VERITAS 5U84 Manual
Replacing a power supply in a Veritas 5U84 Storage Shelf
Document Number: 227
Version 1.0 (11/06/17)
Purpose
This document describes the process for replacing a power supply in a 5U84 Storage Shelf.
Electrical Safety
The static discharged by human bodies can damage static-sensitive components on the boards.
When installing and maintaining the equipment, observe appropriate electrostatic safety precautions
to prevent personnel injuries or device damage.
When operating a device in an electrostatic sensitive area, you must take electrostatic-discharge
(ESD)-preventive measures. These include wearing ESD-preventive gloves, an ESD-preventive wrist
strap, and ESD-preventive clothes to avoid personnel injury or device damage.
To prevent damage to the device, pay attention to the following during operations:
• Do not touch devices with bare hands because ESD from the human body may damage the
electrostatically sensitive elements on a board.
• When dealing with the server or any of the internal components, wear an ESD-preventive wrist
strap, ESD-preventive gloves, and ESD-preventive suit.
High availability (HA) appliance service considerations
Attention: A HA or multi-node appliance is serviced in the same manner as a single node appliance.
About replacing a 5U84 Storage Shelf power supply
This section describes how to remove and replace a power supply in a 5U84 Storage Shelf.
Caution: You must complete a power supply swap within three minutes. Leaving the power supply
slot open for longer than three minutes can result in the appliance overheating and cause other
components to fail.
1
Veritas Appliance
Hardware Service Procedure
Warning: Swap one power supply at a time only. If you need to remove both power supplies, make
sure that the storage shelf is turned off before you proceed.
Requirements
Use the following to verify the requirements of the service.
Verify you have the following items
• 5U84 Storage Shelf replacement power supply•
• ESD wrist strap
Removing a 5U84 Storage Shelf power supply
Use the following steps to remove a 5U84 Storage Shelf power supply.
To remove a 5U84 Storage Shelf power supply
1Put on an ESD-compliant wrist strap or take other ESD-protective measures.
2Do the following to verify that it is safe to remove the power supply before you disconnect the
power:
• A faulty power supply should either have faulty LEDs lit or no LEDs lit.
• Check that the LED on the other power supply is green.
3Disconnect the power cable from the faulty power supply. Do not disconnect the power cable
from the power supply that is running.
2
HSP #227 - Power supply replacement: Veritas 5U84 Storage Shelf
Warning: Swap one power supply at a time only. If you need to remove both power supplies,
make sure that the storage shelf is turned off before you proceed.
4Squeeze the faulty power supply latch towards the power supply handle. Use the handle to pull
the power supply out to remove the module from the storage shelf.
5Place the faulty power supply in an ESD-protective bag.
Installing the power supply
Use the following steps to install the power supply.
To install the power supply
Caution: Handle the power supply carefully to avoid damaging the connector pins. Do not install a
power supply if any pins appear to be bent.
1Remove the replacement power supply from any wrapping.
2Ensure that the switch of the power supply to be installed is turned off
3Slide the new power supply into the storage shelf.
Ensure that the retaining latch clicks into place as the latch engages.
4Connect the power cable to the power supply and secure the strain relief bale.
3
HSP #227 - Power supply replacement: Veritas 5U84 Storage Shelf
5Turn on the power supply switch. Verify that the LED on the replacement power supply is green
and that the air flows from the power supply.
If the LED is not green, contact the Veritas Technical Support.
4
HSP #227 - Power supply replacement: Veritas 5U84 Storage Shelf
Table of contents
Other VERITAS Storage manuals
VERITAS
VERITAS 5150 User manual
VERITAS
VERITAS 3U16 Manual
VERITAS
VERITAS 2U12 Manual
VERITAS
VERITAS NetBackup 5230 Operating and safety instructions
VERITAS
VERITAS Access 3340 Manual
VERITAS
VERITAS NetBackup 5330 Manual
VERITAS
VERITAS NetBackup 5330 User manual
VERITAS
VERITAS NetBackup 5230 Manual
VERITAS
VERITAS NetBackup Series Guide
VERITAS
VERITAS NetBackup 5230 Appliance Technical specifications
VERITAS
VERITAS NetBackup 5330 Manual
VERITAS
VERITAS NetBackup 5330 User manual
VERITAS
VERITAS 5250 User manual
VERITAS
VERITAS NetBackup 5230 Manual
VERITAS
VERITAS NetBackup 5330 Manual
VERITAS
VERITAS NetBackup 523 Operating and maintenance instructions
VERITAS
VERITAS 5350 Manual
VERITAS
VERITAS 5250 Manual
VERITAS
VERITAS 5150 User manual
VERITAS
VERITAS NetBackup 5240 User manual
