MOUNTING WINCH ON A FLAT SURFACE
MOUNTING WINCH TO A PIPE (SEE FIG. 1)
PLEASE NOTE:
Do not over tighten U-bolts; over tightening can cause
deection and weakening of the frame – creating an unsafe
situation and voiding warranty.
WINCH WIRING (SEE WIRING DIAGRAM PG. 2)
Do not use long extension cords to power the winch.
connecting the winch during installation period. Running
the winch under degraded voltage conditions will result
in overheating, low power and damage to the capacitors.
PLEASE NOTE:
The winch limit switches are pre-wired at the factory. Do not
test run the winch with the limit switches bypassed as this may
cause over–travel of the limit mechanism and result in damage
to the winch.
P: 1-866-829-4411
F: 1-519-539-9191
USA: Tork Winch USA LLC
CANADA: Tork Winch
INSTALLATION INSTRUCTIONS
GYMNASIUM
CAUTION
1. As with any lifting device, the installation shall
be made only by persons suitably experienced
and qualied for work on hoisting equipment,
in accordance with local requirements.
2. The electrical supply and connection to the winch
shall be made in accordance with local electrical
code and by qualied personnel.
3. The instructions address the areas of proper
mounting, rope installation, wiring and limit switch
adjustment, but they are not intended to cover
every aspect of installation of your hoisting
system, not to replace the need for normal good
care, workmanship and proper practices on part
of the installer.
