Whispbar K918W User manual
K918W
Fitting Kit
EN Fitting Instructions for Basic Carrier
x 2 x 2 x 4 x 4
Revision No: 4D 1
Fitting Kit K918W
MAX kgs (lbs)
W/P WHD
Land Rover
Discovery Sport, 5dr SUV 14-+ NZ 75 kgs (165 lbs) 75 kgs (165 lbs)
Discovery Sport, 5dr SUV 14-+ AU 75 kgs (165 lbs) 75 kgs (165 lbs)
Discovery Sport, 5dr SUV 14-+ EU 75 kgs (165 lbs) 75 kgs (165 lbs)
Discovery Sport, 5dr SUV 14-+ ZA 75 kgs (165 lbs) 75 kgs (165 lbs)
Discovery Sport, 5dr SUV 14-+ CN 75 kgs (165 lbs) 75 kgs (165 lbs)
2
Fitting Kit K918W
X
A B C 1 2 3
Discovery Sport, 5dr SUV 14-+ (NZ) -195mm 555mm - 995mm 990mm -
-7 -11/16ths" 21 7/8ths" - 39 3/16ths" 39" -
Discovery Sport, 5dr SUV 14-+ (AU) -195mm 555mm - 995mm 990mm -
-7 -11/16ths" 21 7/8ths" - 39 3/16ths" 39" -
Discovery Sport, 5dr SUV 14-+ (EU) -195mm 555mm - 995mm 990mm -
-7 -11/16ths" 21 7/8ths" - 39 3/16ths" 39" -
Discovery Sport, 5dr SUV 14-+ (ZA) -195mm 555mm - 995mm 990mm -
-7 -11/16ths" 21 7/8ths" - 39 3/16ths" 39" -
Discovery Sport, 5dr SUV 14-+ (CN) -195mm 555mm - 995mm 990mm -
-7 -11/16ths" 21 7/8ths" - 39 3/16ths" 39" -
3
Fitting Kit EN
K918W
First Time Installation
●Remove parts from inside the package and
check. Contact your dealer if any parts are
missing or damaged.
●This kit fits type A, B, C and D.
●These instructions show type A crossbar
fitted. They also apply to type B, C and D.
NOTE: Clamp images in these instructions may
not be representative of the clamps in this kit
4
Fitting Kit EN
K918W
●Use keys to remove covers.
●Use hex screwdriver to reverse adjusting
screw 10 turns.
●Press adjusting screw and pull crossbar
legs out. Refer to the crossbar instructions
for crossbar adjustment method.
●Ensure each end of the crossbar is
adjusted equally.
5
Fitting Kit EN
K918W
●Remove locking screw.
●Apply protective strip as shown.
Trim if required.
●A = Grey
●Place rubber pads (supplied with fitting kit)
on the vehicle roof. Pad may vary in shape
to that shown.
6
Fitting Kit EN
K918W
●Make sure the pad fits into the holes
underneath the foot.
Fitment
●Clamps directly to edge of roof under the
doors
●Please check the front of this manual for
information relating specifically to your
vehicle.
●Place crossbar on vehicle. Minimum
recommended spacing between the bars is
700mm (27 1/2") (unless otherwise stated).
●It is important to put the clamps in the
correct position on the vehicle.
●Letters refer to the part numbers stamped
on clamps.
●Clamp Part Number:
A = A793
B = C646
7
Fitting Kit EN
K918W
●Attach clamp to each leg.
●Refit locking screw so that it goes through
the hole in the clamp. Do not begin to
tighten the locking screw.
●Adjust the legs on the crossbar so that they
are positioned equally from the ends of the
crossbar, and the clamps engage firmly on
the body work of the vehicle.
8
Fitting Kit EN
K918W
●Tighten adjusting screw to 2 Nm (1.5 ft lb)
hand tight.
●Tighten locking screw on both legs evenly,
2.5 Nm (1.8 ft lb).
●Check crossbar is securely attached to the
vehicle.
9
Fitting Kit EN
K918W
●Use keys to fit and lock covers
CAUTION: Recheck all fasteners immediately after
a load is applied to the crossbars.
Regularly check screws are tight.
10
Table of contents
Other Whispbar Automobile Accessories manuals
Whispbar
Whispbar K091W User manual
Whispbar
Whispbar K937W User manual
Whispbar
Whispbar K802W User manual
Whispbar
Whispbar K334W User manual
Whispbar
Whispbar K944W User manual
Whispbar
Whispbar K774W User manual
Whispbar
Whispbar K670 User manual
Whispbar
Whispbar K447 Install guide
Whispbar
Whispbar K619W Operation and installation manual
Whispbar
Whispbar K603W User manual
Whispbar
Whispbar K071W User manual
Whispbar
Whispbar K371W User manual
Whispbar
Whispbar K128W User manual
Whispbar
Whispbar K436 User manual
Whispbar
Whispbar K349W User manual
Whispbar
Whispbar K900 User manual
Whispbar
Whispbar K335W User manual
Whispbar
Whispbar K360W User manual
Whispbar
Whispbar K543W User manual
Whispbar
Whispbar K186W User manual
