Unitech PA500II User manual

PA500II Enterprise Mobile Computer

- PA500II -

User’s Manual

400892G Preliminary

Preface

About This Manual

This manual explains how to install, operate and maintain the PA500II

Enterprise Mobile Computer.

No part of this publication may be reproduced or used in any form, or by any

electrical or mechanical means, without permission in writing from the

manufacturer. This includes electronic or mechanical means, such as

photocopying, recording, or information storage and retrieval systems. The

material in this manual is subject to change without notice.

Unitech global website address: http://www.ute.com

Bluetooth is a registered trademark of Bluetooth SIG.

Battery Notices

The PA500II is equipped with a Lithium-Ion battery pack and backup battery.

Both batteries will discharge after an extended period of not being used.

When both batteries are discharged, recharge the unit for 4.5 hours in order to

fully charge the main battery and backup battery. Recharge the PA500II

through the following:

1. Plug the USB charging cable to the PA500II and plug the 5V/3A AC-DC

adapter to the power jack of the USB charging cable.

2. Place the PA500II into the docking station and plug the 5V/3A AC-DC

adapter to the power jack of the docking station.

If the main battery is removed, the backup battery ensures the data on SDRAM

is safe for up to 2 hours. To prevent data loss, do not leave the PA500II

uncharged with the main battery removed for an extended period. For more

details, refer to the section titling Charging the Battery.

Note: Rechargeable batteries are advised to replace every year or when 500

charge/discharge cycles achieved to guarantee optimal performance. It

is normal that the battery balloons or expands beyond one year or the

maximum of 500 cycles. Although it does not cause harm, it cannot be

used again and must be disposed of according to the location's safe

battery disposal procedures.

If the performance decrease is greater than 20% in a Lithium-Ion battery,

the battery is at the end of its life cycle. Do not continue to use, and

ensure the battery is disposed of properly.

The length of time that a battery power lasts depends on the battery type and

how the device is used. Conserve the battery life through the following:

 Avoid frequent full discharges because this places additional strain on the

battery. Several partial discharges with frequent recharges are better than

a deep one. Recharging a partially charged lithium-Ion battery does not

cause harm because there is no memory.

 Keep the lithium-Ion battery cool. Avoid a hot car. For prolonged storage,

keep the battery at a 40% charge level.

 Do not leave the lithium-Ion battery discharged and unused for an

extended period because the battery will wear out and the longevity of the

battery will be at least shorter than half of the one with frequent recharges.

Battery charge notice

It is important to consider the environment temperature whenever the

Lithium-Ion battery pack is charged. Charging is most efficient at normal room

temperature or in a slightly cooler environment. It is essential that batteries are

charged within the stated range of 0°C to 40°C. Charging batteries outside of

the specified range could damage the batteries and shorten their charging life

cycle.

CAUTION! Do not charge batteries at a temperature lower than 0°C, which will

increase the internal resistance to cause heat and make the

batteries unstable and unsafe. Please use a battery

temperature-detecting device for a charger to ensure a safe

charging temperature range. Further, to protect and avoid battery

from inflating, the battery is detected for thermal protection and will

not be charged when the temperature of battery is over 50

degrees.

Storage and safety notice

Although charged Lithium-Ion batteries may be left unused for several months,

their capacity may be depleted due to build up of internal resistance. If this

happens they will require recharging prior to use. Lithium-Ion batteries may be

stored at temperatures between -20°C to 60°C, however they may deplete

more rapidly at the higher temperature ranges. It is recommended to store

batteries within normal room temperature ranges.

Warranty

The following items covered under Unitech Limited Warranty are free from

defects during normal use:

 PA500II – 1-year limited warranty.

 Lithium-Ion battery – 6-month limited warranty.

Warranty becomes void if equipment is modified, improperly installed or used,

dam-aged by accident or neglect, or if any parts are improperly installed or

replaced by the user.

Use only the adapter supplied. Using the wrong adapter may damage the unit

and will void the warranty.

iii

Table of Contents

Preface

About This Manual............................................................................................i

Battery Notices...........................................................................................i

Battery charge notice.......................................................................... ii

Storage and safety notice................................................................... iii

Warranty................................................................................................... iii

Chapter 1

Getting Started.................................................................................................1

Introducing the PA500II.............................................................................1

PA500II Product Introduction &Accessory Kit...........................................2

Tour of the PA500II....................................................................................3

Setting up the PA500II...............................................................................5

Installing the Battery............................................................................5

Charging the PA500II..........................................................................6

Powering On the PA500II....................................................................7

Chapter 2

Using the Hardware.........................................................................................9

Using the Keypad......................................................................................9

Using the Stylus.........................................................................................9

Using the SDIO/MMC Slot.......................................................................10

Chapter 3

Getting Connected.........................................................................................13

Establishing Device-PC Connection........................................................13

Installing Microsoft ActiveSync..........................................................13

Connecting the Device to Your Computer.........................................14

WiFi Connection......................................................................................15

Using the Summit Utilities.................................................................15

Chapter 4

Barcode Scanner Programs...........................................................................19

Scanner Setting.......................................................................................19

Scan2Key................................................................................................19

Barcode Symbologies.......................................................................20

Barcode Symbologies 2D..................................................................21

Chapter 5

Advanced Settings.........................................................................................23

Performing a Hardware Reset.................................................................23

Performing a Warm Boot...................................................................23

Performing a Cold Boot.....................................................................23

Appendix I

System Specification......................................................................................25

Appendix II

Worldwide Support.........................................................................................27

Chapter 1

Getting Started

Introducing the PA500II

Thank you for purchasing the PA500II Enterprise Mobile Computer. Your

PA500II was designed for users who need a compact and durable portable

computer for data collection and real time transactions. The unitech PA500II

Enterprise Mobile Computer is a compact mobile computing device designed

for maximum durability.

Easy to Use

The unit is equipped with a color display with touch screen, a five-way

directional key, and six application keys. The PA500II supports integrated long

range scanners for fast and accurate data collection. The device also supports

infrared interface, Bluetooth, and wireless communication capability for

exchanging information in a computing communication system.

PA500II Product Introduction & Accessory Kit

After opening the box, ensure the following accessories for the PA500II are

present:

PA500II Terminal Power Adapter* Battery Pack

Stylus with bungee

lanyard USB charging cable USB docking station

(optional)

QRG/UM CD-ROM

* The adapter’s replaceable clip plugs is available, depending on the region.

If anything is missing or appears damaged, contact your dealer.

Other manuals for PA500II

Table of contents

Other Unitech PDA manuals

Popular PDA manuals by other brands

SPOT

SPOT SPOT user guide

Palm

Palm handheld Getting started guide

Winmate

Winmate E500QK user guide

Getac

Getac PS236 Specifications

Sharp

Sharp CE-1600P Operation manual

HTC

HTC PHAR100 user manual

Mindeo

Mindeo M40 Reference manual

Acer

Acer n30 manual

ASCOM

ASCOM 9D24 EX brochure

HandHeld

HandHeld Nautiz X3 user manual

Casio

Casio PALM manual

Sharp

Sharp TM-20 Software guide

Atid

Atid AT870 quick guide

AML

AML M7225 user guide

Audiovox

Audiovox Maestro Quick start card

Casio

Casio PV-750 Plus Function guide

PSC

PSC Falcon 4220 installation guide

Datalogic

Datalogic ELF quick start guide