Vivo MOUNT-E-FD70 User manual

Electric Flip Down Ceiling TV Mount

Scan the QR code with your mobile device or follow the link

for helpful videos and specifications related to this product.

Instruction Manual

https://vivo-us.com/products/mount-e-fd70

SKU: MOUNT-E-FD70

[email protected]om www.vivo-us.com 309-278-5303

PACKAGE CONTENTS

WARNING!

A (x1)

Mount

B(x1)

Center Plate

C(x1)

Ceiling

Template

M-F (x4)

Square Washer

M-G x8)

5mm Spacer

M-H (x8)

15mm Spacer

W-A (x6)

Bolt

M-E (x4)

M8x50

M-A (x4)

M5x14

M-B (x4)

M6x14

M-C (x4)

M6x30

M-D (x4)

M8x30

If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician.

Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use

this product for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or

injury caused by improper mounting, incorrect assembly or inappropriate use.

NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED

W-C (x4)

Washer

W-B (x6)

Anchor

CAUTION!

DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO

MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.

com, email at [email protected], or call us at 309-278-5303.

D(x2)

Decorative Cover

E(x2)

VESA Bracket

F (x2)

Bracket Rail

G(x1)

Power Adapter

H(x1)

Remote

Control

I(x4)

Cable Tie

77lbs

(35kg)

DO NOT EXCEED WEIGHT CAPACITY.

Failure to do so may result in serious injury.

TOOLS NEEDED

Phillips

Screwdriver

Drill Pencil

WARNING: CHOKING HAZARD

SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS.

ADULT SUPERVISION IS REQUIRED.

J(x2)

Leveling Knob

K (x4)

Set Screw

L(x4)

Philips Head Bolt

M(x4)

Washer

N(x4)

Hex Nut

O(x4)

Hex Socket Head

Bolt

P (x1)

Allen Wrench

ASSEMBLY STEPS

STEP 1

OPTION A: Wood Ceiling

Using ceiling template (C), mark exact location of

mounting holes. Drill pilot holes 2.2” (55mm) deep

using a 3/16” (4.5mm) drill bit. Insert two screws

(W-A), leaving a 0.2” (5mm) gap from ceiling.

Hang the ceiling mount so that the screws fit

into the keyhole openings. Slide mount forward,

then secure using additional screws (W-A) with

washers (W-C). Tighten all screws.

OPTION B: Concrete Ceiling

Using ceiling template (C), mark exact location

of mounting holes. Drill pilot holes 2.4” (60mm)

deep, using a 3/8” (10mm) drill bit. Insert six

concrete anchors (W-B), then tighten two screws

(W-A), leaving a 0.2” (5mm) gap from ceiling. Hang

the ceiling mount so that the screws fit into the

keyhole openings. Slide mount forward, then

secure using additional screws (W-A) with washers

(W-C). Tighten all screws.

NOTE: If mounting to a wood beam ceiling,

ensure the front and back holes are used for

the main support if mount is in line with the

beam. If perpendicular to the beam, use keyhole

openings for the main support. Do NOT use

included concrete anchors (W-B) for wood or

drywall.

SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS.

ADULT SUPERVISION IS REQUIRED.

STEP 2

Assemble the bracket rails (F) to the center plate (B) using Phillips head bolts (L),

washers (M) and hex nuts (N). Tighten with a Phillips screwdriver while holding nuts

with a wrench. Slide VESA brackets (E) onto the rails as shown and insert hex socket

head bolts (O) into the rails using the Allen wrench (P).

STEP 3

OPTION A: Flat Back TV

Align the VESA bracket assembly with the mounting holes in the back of the TV screen.

Install assembly to TV using appropriate screws (M-A, M-B) and square washers (M-F)

according to your screen’s requirements.

Adjust VESA bracket spacing to match TV

mounting holes, and lock in place using

the set screws (K) with the Allen wrench

(P). Remove x4 pre-installed screws from

the center plate, and loosen the center

screw until 5mm of thread is exposed.

STEP 3 (Continued)

OPTION B: Curved/Recessed Back TV

Align the VESA bracket assembly with the mounting holes in the back of the TV screen.

Install assembly to TV using appropriate screws (M-C, M-D, M-E), square washers (M-F) and

spacers (M-G, M-H) according to your screen’s requirements.

STEP 5

Place the TV with VESA bracket assembly on the ceiling mount arm (A) by inserting the

center screw into the keyhole at the desired height. Secure using previously removed

screws (from end of step 2) and tighten with a Phillips screwdriver. Clearance between the

ceiling and top edge of TV should be no less than 15mm when TV is in the fully lowered

position.

STEP 4 (Optional)

Attach the leveling knobs (J) to the lower two set screws (K) as shown. This will ensure the TV is

perfectly level with the ceiling when raised.

STEP 6

Run cables along edge of mount. Allow slack in cables for arm movement. Place decorative covers (D)

over cables and snap into place.

Using cable ties (I), fasten cables to the side of the arm.

NOTE: Keep cables clear from inside of arm to avoid damage due to pinching.

STEP 7

Plug power adapter (G) into mount, and connect to AC outlet.

NOTE: Plugging power supply into AC outlet prior to the mount may

cause a large spark when connecting to the mount.

LAST UPDATED: 11/29/2019

Open Monday-Friday from 7:00am-7:00pm CST,

our dedicated support team can oer immediate assistance with rapid response times.

If any parts are received damaged or defective, please contact us.

We are happy to replace parts to ensure you have a fully functioning product.

FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com

Love your new VIVO setup and want to share?

Tag us in your photo! @vivo_us

[email protected]

www.vivo-us.com

309-278-5303

AVG. RESPONSE TIME (within oice hrs): 1HR 8M

- 23% within < 15m

- 38% within < 30m

- 61% within < 1hr

- 83% within < 2hr

- 92% within < 3hr

AVG. RESOLUTION TIME (within oice hrs): 5M 4S

AVG. RESOLUTION TIME (within oice hrs): < 15 M

Other manuals for MOUNT-E-FD70

Table of contents

Popular TV Mount manuals by other brands

Ergotron

Ergotron Neo Flex Cantilever UHD user guide

StarTech.com

StarTech.com FPCEILBTB user manual

VonHaus

VonHaus 05/038 instruction manual

Techlink

Techlink ECHO TV manual

Sandstrom

Sandstrom SSTVMC12X instruction manual

Sony

Sony SU-WL700 Additional information for Using

ICW

ICW SCACC18 installation instructions

LG WM-L640V owner's manual

Gembird

Gembird WM-65ST-01 user manual

ERARD

ERARD FiTUP XXL 035320 quick start guide

PEERLESS

PEERLESS PLCK-1 Installation and assembly

Kanto

Kanto RCF180 user manual

GEM

GEM GEM GP001 instructions

Gladiator Joe

Gladiator Joe GJ0A0053 quick start guide

Vivotek

Vivotek AM-105 installation guide

AmazonBasics

AmazonBasics B07QG3LMG4 manual

Secura

Secura QLF210 instruction manual

Marquant

Marquant 929-083 Operating instructions in original