Alliance Laundry Systems ADEE8B BLACK User manual
speedqueen.com.au
Need More info?
Call 1300 927 437
ADEE8B BLACK (ELECTRIC)
ADGE8B BLACK (GAS)
INSTALLATION GUIDE
DRYER
Installation Instructions
for Dryers
Original Instructions
Keep These Instructions for Future Reference.
CAUTION: Read the instructions before using the machine.
(If this machine changes ownership, this manual must accompany machine.)
www.alliancelaundry.com Part No. D514685R5
August 2017
WARNING
Risk of fire. Highly flammable material.
W881
IMPORTANT: The electrical installation in the site shall
comply with the Australian Electrical Standards,
AS3000, SAA wiring rules, and such local regulations
that might apply. In Australia and New Zealand, instal-
lation must comply with the Gas Installations Standard
AS/NZS 5601 Part 1: General Installations.
The maximum drying load (dry weight) shall not exceed 9 kg [20
pounds].
Read all instructions before using unit.
WARNING
FOR YOUR SAFETY, the information in this manual
must be followed to minimize the risk of fire or ex-
plosion or to prevent property damage, personal in-
jury or death.
W033
WARNING
• Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
• WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Clear the room, building or area of all occu-
pants.
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s in-
structions.
• If you cannot reach your gas supplier, call the
fire department.
• Installation and service must be performed by a
qualified installer, service agency or the gas sup-
plier.
W052
IMPORTANT: Purchaser must consult the local gas
supplier for suggested instructions to be followed if
the dryer user smells gas. The gas utility instructions
plus the SAFETY and WARNING note directly above
must be posted in a prominent location near the dryer
for customer use.
WARNING
• Installation of unit must be performed by a quali-
fied installer.
• Install clothes dryer according to manufacturer’s
instructions and local codes.
• DO NOT install a clothes dryer with flexible plas-
tic venting materials. If flexible metal (foil type)
duct is installed, it must be of a specific type
identified by the appliance manufacturer as suita-
ble for use with clothes dryers. Refer to section
on connecting exhaust system. Flexible venting
materials are known to collapse, be easily crush-
ed, and trap lint. These conditions will obstruct
clothes dryer airflow and increase the risk of fire.
W729R1
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
3 Part No. D514685R5
WARNING
To reduce the risk of severe injury or death, follow all
installation instructions. Save these instructions.
W894
WARNING
FOR YOUR SAFETY
Do not store or use gasoline or other flammable va-
pors and liquids in the vicinity of this or any other
appliance.
W053
This product uses FreeRTOS V7.2.0 (www.freertos.org).
NOTE: For Australian models, the energy consumption
is measured as used once per week using the Perm
Press Automatic cycle with High Temperature and Dry-
ness Dry at the rated load capacity of 7 kg.
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
4 Part No. D514685R5
Table of Contents
Dimensions............................................................................................. 6
Installation............................................................................................. 8
Before You Start............................................................................................. 8
Supplies..................................................................................................... 8
Order of Installation Steps............................................................................8
Position and Level the Dryer............................................................................8
Connect Dryer Exhaust System...................................................................... 10
Exhaust Direction......................................................................................11
Exhaust System.........................................................................................12
Gas Dryers - Connect Gas Supply Pipe........................................................... 12
Reverse Door, if Desired................................................................................14
Wipe Out Inside of Dryer...............................................................................15
Plug In the Dryer.......................................................................................... 15
Electrical Requirements............................................................................. 15
Earth/Ground Instructions.......................................................................... 17
Recheck Steps.............................................................................................. 17
Check Heat Source........................................................................................17
Electric Dryers.......................................................................................... 17
Gas Dryers................................................................................................17
All Dryers.................................................................................................18
Installer Checklist.................................................................................19
© Copyright 2017, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any means without the expressed
written consent of the publisher.
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
5 Part No. D514685R5
Dimensions
Electric Models
DRY2638N_SVG
JK
IH
G
F
E
D
C
B
A
A * 1027 mm [40.42 in.]
B * 1006 mm [39.61 in.]
C * 392 mm [15.44 in.]
D * 102 mm [4 in.]
E 391 mm [15.4 in.]
