Adam Equipment CB Balance User manual

Adam Equipment Company 2012

Adam Equipment

CB Balance

(P.N. 7.00.6.6.0246

– Revision - A, Septembe 2012)

Adam Equipment Company 2012

CONTENTS

1.0

INTRODUCTION................................................................ 1

2.0

KEY OPERATIONS............................................................ 1

3.0

CALIBRATION.................................................................... 2

4.0

MODEL SPECIFICATIONS................................................ 2

WARRANTY

INFORMATION ..................................................... 3

Adam Equipment Company 2012

1.0 INTRODUCTION

Each CB balance comes with 2 x AA batteries ready to use. There is a choice of three

capacities each with three weighing units including grams, ounces and Pounds

selectable by a Units key (grams only if the Mode key is not enabled). The bright

backlit display enables operation in any degree of light and the 304 grade stainless

steel top pan offers protection against most materials and liquids. With easy calibration

through the keypad the CB ensures correct and accurate weighing at all times.

Always position the balance on a steady and level surface before use.

The display “EEEE” indicates that the balance has been overloaded or damaged.

The display “Lo” indicates that the batteries must be changed.

Remove the cover on the underside of the balance to fit new batteries.

2.0 KEY

OPERATIONS

Power on/off key.

Weighing mode selection key (if enabled) – g, oz or Lbs.

Zero key is used to zero the balance or remove the weight

of an empty container.

Adam Equipment Company 2012

3.0 CALIBRATION

To calibrate the balance follow the instructions below.

With the display at zero press the on/off key four times, the display will now show an

internal figure.

Press the on/off key again and the display will show Zero and then flash with the

required calibration weight to be placed on the pan.

Place this value of weight on the pan and wait for the balance to show the correct value

at which time the calibration is complete.

*Always ensure you calibrate using an accurate and correct value weight otherwise the

weighing will not be accurate.

4.0 MODEL

SPECIFICATIONS

Model CB 501 CB 1001 CB 3000

Maximum

Capacity 500g 1000g 3000g

Readability 0.1g 0.1g 1g

Units of Measure grams as default, oz and lbs if the mode key

is enabled

Operating

Temperature 0 - 40 degrees C

Power Supply 2 x AA batteries or 6v DC 200ma Adaptor

Calibration Mass 500g 1000g 3000g

Display 5 x 12mm/0.47 inches high digits

Pan Size 130mm/5.1 inches diameter

Overall

Dimensions

(w x d x h) 160mmx205mmx 45mm / 6.3in x 8.1in x 1.8in

Net Weight 385g / 0.85Lbs

Adam Equipment Company 2012

WARRANTY

INFORMATION

Adam Equipment offe s Limited Wa anty (Pa ts and Labou ) fo the components failed due to defects

in mate ials o wo kmanship. Wa anty sta ts f om the date of delive y.

Du ing the wa anty pe iod, should any epai s be necessa y, the pu chase must info m its supplie o

Adam Equipment Company. The company o its autho ised Technician ese ves the ight to epai o

eplace the components at any of its wo kshops depending on the seve ity of the p oblems. Howeve ,

any f eight involved in sending the faulty units o pa ts to the se vice cent e should be bo ne by the

pu chase .

The wa anty will cease to ope ate if the equipment is not etu ned in the o iginal packaging and with

co ect documentation fo a claim to be p ocessed. All claims a e at the sole disc etion of Adam

Equipment.

This wa anty does not cove equipment whe e defects o poo pe fo mance is due to misuse,

accidental damage, exposu e to adioactive o co osive mate ials, negligence, faulty installation,

unautho ised modifications o attempted epai o failu e to obse ve the equi ements and

ecommendations as given in this Use Manual. Additionally echa geable batte ies (whe e supplied)

a e not cove ed unde wa anty.

Repai s ca ied out unde the wa anty does not extend the wa anty pe iod. Components emoved

du ing the wa anty epai s become the company p ope ty.

The statuto y ight of the pu chase is not affected by this wa anty. The te ms of this wa anty is

gove ned by the UK law. Fo complete details on Wa anty Info mation, see the te ms and conditions

of sale available on ou web-site.

Adam Equipment Company 2012

Manufactu e ’s Decla ation of Confo mity

This p oduct has been manufactu ed in acco dance with the ha monised Eu opean standa ds, following the

p ovisions of the below stated di ectives:

Elect o Magnetic Compatibility Di ective 2004/108/EC

Low Voltage Di ective 2006/95/EC

Adam Equipment Co. Ltd.

Bond Avenue, Denbigh East

Milton Keynes, MK1 1SW

United Kingdom

FCC COMPLIANCE

This equipment has been tested and found to comply with the limits fo a Class A digital device, pu suant to

Pa t 15 of the FCC Rules. These limits a e designed to p ovide easonable p otection against ha mful

inte fe ence when the equipment is ope ated in a comme cial envi onment. The equipment gene ates, uses,

and can adiate adio f equency ene gy and, if not installed and used in acco dance with the inst uction

manual, may cause ha mful inte fe ence to adio communications. Ope ation of this equipment in a

esidential a ea is likely to cause ha mful inte fe ence in which case the use will be equi ed to co ect the

inte fe ence at his own expense.

