Ubiquiti M900 User manual

Carrier Class

airMAX™BaseStation

Models:

M900/M2/M3/M365/M5/M6

Introduction

Thank you for purchasing a Ubiquiti Networks™Rocket™M

series product. This Quick Start Guide is designed to guide you

through installation and show you how to access the airOS™

Configuration Interface. This Quick Start Guide also includes

the warranty terms and is for use with the RocketM models

without GPS.

Package Contents

RocketM Metal Strap 24V PoE Adapter

Carrier Class

airMAX™BaseStation

Models:

M900/M2/M3/M365/M5/M6

Power Cord Quick Start Guide

Installation Requirements

• Shielded Category 5 (or above) cabling should be used for

all wired Ethernet connections and should be grounded

through the AC ground of the PoE.

We recommend that you protect your networks from the

most brutal environments and devastating ESD attacks

with industrial-grade shielded Ethernet cable from Ubiquiti

Networks. For more details, visit

www.ubnt.com/toughcable

cable and earth grounding must be used as conditions of product warranty. TOUGHCable is

designed for outdoor installations. It is the customer’s responsibility to follow local country

regulations, including operation within legal frequency channels, output power, and Dynamic

Frequency Selection (DFS) requirements.

Hardware Overview

Antenna

Connectors

Port Cover

LAN

Ethernet

Port

Reset

Button

Note: U.S. product versions are locked to the U.S. Country

Code to ensure compliance with FCC regulations.

LEDs

Power The Power LED will light green when the

device is connected to a power source.

Ethernet The Ethernet LED will light steady

green when an active Ethernet connection is

made and flash when there is activity.

Signal In airOS, you can modify the wireless

signal strength threshold values for each LED on

the Advanced tab under Signal LED Thresholds.

The default values are shown below:

LED will light red when the wireless signal

strength is above -94 dBm.

LED will light amber when the wireless

signal strength is above -80 dBm.

LED will light green when the wireless

signal strength is above -73 dBm.

LED will light green when the wireless

signal strength is above -65 dBm.

Hardware Installation

1. Remove the Port Cover by lifting the release latch on the

bottom of the RocketM and sliding the Port Cover off.

2. Connect an Ethernet cable to the LAN port.

3. Replace the Port Cover.

4. Attach the RF Cables to the connectors labeled Chain 0 and

Chain 1 on the RocketM.

5. Attach the RocketM to an antenna. Align the mounting

tabs on the back of the RocketM with the mounting

bracket on the antenna. Slide the RocketM down until it

locks into place. (If you are mounting the RocketM on a

pole, refer to the Pole‑Mounting section.)

Mounting on a Dish Antenna Mounting on a Sector Antenna

6. Attach the RF Cables from the RocketM to the connectors

on the antenna.

Connecting to a Dish Antenna Connecting to a Sector Antenna

7. Attach the Protective Shroud.

Align the arrow on the top of the

shroud with the short hash mark on

the Dish Antenna, and then rotate

the shroud clockwise until it aligns

with the long hash mark to lock it

into place.

Slide the Protective Shroud

down over the RocketM until it

locks into place on the Sector

Antenna.

Pole-Mounting

To mount the RocketM on a pole, use the included Metal Strap

and perform the following steps:

1. Open the Metal Strap by turning the screw

counter-clockwise. You can loosen it by hand or use a

flathead screwdriver.

2. Straighten out the end of the Metal Strap and slide it

through the back of the RocketM.

3. Wrap the Metal Strap around the pole. To tighten the strap,

turn the screw clockwise using a flathead screwdriver.

Connecting Power over Ethernet

1. Connect the other end of the Ethernet cable from the

RocketM to the Ethernet port labeled POE on the PoE

Adapter.

2. Connect an Ethernet cable from your LAN to the Ethernet

port labeled LAN on the PoE Adapter.

3. Connect the Power Cord to the power port on the PoE

Adapter. Connect the other end of the Power Cord to a

power outlet.

Other manuals for M900

This manual suits for next models

Table of contents

Other Ubiquiti Network Hardware manuals

Ubiquiti

Ubiquiti UF-OLT-4 User manual

Ubiquiti

Ubiquiti LiteBeam LBE-5AC-23 User manual

Ubiquiti

Ubiquiti mFi mPort User manual

Ubiquiti

Ubiquiti UniFi LED ULED-AT User manual

Ubiquiti

Ubiquiti Airmax NBE-M2-400 User manual

Ubiquiti

Ubiquiti UBB User manual

Ubiquiti

Ubiquiti UF-AE User manual

Ubiquiti

Ubiquiti PBE-5AC-GEN2-5-EU User manual

Ubiquiti

Ubiquiti RocketDish RD-5G30 User manual

Ubiquiti

Ubiquiti UniFi Cloud Key User manual

Ubiquiti

Ubiquiti RD-3G26 User manual

Ubiquiti

Ubiquiti PBM3 User manual

Ubiquiti

Ubiquiti UniFi WiFi BaseStation XG User manual

Ubiquiti

Ubiquiti AM-5AC21-60 User manual

Ubiquiti

Ubiquiti airMAX NanoBridge M NBM3 User manual

Ubiquiti

Ubiquiti USW-24 User manual

Ubiquiti

Ubiquiti Nano G User manual

Ubiquiti

Ubiquiti NanoBeam M5 Manual

Ubiquiti

Ubiquiti UF-LOCO User manual

Ubiquiti

Ubiquiti airVision-C User manual

Ubiquiti

Ubiquiti UF-Instant User manual

Ubiquiti

Ubiquiti UniFi Dream Machine Pro User manual

Ubiquiti

Ubiquiti airMAX NanoStationM2 User manual

Ubiquiti

Ubiquiti NS-5AC User manual

Popular Network Hardware manuals by other brands

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL product manual

B&B Electronics

B&B Electronics ZXT9-IO-222R2 product manual

Yudor

Yudor YDS-16 user manual

D-Link

D-Link ShareCenter DNS-320L datasheet

Samsung

Samsung ES1642dc Hardware user manual

Honeywell Home

Honeywell Home LTEM-PV Installation and setup guide

evertz

evertz 7700 Series manual

D-Link

D-Link ShareCenter DNS-343 Quick installation guide

Asante

Asante AsanteBridge 1012 user guide

FireBrick

FireBrick FB2700 user manual

Audiovox Electronics

Audiovox Electronics ARWH2T user manual

ADC

ADC DSX-1 Operational Procedures Guide

NetComm

NetComm NF2 user guide

Alcatel-Lucent

Alcatel-Lucent 5620 user guide

Dell EMC

Dell EMC XC6420 Series Solution guide

Lanner

Lanner NCA-1020A user manual

Allied Telesis

Allied Telesis AT-TN121-A Specifications

Arista

Arista CCA-ETM-Q12 quick start guide