Vivo MOUNT-E-MM070 User manual

Electric TV Wall Mount

Scan the QR code with your mobile device or follow the link

for helpful videos and specifications related to this product.

Instruction Manual

https://vivo-us.com/products/mount-e-mm070

SKU: MOUNT-E-MM070

[email protected]om www.vivo-us.com 309-278-5303

Chat live with an agent!

GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

PACKAGE CONTENTS

77lbs

(35kg)

DO NOT EXCEED WEIGHT CAPACITY.

Failure to do so may result in serious injury.

WARNING!

A (x1)

Mount

B(x2)

Wall Plate Cover

C(x1)

Stencil

If you do not understand these directions, or if you have any doubts about the safety of the

installation, please call a qualified technician. Check carefully to make sure there are no missing or

defective parts. Improper installation may cause damage or serious injury. Do not use this product

for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.

We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or

inappropriate use.

NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED

D(x1)

TV Plate

E (x2)

VESA Bracket

F (x1)

Front Cover

G (x1)

Remote

H(x1)

Power Cord

I(x1)

Wrench

M-A (x4)

M5x14

M-B (x4)

M6x14

M-C (x4)

M6x30

M-D (x4)

M8x30

M-E (x4)

M8x50

M-F (x4)

Square

Washer

M-G (x8)

5mm Spacer

M-H (x8)

15mm Spacer

W-A (x6)

Screw

W-B (x6)

Anchor

CAUTION!

DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO

MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.

com, email at [email protected], or call us at 309-278-5303.

WARNING: CHOKING HAZARD

SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

W-C (x6)

Washer

ASSEMBLY STEPS

STEP 1

Measure the required mounting height using the

chart below. Ensure the front edge of the mantel

does not exceed 110°F (43°C).

STEP 2

Remove pre-installed nuts (A1), metal washers

(A2) and plastic washers (A3) from the mount (A)

using the wrench (I).

STEP 3

OPTION A: Wood Wall Installation

Align the bottom edge of the stencil (C)

with the measured height from step

1 and mark drilling locations using a

pencil. Use of a stud finder and level

is recommended. Remove stencil and

drill 2.2” (55mm) deep holes using a

1/4” (6mm) drill bit. Attach the mount

(A) to the wall using screws (W-A) and

washers (W-C).

TOOLS NEEDED

3/8” Drill Pencil

Phillips

Drill

3/16” Drill

Hammer Ruler Stud Finder

≤ 13-3/4” (350mm)

≤ 4” (100mm)

≤ 7-7/8” (200mm)

≤ 11-3/4” (300mm)

≥ 9-7/8” (250mm)

≥ 7-7/8” (200mm)

≥ 3-1/8” (80mm)

≥ 11-3/4” (300mm)

STEP 4

Plug the power cord (H) into mount (A). Place the cord into the slot as shown and snap the wall plate

covers (B) in place.

STEP 3 (Continued)

OPTION B: Concrete/Brick Installation

Align the bottom edge of the stencil (C)

with the measured height from step 1

and mark drilling locations using a pencil.

Use of a level is recommended. Remove

stencil, drill 2.4” (60mm) deep holes using

a 3/8” (10mm) drill bit, and insert anchors

(W-B) into the holes. Attach the mount

(A) to the wall using screws (W-A) and

washers (W-C).

STEP 5

Plug the power cord (H) into a wall outlet. Press and hold the down button on the remote (G) until the

arm is fully lowered. Remove and discard the silicon shipping pad (A4). Please note that the arm is

not able to fully raise until the pad is removed.

STEP 6

Remove the nut from each VESA bracket (E) and flip open the clip.

STEP 7

Attach the VESA brackets (E) to the back of the TV

using combination of screws (M-A - M-E), washers

(M-F) and spacers (M-G, M-H) appropriate for your

TV. The bottom edge of the VESA brackets should be

greater than 7-7/8” (200mm) above the bottom edge

of the TV.

STEP 9

Hang the TV with VESA brackets (E) onto the TV plate (D). Close the clips, and secure using

the previously removed nuts. Tighten with the wrench (I).

STEP 8

Place previously removed plastic washers (A3) on the mount (A). Attach the TV plate (D) to the mount

using nuts (A1) with metal washers (A2). Make sure the TV plate is level, and tighten nuts using the

wrench (I). Press the front cover (F) onto the front of the TV plate.

STEP 10

Manage cables using the cable clips on the arm. Use the remote (G) to raise and lower the mount.

The TV may be manually swiveled to the le and right.

CAUTION: To avoid injury, do not place hand in the arm while operating.

LAST UPDATED: 03/05/2020

Open Monday - Friday 7:00am - 7:00pm CST,

our dedicated support team can oer immediate assistance with rapid response times. If any

parts are received damaged or defective, please contact us. We are happy to replace parts to

ensure you have a fully functioning product.

FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com

[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M

- 23% within < 15m

- 38% within < 30m

- 61% within < 1hr

- 83% within < 2hr

- 92% within < 3hr

Love your new VIVO setup and want to share?

Tag us in your photo! @vivo_us

AVG. RESOLUTION TIME (within oice hrs): < 15 M

www.vivo-us.com

Chat live with an agent!

AVG. RESOLUTION TIME (within oice hrs): 5M 4S

309-278-5303

Table of contents

Popular Rack & Stand manuals by other brands

Salamander

Salamander Acadia AC/W/L400/WH Assembly instructions

Fohhn

Fohhn VAT-09 Mounting instruction

ricoo

ricoo FS0522 quick start guide

AMSOIL

AMSOIL BMK-22 Installation and service instructions

Kargo Master

Kargo Master 48220 installation guide

Milestone AV Technologies

Milestone AV Technologies SIMPLICITY SLF2 installation instructions

ricoo

ricoo S1222 installation instructions

Ready-Set-Mount

Ready-Set-Mount RSMCM602 instruction manual

VidaBox

VidaBox VB MNT FFS2 installation guide

Welch Allyn

Welch Allyn 48960 Assembly instructions

Arkon

Arkon CM035-ST-2 installation instructions

PROEL

PROEL PLWIN60C user manual

Agilent Technologies

Agilent Technologies E2609B installation guide

Mustang

Mustang MV-ARM4 installation guide

Mounting Solutions

Mounting Solutions WRM-320 manual

Pyle

Pyle PMKSPAD1 manual

ShelterIt

ShelterIt 21208 installation instructions

SPL

SPL RackPack?4 1040 manual 