vicinity. Short-circuiting the terminals can damage the battery or the connectors.
·Do not leave the battery in very warm or cold places, such as in a closed car in summer or winter.
All of the above suggestions apply to the phone, battery, charger, or any accessory.
If phone or accessories are not working properly, take only to authorised service facilities.
Damaged batteries can damage or ruin components (e.g. Plastics).
• When the phone or accessories return to normal temperature, moisture can form inside and damage
circuit boards.
•Do not attempt to open the phone or accessories other than as instructed in this guide.
•Do not drop, knock, or shake the phone or accessories. Rough handling can break internal circuit boards
and fine mechanics.
•Do not use chemicals, solvents, or detergents to clean the phone or accessories.
•Do not paint the phone or accessories. Paint can clog the moving parts and prevent proper operation.
•Use only the supplied or authorized replacement parts. Unauthorized parts, modifications, or
attachments can damage the phone and may violate regulations governing radio devices.
•Do not dispose of batteries in a fire!
Dispose of batteries according to local regulations. Please recycle when possible. Do not dispose as
household waste.
Mobile phone maintenance
• Keep the device dry. Precipitation, humidity, and all types of liquids or moisture can contain minerals that
will corrode internal parts and circuits. If your device does get wet, remove the battery and allow the
device to dry completely before replacing it.
• Do not use or store the device in dusty, dirty areas to avoid damage to moving parts and components.
• Do not store the phone or accessories in warm areas. High temperatures reduce the life of electronic
devices.
Charging your battery
Your device is powered by a rechargeable battery. The full performance of a new battery is
achieved only after two or three complete charge and discharge cycles. The battery can be charged and
discharged hundreds of times but it will eventually wear out. When the talk and standby times are
noticeably shorter than normal, replace the battery. Use only approved batteries and recharges your
battery only with approved chargers designated for this device.
If a replacement battery is being used for the first time or if the battery has not been used for a long
period, it may be necessary to connect the charger, disconnect it and then reconnect it to begin charging
the battery.
Unplug the charger from the electrical plug and the device when not in use. Do not leave a fully
charged battery connected to a charger, since overcharging may shorten its lifetime. If left unused, a fully
charged battery will lose its charge over time.
If the battery is completely discharged, it may take a few minutes before the charging indicator
appears on the display or before any calls can be made.
Use the battery only for its intended purpose. Never use any charger or battery that is damaged.
Do not short-circuit the battery. Accidental short-circuiting will occur when a metallic object such as
a coin, clip, or pen causes direct connection of the positive (+) and negative (-) terminals of the battery.
(These look like metal strips on the battery.) This might happen, for example, when you carry a spare
battery in your pocket or purse. Short-circuiting the terminals may damage the battery or the connecting
object. Leaving the battery in hot or cold places, such as in a closed car in summer or winter conditions,
will reduce the capacity and lifetime of the battery. Always try to keep the battery between 15°C and 25°C
(59°F and 77°F). A device with a hot or cold battery may not work temporarily, even when the battery is
fully charged. Battery performance is particularly limited in temperatures well below freezing.
Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged.
Dispose of batteries according to local regulations. Please recycle when possible. Do not dispose as
household waste.
Note: Actual operation time of the battery varies according to operation mode, network settings
and call settings.
Note:
