Operating
Instructions
COOL operation
• Press the “MODE” button until the “COOL”
indicator light comes on.
• Press the UP and DOWN buttons “+” or “-” to
select your desired room temperature. The
temperature can be set within a range of
17°C~30°C/62°F~86°F.
• The fan speed is automatically set to auto.
Use the remote to adjust the fan speed if
desired.
DRY operation
• Press the “MODE” button until the “DRY”
indicator light comes on.
• While in this mode, you cannot select a
fan speed or adjust the temperature. The
fan motor operates at LOW speed.
• Keep windows and doors closed for the
best dehumidifying effect.
FAN operation
• Press the “MODE” button until the ”FAN“
indicator light comes on.
• Press the “FAN SPEED” button to choose
the fan speed. The temperature cannot
be adjusted.
Operating Instructions
SLEEP/ECO operation
This feature can be activated from
the remote control ONLY. To activate
SLEEP feature, the set temperature will
increase by 1°C/2°F in 30 minutes. The set
temperature will then increase by another
1°C/2°F after an additional 30 minutes.
This new temperature will be maintained
for 7 hours before it returns to the
originally selected temperature. This ends
the Sleep mode and the unit will continue
to operateas originally programmed.
NOTE
This feature is unavailable in FAN or
DRY mode.
Other Features
NOTE
This feature can be activated from
the remote control ONLY. The remote
control serves as a remote thermostat
allowing for the precise temperature
control at its location.
COMFORTSENSE
Feature (optional)
To activate the Follow Me/Temp Sensing
feature, point the remote control towards
the unit and press the Follow Me/Temp
Sensing button. The remote display is
actual temperature at its location. The
remote control will send this signal to the
air conditioner every 3 minutes until the
ComfortSense button is pressed again.
If the unit does not receive the Follow
Me/Temp Sensing signal during any 7
minutes interval, the unit will exit the
Follow Me/Temp Sensing mode.
Constant Fan button
Feature (optional) in cooling or Dry mode,
press the button for 3 seconds to turn on
or off the constant fan function. When the
function is turned on, the constant fan light
will illuminate, identifying the fan continuous
run for cooling. When the function is
turned off, the constant fan light will go
out, identifying the fan cycle run with
compressor stop.
AUTO-RESTART
If the unit shuts off unexpectedlydue toa
power outage,it willrestartwith the previous
set function when thepower resumes.
WAIT 3 MINUTES BEFORE RESUMING
OPERATION
After the unithas stopped, it cannot be
restarted until 3 minutes time has elapsed.
This is to protect the unit. Operation will
automatically resumeafter 3 minutes.
AIRFLOW DIRECTION ADJUSTMENT
Adjust the air flow direction manually:
- The louver can be set to the desired
position manually.
- Do not place any heavy objects or
other loads on the louver, doing so will
cause damage to the unit.
- Keep the louver fully opened during
operation.
Page 10
