece,

it will operate normally.

•Remove batteries if Remote controller has not

been used for a long time.

•When the button is pressed, indoor unit will beep once or twice, indicating

the receiving of the signal. If no beep is heard, press again.

•Handle remote controller carefully. Do not drop, throw and get wetted. Avoid

malfunction.

•The signal can be reached within six metres directly in front of indoor unit.

NOTICE

OPERATION OF AIR CONDITIONER

Operation procedure-Control under the Remote controller

Run/Stop

Press I/O button, start operation, and stop when repressed.

Temperature adjustment

Press TEMPERATURE ADJUSTMENT button,decreases 1 by press button once,

and increase 1 C

by press button once.

Temperature change will display in the remote controller's display.

Sleep selection

Press SLEEP button, set sleep operation, and cancel when repressed.

Fan speed adjustment

Press FAN SPEED button,change the fan speed of indoor unit in the order of ( low )

( medium ) ( high ) ( auto ).

NOTICE

Air flow direction adjustment

Change up/down air flow direction

Press MANUAL SWING button, the deflector move a specific angle. Change the deflector

of indoor unit follow the order of (1) (2) (3) (4) (5) (Fig.2)

In DRY or COOL mode , air blows downward in (4), (5) for one hour,

it changes to horizontal blowing automatically to prevent dropping.

OPERATION OF AIR CONDITIONER

(1)

(2)

(3)

(4)

(5)

Change right/left air flow direction

Manually swing ,to change right/left air flow direction.Complete ad-

justment before operation, if adjusted during operation,the auto swinging deflector may

pinch your fingers.(Fig. 1)

Left/Right deflector

ADVICE

In DRY or COOL mode, advise to make the

Fan speed with (auto), air blows downward

in (1). In HEAT mode, advise to make the

Fan speed with (auto), air blows downw-

ard in (4).

Control with remote controller to adjust up/d-

own air flow direction, avoid turning deflector

with hand to avoid injury.

( Fig.2 )

COOL

mode

DRY

mode

HEAT

mode

OPERATION OF AIR CONDITIONER

Press SWING button, the deflector start to opreate..

( Fig.1 )

ADVICE

HEAT mode: Healthy warmness lies in the difference with outside temperature! The

setting temperature for heating shall not be too different from outside temperature.

Though it varies with area, set temperature to between 20 - 24 , Heating effect

becomes inferior when ambient temperature is below 5 .

C C

OPERATION OF AIR CONDITIONER

Cool only type has not HEAT mode .

116

Operation mode adjustment

AUTO mode

When started, operation mode will turn into COOL or DRY or HEAT mode as per room

temperature, if operation stops for two hours, it restarts in the same mode set as before

operation was stopped. Once operation mode is set,it will not be influenced even if room

temperature has changed.Press MAUNAL SWING button or SWING button to change

up/down air flow direction.

COOL mode

Press MAUNAL SWING button or SWING button to change up/down air flow direction.

Press FAN SPEED button to change the fan speed of indoor unit. Press TEMPERATURE

ADJUSTMENT button to change the setting temperature.

DRY mode

Press MAUNAL SWING button or SWING button to change up/down air flow direction.

Press FAN SPEED button to changes the fan speed of indoor unit.

FAN mode

Press MAUNAL SWING button or SWING button to change up/down air flow direction.

Press FAN SPEED button to change the fan speed of indoor unit.

HEAT mode(heat pump type)

Press MAUNAL SWING button or SWING button to change up/down air flow direction.

Press FAN SPEED button to change the fan speed of indoor unit. Press TEMPERATURE

ADJUSTMENT button to change the setting temperature.

Per Room

Temperature (RT)

Cooling only type

Mode Per Setting Temperature Per Setting Temperature

Mode

RT-2 RT-2

Cool Cool

Dry RT-2 RT-2

Dry

Heat

Heat pump type

above 26

25-26

23-25

below 23

C 24

C C

OPERATION OF AIR CONDITIONER

This manual suits for next models

Table of contents

Popular Air Conditioner manuals by other brands

Spheros

Spheros CC 355 instructions

Bosch

Bosch Climate 5000 SCI 24 CAS/ OU- OUE owner's manual

Panasonic

Panasonic CS-E12HKEW operating instructions

nedis

nedis ACMB1WT7 quick start guide

Samsung

Samsung AR KV Series User & installation manual

Daikin

Daikin FCFV50A Operation manual

Fujitsu

Fujitsu Inverter ASBA30JFC operating manual

Toshiba

Toshiba RAS-M10SMUV-E installation manual

Daikin

Daikin FXLQ20MAVE Operation manual

Hitachi

Hitachi RAS-E24CAK instruction manual

CIAT

CIAT Magister 2 Series Installation, Operation, Commissioning, Maintenance

Bestron

Bestron AAC6000 instruction manual

Hisense

Hisense 7K Use and Installation Instructions

Frigidaire

Frigidaire FFRE0533S1E0 Use & care guide

Samsung

Samsung AS09HM3N user manual

Frigidaire

Frigidaire CRA073PU11 use & care

Soleus Air

Soleus Air GB-PAC-08E4 operating instructions

McQuay

McQuay MCK020A Technical manual