Weber Summit 460-LPG User manual

56861 04/28/11 LPG

AU - AUSTRALIA

#56861

460 - LPG

660 - LPG

GAS GRILL

Built-In LPG Gas Grill Installation Guide







m



 

 

 

 











m

 



 





m 

















m 





WWW.WebeR.com®3

bUILT-IN cUToUT DImeNSIoNS



There are several configuration options for the grill and gas supply access of your Island

structure.

The 3 common options (A, B, C) are illustrated in the “ ‘Island’ Structure Configuration

Options” table. ◆



All dimensions are to finished surfaces.

m 

◆

bUILT-IN cUToUT GeNeRAL DImeNSIoNS

460 660 ToLeRANceS

134" (864 mm) 42" (1067 mm) ±1/4" (6 mm)

36" (914 mm) 36" (914 mm) max

324 5/16" (618 mm) 24 5/16" (618 mm) ±1/4" (6 mm)

cLeARANceS

1 1

124" (610 mm) any surface

27" (686 mm) minimum for lid clearance



When determining a suitable location for your Summit®gas grill installation, give

attention to concerns such as exposure to wind, proximity to traffic paths, and keeping

any gas supply lines as short as possible. Never locate the Summit®gas grill in a

garage, breezeway, shed, under an unprotected overhang, or other enclosed area.

Locate the grill and structure so there is enough room to safely evacuate the area in

case of a fire.



m 







m 





NOTE: If you have questions on what materials are considered noncombustible, contact

your local building materials supplier or fire department. ◆

“ISLAND” STRUcTURe coNFIGURATIoN oPTIoN

1Summit®4-burner/6-burner grill

Gas supply

bUILT-IN cUToUT DImeNSIoNS



The Summit®Built-In unit should be on site before construction begins.

For ease of installation, the grill will be pushed on its casters into the built-in structure.

The installation of this grill requires a level floor pad surface  and countertop surface.

The floor pad surface must be constructed from solid materials and must be level

and smooth. Proper subgrade materials must be used under the floor pad to prevent

materials from settling and heaving.



If the supporting structure is going to have an electrical outlet for a rotisserie, it should

be on the left side of the structure. ◆







bUILT-IN cUToUT DeTAILeD DImeNSIoNS

460 660

DImeNSIoNS

124" minimum* (610 mm) 24" minimum* (610 mm)

16 1/2" (419 mm) 16 1/2" (419 mm)

311 1/8" (283 mm) 11 1/8" (283 mm)

410 1/2" (267 mm) minimum 10 1/2" (267 mm) minimum

24 5/16" (618 mm) 24 5/16" (618 mm)

36" (914 mm) maximum 36" (914 mm) maximum

734" (864 mm) Built-In frame 42" (1067 mm) Built-In frame

For a countertop treatment: recommended 3/4" (19 mm) overhang.

bGas inlet

Access for electric on left hand side

WWW.WebeR.com®27



A 58" (147.32 cm) corrugated gas line is connected to the manifold of the grill.

A) The main corrugated line passes through the “Island Structure” cavity to the hose

and regulator connection inside the tank enclosure .

B) Uncap the flare fitting from the 90° Connection on the regulator hose located inside

the tank enclosure .

C) Connect the main corrugated hose to the 90° bulkhead fitting. Use the 1/2" (12.7

mm) flared gasket to ensure proper seal .

Note: 1/2" flared gaskets are included in the Summit® Built-In tank Enclosure Kit

included with your grill. ◆

coNNecTIoN cHART

4Typical tank cabinet or tank enclosure location

Side view

Top of box

7Back of box

Corrugated gas line to manifold

90° fitting

10 1/2" (13 mm) flared gasket

bUILT-IN TANK eNcLoSURe PARTS LIST / ASSembLY



m 





Ventilation holes can be located in a low visibility area and should be protected by

screening material to prevent rodents and insects from entering the structure. Air holes

will also help dry moisture.

Note:These drawings are only a reference.

• Crossventilationmustbeincorporatedinthesupportingstructure.Werecommenda

minimum of 100 square inches (254 square cm) of venting per side.

• Ventsshouldbeontwosidesofthestructure.

• Thedrawingsareforreferenceonly.

• Locationoftheventsshouldbefromthecenter,outward.

• Locatetheventsatboththebottomofthestructureandatthetopofthestructure.

• Thebottomventsshouldbeasclosetogroundlevelaspossible.Makesurethevent

area is not blocked by interior supports of the structure.

• Werecommendventswithscreens.

• Accessdoorstothestructurearenotconsideredvents.

• Cleantheventsperiodically.

bUILT-IN TANK eNcLoSURe ASSembLY VeNTILATIoN

m









◆

m 



These parts may be gas carrying or gas burning components. Please contact Weber-Stephen Products LLC Customer Service

Department for genuine Weber-Stephen Products LLC replacement part(s) information.

m 







WEBER-STEPHEN PRODUCTS LLC

www.weber.com®

a Delaware limited liability company, located at 200 East Daniels Road, Palatine, Illinois 60067 U.S.A.

Printed in U.S.A.

This manual suits for next models

Table of contents

Other Weber Grill manuals

Popular Grill manuals by other brands

Orbegozo

Orbegozo GR 2300 instruction manual

bora

bora PT11 Operating and installation instructions

Klarstein

Klarstein 10031664 manual

Garland

Garland MWE3W Installation and operation manual

Char-Broil

Char-Broil 463722714 Product guide

Nexgrill

Nexgrill 720-0830HK Operating instruction

Kenmore

Kenmore 415.16123800 Use and care guide

Camp Chef

Camp Chef PG24CLAU Warning & instruction booklet

Tucker Barbecues

Tucker Barbecues GTR Series Assembly, installation and operating instructions

Monogram

Monogram ZGG540NCP1SS owner's manual

Equipex

Equipex Sodir Savoy Operation manual

Gaggenau

Gaggenau VR 414 610 use and care manual

Miele

Miele KM 408-1 operating instructions

George Foreman

George Foreman GGR50B owner's manual

AOG

AOG T series quick start guide

Gorenje

Gorenje TG2000CB Instruction manua

Glen

Glen SA 3037 user guide

Stalgast

Stalgast 9730100 instruction manual