Shielded inte connect cables must be employed with this equipment to insu e compliance with the pe tinent

RF emission limits gove ning this device.

Changes o modifications not exp essly app oved by Adam Equipment could void the use 's autho ity to

ope ate the equipment

WEEE

COMPLIANCE

Any Elect ical o Elect onic Equipment (EEE) component o assembly of pa ts intended to be inco po ated into

EEE devices as defined by Eu opean Di ective 2002/95/EEC must be ecycled o disposed using techniques that

do not int oduce haza dous substances ha mful to ou health o the envi onment as listed in Di ective

2002/95/EC o amending legislation. Batte y disposal in Landfill Sites is mo e egulated since July 2002 by

egulation 9 of the Landfill (England and Wales) Regulations 2002 and Haza dous Waste Regulations 2005.

Batte y ecycling has become topical and the Waste Elect ical and Elect onic Equipment (WEEE) Regulations

a e set to impose ta gets fo ecycling.

Adam Equipment Company 2012

ADAM EQUIPMENT is an ISO 9001:2008 ce tified global company with mo e than 35 yea s

expe ience in the p oduction and sale of elect onic weighing equipment.

Adam p oducts a e p edominantly designed fo the Labo ato y, Educational, Health and Fitness,

etail and Indust ial Segments. The p oduct ange can be desc ibed as follows:

-Analytical and P ecision Balances

-Compact and Po table Balances

-High Capacity Balances

-Moistu e analyse s / balances

-Mechanical Scales

-Counting Scales

-Digital Weighing/Check-weighing Scales

-High pe fo mance Platfo m Scales

-C ane scales

- Health and Fitness Scales

-Retail Scales fo P ice computing

Fo a complete listing of all Adam p oducts visit ou website at www.adamequipment.com

t anslated in any fo m o by any means without the p io pe mission of Adam Equipment.

Adam Equipment ese ves the ight to make changes to the technology, featu es, specifications and design of

the equipment without notice.

All info mation contained within this publication is to the best of ou knowledge timely, complete and

accu ate when issued. Howeve , we a e not esponsible fo misinte p etations which may esult f om the

eading of this mate ial.

The latest ve sion of this publication can be found on ou Website.

www.adamequipment.com

Table of contents

Other Adam Equipment Scale manuals

Adam Equipment

Adam Equipment Warrior Series User manual

Adam Equipment

Adam Equipment 700660189 User manual

Adam Equipment

Adam Equipment CORE SERIES User manual

Adam Equipment

Adam Equipment CBC-M Series User manual

Adam Equipment

Adam Equipment MTB User manual

Adam Equipment

Adam Equipment AZextra Series User manual

Adam Equipment

Adam Equipment Cruiser CKT Series User manual

Adam Equipment

Adam Equipment WBW 3M User manual

Adam Equipment

Adam Equipment WBZ Series User manual

Adam Equipment

Adam Equipment CBD 6a User manual

Adam Equipment

Adam Equipment CRW Series User manual

Adam Equipment

Adam Equipment CB 501 User manual

Adam Equipment

Adam Equipment NBL 84 e/i User manual

Adam Equipment

Adam Equipment 103 User manual

Adam Equipment

Adam Equipment GBC Series User manual

Adam Equipment

Adam Equipment RAV Series User manual

Adam Equipment

Adam Equipment CQT1751GR User manual

Adam Equipment

Adam Equipment PGL SERIES User manual

Adam Equipment

Adam Equipment CBC SERIES User manual

Adam Equipment

Adam Equipment CCEU-20 User manual

Adam Equipment

Adam Equipment CPWplus 6 User manual

Adam Equipment

Adam Equipment GBC Series User manual

Adam Equipment

Adam Equipment MTB User manual

Adam Equipment

Adam Equipment MCW-250 L User manual

Popular Scale manuals by other brands

AWS

AWS ZEO-50 user manual

Gima

Gima Glass Body Fat Analyzer Use and maintenance book

Seca

Seca 374 user manual

TEC

TEC TEC SL59 SERIES owner's manual

Axis

Axis B/E Series user manual

Alecto

Alecto ACW-40 user manual

Rice Lake

Rice Lake MSI-4260 IS Technical manual

IKA

IKA RCT basic safety control operating instructions

ADE

ADE M20011 operating manual

Duronic

Duronic KS3000 manual

Digi

Digi SM-720 Service manual

Cardinal

Cardinal CS Series Operation manual

Korona

Korona Kastella Instructions for use

A&D

A&D FC-50Ki instruction manual

BDA

BDA CAMARGUE installation guide

Tanita

Tanita HD-357 Instructions for use

Leifheit

Leifheit 03173 quick start guide

Lumme

Lumme LU-1340 user manual