Step 1. –Assemble Angled Tongue Section, Bow Stop Foam Bumper, and Tongue Handle Grip
Slide Bow Stop Foam Bumper Onto ATS Insert Tongue handle into ATS and Install Grip
Step 2. Assemble Axle Beam , Upright Stanchion Assembly, Upright Stanchion Roller Assembly, and Axles
Insert Upright Stanchion Assembly into Axle Beam end and install Wire Lock Pin (WLP)-Left Side shown, Right Side Similar
NOTE: The Upright Stanchions may be installed to any of four positions, which are used to adjust the width of the Axle Beam. Three
of the positions have pre-drilled holes. After you select the desired width, insert the WLP. The fourth position does not require
WLP;the Upright Stanchions may be FULLY inserted into the Axle Beam, which will provide the narrowest width adjustment. If used
in this configuration, the Hull Cross Strap will retain the Upright Stanchions in the Axle Beam.
NOTE: The Upright Stanchion Roller Assembly has four height adjustment positions, in one-inch increments. After you select the
correct height for your application, install the Upright Stanchion Roller Assembly onto the Upright Stanchion Assembly using
included hardware. Tighten bolt and nuts securely.