F 683 mm [26.875 in.]
G * 114 mm [4.5 in.]
H 10 mm [0.4 in.]
I 203 mm [8 in.]
J 711 mm [28 in.]
K 597 mm [23.5 in.]
NOTE: Exhaust openings are 102 mm [4 inch] metal
ducting.
* With leveling legs turned into base.
Gas Models
DRY2639N_SVG
F
E
DC
B
A
J
K
M L
I
H
G
1
1. 3/8 in. NPT Gas Connection
Dimensions
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
6 Part No. D514685R5
A *1027 mm [40.42 in.]
B *1006 mm [39.61 in.]
C *392 mm [15.44 in.]
D *70 mm [2.8 in.]
E 60 mm [2.3 in.]
F 391 mm [15.4 in.]
G 683 mm [26.875 in.]
H 102 mm [4 in.]
I *114 mm [4.5 in.]
J 10 mm [0.4 in.]
K 203 mm [8 in.]
L 711 mm [28 in.]
M 597 mm [23.5 in.]
NOTE: Exhaust openings are 102 mm [4 inch] metal
ducting.
* With leveling legs turned into base.
NOTE: Gas models cannot be vented out left side of
cabinet because of burner housing.
IMPORTANT: The dryer should have sufficient clear-
ance around it for needed ventilation and for the ease
of installation and servicing. For maximum drying per-
formance, we recommend that more clearance be al-
lowed around the dryer than the clearances that are lis-
ted throughout this manual.
Dimensions
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
7 Part No. D514685R5
Installation
Before You Start
Supplies
For most installations, the basic supplies you will need are:
DRY2586N_SVG
8
765
4
3
2
1
1. Wrench
2. 1/4 inch Driver
3. Screwdrivers
4. Level
5. Gloves
6. Teflon Tape
7. Duct Tape
8. Safety Glasses
Figure 1
NOTE: This appliance is suitable for use in countries
having a warm, damp climate.
WARNING
Any disassembly requiring the use of tools must be
performed by a suitably qualified service person.
W299
Order of Installation Steps
1. Position and level the dryer.
2. Connect dryer to exhaust system.
3. For gas models only, connect the gas supply pipe. Check for
gas leaks.
4. Reverse the door, if desired.
5. Wipe out the inside of the dryer.
6. Plug in the dryer.
7. Recheck steps.
8. Start and run the dryer in a heat setting to verify dryer is heat-
ing.
Position and Level the Dryer
1. Install dryer before washer. This allows room for attaching
exhaust duct.
2. Select a location with a solid floor. Dryers installed in resi-
dential garages must be elevated 457 mm [18 inches] above
the floor.
No other fuel burning appliance should be installed in the same
closet with the dryer.
The dryer must not be installed or stored in an area where it will
be exposed to water and/or weather.
The dryer needs sufficient clearance and an adequate air supply
for proper operation and ventilation, and for easier installation
and servicing. (Minimum clearances are shown in Figure 3 ).
The dryer must not be installed behind a lockable door, a sliding
door or a door with a hinge on the opposite side to that of the dry-
er, in such a way that a full opening of the dryer door is restricted.
3. Place the dryer in position, and adjust the legs until the dryer
is level from side to side and front to back. Leveling legs can
be adjusted from inside the dryer with a 1/4 in. driver.
4. All four legs must rest firmly on the floor so the weight of the
dryer is evenly distributed. The dryer must not rock.
DRY2500N_SVG
3
2
1
1. Dryer Base
2. Level
3. Leveling Leg
Figure 2
Installation
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
8 Part No. D514685R5
Front View (Without Closet Door)
DRY2640N_SVG
A
B
A
Side View (Closet Door)
DRY2641N_SVG
H
E
D
C
A
3
1
Front View (Closet Door)
DRY2637N_SVG
F
F
2 (G)
1. Closet Door
2. Centered Air Openings (G) (2 Openings minimum)
3. Outer Wall of Enclosure
Figure 3
Installation
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
9 Part No. D514685R5
Area Description
Free Standing/Alcove In-
stallation Closet Installation
A* Dryer sides and rear clearance 0 mm [0 in.] 0 mm [0 in.]
