Alderon Industries 8059 User manual

Alarm Systems Control Panels Float Switches Leak Detection Systems Page 1 of 2

PO Box 827 Hawley, MN 56549 (218) 483-3034 Fax (218) 483-3036 www.alderonind.com

Operation, Maintenance and Installation Manual

Part Number - 8059

Pump Station Alarm

Introduction

Before proceeding with the installation or operation of the Pump Station Alarm

Panel, read all instructions thoroughly, as well as complying with all Federal, State

and Local Codes, Regulations and Practices. The control panel must be installed

by qualified personnel familiar with all applicable local electrical and mechanical

codes. Refer to the National Electrical Code (NFPA 70). Failure to properly install

and test this product can result in personal injury or equipment malfunction.

Safety Guidelines

1. DISCONNECT ALL POWER SOURCES BEFORE WORKING ON OR INSTALLING THE ALARM PANEL.

2. DO NOT USE WITH FLAMMABLE OR EXPLOSIVE FLUIDS SUCH AS GASOLINE, FUEL OIL, KEROSENE,

ETC. DO NOT USE IN EXPLOSIVE ATMOSPHERES.

Description of Operation

The outdoor rated Remote Pump Station Alarm Panel is connected to either dry or 120 VAC powered contacts

from a pump basin “Main Control Panel”.

The dry contacts from the “Main Control Panel” must be rated for 120 VAC, 1 Amp Minimum. The panel is

designed to be connected and field configured for Dry (Normally Open) or 120 VAC powered signals from the

“Main Control Panel”.

When the signal is received from the “Main Control Panel”, the alarm indicator, alarm buzzer and auxiliary

contacts activate. Pressing the Alarm Silence pushbutton silences the buzzer, but the alarm indicator and auxiliary

contacts remain activated.

When the signal from the “Main Control Panel” deactivates, the alarm indicator and auxiliary contacts turn off and

then auto resets the alarm buzzer for the next alarm cycle. The auxiliary contacts in the remote alarm can be used

to connect to auto dialers or Building Automation Systems (BAS).

Outdoor Remote Alarm Panel

Installation of Pump Station Alarm

1. Determine mounting location for the alarm panel and mount to a wall or wall structure. The panel has flanges

on the top and bottom which have mounting holes, use appropriate fasteners to securely mount the enclosure

to the wall or wall structure.

2. Determine conduit entrance locations on the alarm panel and install per local codes. Check schematic and

determine the number of power sources required. Use conduit sealant on all conduits to prevent moisture and

gases from entering the alarm panel.

3. Connect wires (recommended THHN 18 AWG wire) from the main control panel to the alarm panel, refer to

Figure 2 and Figure 3 on Page 2 for wiring options.

4. Verify correct wiring after installation is complete by activating the main panel alarm system, the remote alarm

panel should activate.

Alarm

Silence

Alarm Systems Control Panels Float Switches Leak Detection Systems Page 2 of 2

PO Box 827 Hawley, MN 56549 (218) 483-3034 Fax (218) 483-3036 www.alderonind.com

Operation, Maintenance and Installation Manual

Part Number - 8059

Pump Station Alarm

Schematic Drawing for Wiring

There are two (2) different ways to wire the alarm panel depending on which type of application being used, either

Dry or Wet contacts from the main pump panel. The Pump Station Alarm Panel comes with a jumper wire installed

on Terminals 3 and 4 (Fig. 1 and Fig. 3). If using a Dry Alarm Contact from the main pump panel, see Figure 2.

Outdoor Remote Alarm Panel

(Fig. 1) (Fig. 2)

(Fig. 3)

Panel Features

Alarm LED

Indicator

Alarm Silence

Pushbutton

(auto reset)

(Cover Removed)

Buzzer

Auxiliary

Contacts

Relay

Silence

Relay

Field Connection

Terminal Block

Specifications

Primary Power

120 VAC from Main Control Panel Signal or

Separate 120 VAC Feed

Input Signal

Dry Contacts Rated to 120 VAC,

1 Amp Minimum

Wet Contacts Rated to 120 VAC

Auxiliary Contacts

Normally Open - Dry

120 VAC, 5 Amps Maximum

Enclosure

Type 4X Thermoplastic, Padlockable

Alarm Indicator

120 VAC, Red LED, 22mm Diameter

Alarm Buzzer

95db @ 2-feet

Other Alderon Industries Security System manuals

Alderon Industries

Alderon Industries VersAlarm 4X User manual

Alderon Industries

Alderon Industries Sump Advisor 2000514 User manual

Alderon Industries

Alderon Industries Vizzyalarm VZW-02 User manual

Alderon Industries

Alderon Industries Versa'larm VA01A User manual

Alderon Industries

Alderon Industries Versa'larm VA02A User manual

Alderon Industries

Alderon Industries VersAlarm I/O User manual

Alderon Industries

Alderon Industries Versa'larm VA02B User manual

Alderon Industries

Alderon Industries VersAlarm I/O VLIO-0001 User manual

Alderon Industries

Alderon Industries VersAlarm I/O VLIO-00005 User manual

Alderon Industries

Alderon Industries Versa'larm VA01A User manual

Alderon Industries

Alderon Industries 7001 Versa’larm User manual

Alderon Industries

Alderon Industries VersAlarm I/O VLIO-0002 User manual

Alderon Industries

Alderon Industries VersAlarm I/O VLIO-0001 User manual

Alderon Industries

Alderon Industries WaterPro WaterSpotter AVFD Series User manual

Alderon Industries

Alderon Industries Oil Alert VA02 User manual

Alderon Industries

Alderon Industries Vizzyalarm VZW-01 User manual

Alderon Industries

Alderon Industries Versa'larm VA01D User manual

Alderon Industries

Alderon Industries Versa'larm 4X User manual

Alderon Industries

Alderon Industries Oil Alert VA03 User manual

Alderon Industries

Alderon Industries Versa'larm 8124 User manual

Alderon Industries

Alderon Industries VersAlarm 4X User manual

Alderon Industries

Alderon Industries Power Post VA-02 User manual

Alderon Industries

Alderon Industries Sump Advisor 2000514 User manual

Alderon Industries

Alderon Industries VersAlarm VLIO-0004 User manual

Popular Security System manuals by other brands

Inner Range

Inner Range Concept 2000 user manual

Climax

Climax Mobile Lite R32 Installer's guide

CADDX

CADDX NX-6 user manual

FBII

FBII XL-31 Series installation instructions

Johnson Controls

Johnson Controls PENN Connected PC10 Install and Commissioning Guide

Aeotec

Aeotec Siren Gen5 quick start guide

Blaupunkt

Blaupunkt SA 2700 quick start guide

IDEAL

IDEAL Accenta Engineering information

AJAX

AJAX DoubleButton user manual

Swann

Swann SW-P-MC2 Specifications

Ecolink

Ecolink Siren+Chime user manual

Digital Monitoring Products

Digital Monitoring Products XR150 user guide

EDM

EDM Solution 6+6 Wireless-AE installation manual

Highway Safety Group

Highway Safety Group EA401 user manual

Siren

Siren LED GSM operating manual

Detection Systems

Detection Systems 7090i Installation and programming manual

Se-Kure Controls

Se-Kure Controls MicroMini SK-4841 instructions

Siemens

Siemens FDM273 manual