System Sensor SMB500 User manual

I56-1267-002

PittwayTecnologica S.r.l, Via Caboto 19/3, 34147Trieste, Italy © System Sensor 2008

D450-24-00

P1562-D4

Notice: This manual should be left with the owner/user of this equipment.

1. If surface mount conduit is to be used, predrill a hole in the side of the

surface mount box at one of the drill centers provided.

2. Secure the surface mount box to the wall with screws and plastic

anchors (provided) or to a junction box (screws not provided).

3. Wire the module according to the module instructions.

4. Assemble the module to the surface mount box with the short screws

provided.

5. Fasten the cover plate to the module, using the screws provided with the

module.

NOTE: ForUL installationswheremultiple conduitentriesareused, install

RACO Model 1262 (1/2") or 1263 (3/4") grounding bushings to maintain

proper system ground. Hub shall be connected to the conduit before the

hub is connected to the enclosure.

INSTALLATION AND MAINTENANCE INSTRUCTIONS

Model SMB500 Surface Mount Box

Aviso: Este manual debe entregarse al propietario/usuario de este

equipo.

1. Si se utilizan tubos para montaje en superficie, taladre un agujero en la

caja de montaje de superficie sobre uno de los puntos marcados para

taladrar.

2. Fije la caja de montaje en superficie sobre la pared con los tornillos y

tacos suministrados o en una caja de conexiones (tornillos no

suministrados).

3. Conecte el módulo según las instrucciones de cableado para módulos.

4. Monte el módulo en la caja con los tornillos cortos que se suministran.

5. Sujete la tapa frontal al módulo utilizando los tornillos suministrados con

el módulo.

INSTRUCCIONES DE INSTALACIÓN Y MANTENIMIENTO

Modelo SMB500 Caja para montaje en superficie

P1562-D4

I56-1267-002

Pittway Tecnologica S.r.l,Via Caboto 19/3, 34147 Trieste, Italy © System Sensor 2008

D450-24-00

P1562-D4

Nota : Questo manuale dovrebbe rimanere con il proprietario/utente

di questa attrezzatura.

1. Se è necessario collegare la scatola da parete ad una canalina

portacavi, forare un lato della scatola da parete in corrispondenza

ai centri di foratura segnati.

2. Fissare la scatola da parete al muro con le viti e i tasselli in

plastica (in dotazione) oppure ad una scatola di derivazione (viti

non in dotazione).

3. Cablare il modulo seguendo le istruzioni.

4. Fissare il modulo alla scatola da parete con le viti piccole in

dotazione.

5. Fissare la piastra di protezione al modulo usando le viti fornite con

il modulo.

Anmerkung: Die Anleitung sollte beim Anwender dieses Geräts aufbewahrt

werden.

1. Bei Kabel-Aufputzmontage, sollten Sie ein entsprechendes Loch in die

Seitenwand des SMB 500 bohren. Benutzen Sie dafür die markierten,

gesenkten Punkte.

2. Befestigen Sie das Gehäuse an der Wand mit den mit gelieferten

Schrauben und Plastikdübeln.

3. Verdrahten Sie das Modul gemäß der zugehörigen Installationsanleitung.

4. Befestigen Sie das Modul in dem Aufputzgehäuse mit den kurzen

beigefügten Schrauben.

5. Befestigen Sie die Abdeckplatte des Moduls mit den dafür vorgesehenen

Schrauben (Liegen dem Modul bei).

ISTRUZIONI DI INSTALLAZIONE E MANUTENZIONE

Modello SMB500 Scatola da parete

INSTALLATIONSANLEITUNG

Modell SMB500 Aufputz-Montage-Gehäuse

Table of contents

Other System Sensor Accessories manuals

System Sensor

System Sensor 2251TEM User manual

System Sensor

System Sensor 22051E User manual

System Sensor

System Sensor 52051E-RF User manual

System Sensor

System Sensor 2351TIR User manual

System Sensor

System Sensor RTS451 User manual

System Sensor

System Sensor 2251CTLE User manual

System Sensor

System Sensor 22051EISE User manual

System Sensor

System Sensor 22051E-RF User manual

System Sensor

System Sensor 22051TLE User manual

System Sensor

System Sensor 72051EI User manual

System Sensor

System Sensor B200SR-LF-WH User manual

System Sensor

System Sensor 7251 User manual

System Sensor

System Sensor SENS-RDR User manual

System Sensor

System Sensor 7351 User manual

System Sensor

System Sensor B501AP-IV User manual

System Sensor

System Sensor 5251RB-WP User manual

System Sensor

System Sensor 2251TM User manual

System Sensor

System Sensor B401BH User manual

System Sensor

System Sensor 2351BR User manual

System Sensor

System Sensor SPECTR Alert ADVANCE CHSR User manual

System Sensor

System Sensor 5451EIS User manual

System Sensor

System Sensor 22051TEI User manual

System Sensor

System Sensor RA400Z User manual

System Sensor

System Sensor FAAST FL2011EI-HS User manual

Popular Accessories manuals by other brands

Hillco

Hillco 2810 Operator's manual

Siemens

Siemens QSA2700D Basic documentation

Contours

Contours ZY024 manual

Saivod

Saivod VS621 manual

Virtuox

Virtuox VirtuCLEAN 2.0 user manual

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS user manual

Z-Wave

Z-Wave HSD-200Z user manual

turck

turck FMX-IM-2UPLI63FX quick start guide

Decagon Devices

Decagon Devices 10HS manual

UPPAbaby

UPPAbaby Cup Holder user manual

Elko

Elko SmartSensor Leakage Wireless manual

Grizzly

Grizzly H8371 instructions

Panasonic

Panasonic HG-T Series user manual

IFM Electronic

IFM Electronic Efector 250 Series Brief instructions

DigiDesign

DigiDesign 888/24 I/O installation guide

PROZIS

PROZIS QUAY user manual

patagonia

patagonia PSI Vest user manual

SFC Energy

SFC Energy EFOY GO! manual