B Dryer top clearance 305 mm [12 in.] 305 mm [12 in.]
C Dryer front clearance Not Applicable 51 mm [2 in.]
D Exhaust duct clearance to com-
bustible material
51 mm [2 in.] 51 mm [2 in.]
E Weather hood to ground clear-
ance
305 mm [12 in.] 305 mm [12 in.]
F Distance from floor or ceiling
to air opening edge
Not Applicable 76 mm [3 in.]
G Area of centered air openings
in closet door. Louvered door
with equivalent air openings is
acceptable. (Minimum clearan-
ces are shown.)
Not Applicable 1016 sq. mm/open [40 sq. in./
open]
H For new installations, it is sug-
gested to locate top of wall vent
1067 mm [42 inches] above
floor to make venting easier to
connect.
1067 mm [42 in.] 1067 mm [42 in.]
* Rear clearance is minimum. 51 mm [2 inches] is recommended for utility connection. 152 mm [6
inches] is recommended when venting through rear of unit.
Table 1
IMPORTANT: In mobile home installations, gas dryers
MUST be permanently attached to the floor at the time
of installation. Order No. 526P3 Hold Down Kit (availa-
ble at extra cost) for a manufactured (mobile) home in-
stallation. Follow the instructions supplied with the kit.
Connect Dryer Exhaust System
WARNING
To reduce the risk of fire and combustion gas accu-
mulation the dryer MUST be exhausted to the out-
doors.
W604
WARNING
To reduce the risk of fire and the accumulation of
combustion gases, DO NOT exhaust dryer air into a
window well, gas vent, chimney or enclosed, unven-
tilated area, such as an attic, wall, ceiling, crawl
space under a building or concealed space of a
building.
W045
WARNING
To reduce the risk of fire, DO NOT use plastic or thin
foil ducting to exhaust the dryer.
W354
Installation
© Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
10 Part No. D514685R5
This manual suits for next models
1
Table of contents
Other Alliance Laundry Systems Dryer manuals
Alliance Laundry Systems
Alliance Laundry Systems AE Series User manual
Alliance Laundry Systems
Alliance Laundry Systems CA120L Owner's manual
Alliance Laundry Systems
Alliance Laundry Systems DC5102WE User manual
Alliance Laundry Systems
Alliance Laundry Systems HE-HG Seies Assembly instructions
Alliance Laundry Systems
Alliance Laundry Systems ADE3TFWS431AW01 Operating instructions
Alliance Laundry Systems
Alliance Laundry Systems D677I_SVG Original operating instructions
Alliance Laundry Systems
Alliance Laundry Systems DRY724C_SVG Guide
Alliance Laundry Systems
Alliance Laundry Systems DRY2195N User manual
Alliance Laundry Systems
Alliance Laundry Systems 000 BTU User manual
Alliance Laundry Systems
Alliance Laundry Systems Speed Queen DF7000SE User manual
Alliance Laundry Systems
Alliance Laundry Systems DCB50EG User manual
Alliance Laundry Systems
Alliance Laundry Systems BA025E User manual
Alliance Laundry Systems
Alliance Laundry Systems 120 User manual
Alliance Laundry Systems
Alliance Laundry Systems LES33A F4562 Series User manual
Alliance Laundry Systems
Alliance Laundry Systems LES33 User manual
Alliance Laundry Systems
Alliance Laundry Systems DRY684C User manual
Alliance Laundry Systems
Alliance Laundry Systems 513123 User manual
Alliance Laundry Systems
Alliance Laundry Systems FES17AxF Assembly instructions
Alliance Laundry Systems
Alliance Laundry Systems 25 Pound Capacity User manual
Alliance Laundry Systems
Alliance Laundry Systems DRY2030N User manual
Popular Dryer manuals by other brands
Bosch
Bosch WTA79200GB Installation and operating instructions
Amana
Amana W10233410A Use and care guide
Miele
Miele TWH 780 WP operating instructions
Asko
Asko T760 user guide
Bosch
Bosch Logixx 10 WTB76556GB Instruction manual and installation instructions
STIEBEL ELTRON
STIEBEL ELTRON Ultronic S Operation and installation
