Swann SR16220 User manual

Installation and User Guide

For model: SR16220 (all colours)

Swan Service Help line

0333 220 6050

Retro Under Counter Cooler

v1.0

SR16220_IM.indd 1 03/04/2018 14:06

Important Safeguards

Do not connect your appliance

to the electricity supply until all

packing and transit protectors

have been removed.

Leave to stand upright for at least

4 hours before switching on to

allow compressor oil to settle

This cooler must only be used

for its intended purpose i.e the

storing cooling of drinks in bottles,

cans or plastic containers. It is

not designed for foodstuff to be

in direct contact with the internal

surfaces.

Do not dispose of the appliance

on a fire. Your appliance

contains non CFC/HFC natural

substances in the cooling system

and in the insulation, which are

potentially flammable if exposed

to fire. Therefore, take care not

to damage, the cooling circuit

or pipes of the appliance in

transportation and in use. In

case of damage do not expose

the appliance to fire or potential

ignition source and immediately

ventilate the room where the

appliance is situated.

We suggest you contact your

local authority for disposal

information and facilities available.

See installation section for

information on suitable location.

On delivery, check to make

sure that the product is not

damaged and that all the parts

and accessories are in perfect

condition.

Ensure that the plug remains

readily accessible. Do not use

multiple adaptor or extension

cables

Failure to observe these

instructions may invalidate your

right to free service during the

guarantee period.

WARNING: Ensure adequate

ventilation around the appliance.

Do not site close to heat sources.

SR16220_IM.indd 2 03/04/2018 14:06

Important Safeguards

WARNING: Do not damage the

refrigerant circuit.

We suggest you keep these

instructions in a safe place for

easy reference.

This appliance can be used by

children aged from 8 years

and above if they have been

given supervision or instruction

concerning use of the appliance in

a safe way and if they understand

the hazards involved.

Cleaning and user maintenance

shall not be made by children

unless they are older than 8 and

supervised. Keep the appliance and

its cord out of reach of children

aged less than 8 years.

If the supply cord is damaged,

it must be replaced by the

manufacturer, its service agent or

similarly qualified persons in order

to avoid a hazard.

The plug must be accessible after

the installation.

Children should be supervised to

ensure that they do not play with

the appliance.

CAUTION: In order to avoid

a hazard due to inadvertent

resetting of the thermal cutout,

this appliance must not be

supplied through an external

switching device, such as a

timer, or connected to a circuit

that is regularly switched on and

off by the utility company

This appliance should only

be connected to an earthed,

switched mains socket. Do not

use an extension cord with this

appliance

SR16220_IM.indd 3 03/04/2018 14:06

Installation Notes

1. The appliance should not be tilted more than 45 degrees when you move it. Do

not use force on any part such as the condenser, the door or handle. They could

distort and affect the operation of the cooler. Ensure ALL packaging is removed

before installation

2. Make sure there is enough ventilation space around product

3. The appliance should not be installed near external heat sources eg direct sun-

shine - or external moisture sources.

It is important that upon receipt you stand your appliance upright for at least 4

hours before switching on to allow the system to settle.

2cm

SR16220_IM.indd 4 03/04/2018 14:06

Installation Notes

4. Ensure the supply voltage of socket is same as rating label.

5. The plug must be properly inserted to the wall socket.

6. The mains supply socket must be earthed - preferably with a switch. If it is not

earthed, do NOT install this appliance there. Do not use an extension cord

7. The product is equipped with adjustable feet. Once the product is in place, adjust

these to ensure the fridge is level and doesn’t rock.

DO NOT SITE THE PRODUCT WHERE THE AMBIENT TEMPERATURE IS LIKELY TO

DROP BELOW 5 DEGREES CENTIGRADE - EG: GARAGE OR SHED

SR16220_IM.indd 5 03/04/2018 14:06

First Time Use

1. It is important that upon receipt you stand your appliance upright for at least 4

hours before switching on to allow the system to settle

2. When using the cooler for the first time, set the thermostat to setting 3 or 4.

When the refrigeration system starts, you will hear the quiet hum of the compres-

sor. You may also hear the circulation of liquids and gases. This is normal on first

start up, Generally it will take 2-3 hours for the appliance to reach temperature.

Once temperature has been reached then put the beverages inside.

3. See below for location of thermostat and light switch on this model.

SR16220_IM.indd 6 03/04/2018 14:06

Reversing the Door

The door of the cooler can be reversed quite easily. See the illustration below. It is

best if you have a friend help you due to the weight, and to assist with alignment.

NOTE: Since reversing the door requires it to be inverted so the hinge mounts line

up, it will result in your Swan logo being upside down! Contact our service line if you

need to order another one. Always unplug the cooler before reversing the door.

1. Support the door from the bottom

2. Remove the 6 screws that affix the hinges and spacers to the cabinet frame

3. Place the door on a flat, padded surface to prevent scratching

4. Remove the 6 screws that affix the hinges to the door

5. Remove the blanking plugs from the opposite side and use those to plug the

holes exposed by the removal of the hinge from the cabinet frame

6. Screw the hinges to the opposite side of the door

7. Pick up the door and carefully align it with the cabinet holes

8. Screw the remaining 6 screws in to both hinges and the 2 spacers into the

cabinet to secure the door.

SR16220_IM.indd 7 03/04/2018 14:06

Cleaning & Maintenance

DAILY CLEANING

The outside of your refrigerator can be cleaned using a soft cloth moistened with a mild

detergent solution. Wipe dry with kitchen towel.

Do not use chemical or abrasive cleaners on any part of your refrigerator as these could

permanently damage or discolour the surfaces.

INTERNAL CLEANING

Wipe up any internal spills immediately with a soft cloth moistened with a mild detergent solu-

tion. Dry thoroughly.

SHELVES AND GUARDS

Any shelves can be removed and cleaned separately.

DOOR SEALS

Ensure that the door seals are kept free from debris at all times. If they don’t seal properly

this can waste energy and cause refrigeration unit to over run

Troubleshooting

Condensation on outside of door Humidity in the room is high. This is also

to be expected if the room is very warm

Condensation on the inside of the

cabinet

This is also caused by high humidity.

You can minimise this by only keeping

the door open only as long as you need

to .

Too cold/not cold enough inside the

cabinet

Adjust thermostat up or down accord-

ingly. Make sure nothing is stopping the

door from sealing properly

No power to cooler Check power cord, power supply or on/

off switch

SR16220_IM.indd 8 03/04/2018 14:06

Service and Spares

If you experience any problems at all with your cooler or require spare parts, expert

help is just a phone call away!

0333 220 6050

You will need to quote the model number of your appliance to hand.

Specifications

Total capacity: 115 L

Energy A+

Dimensions: 55 x 55 x 84 cm

Climate class: N (normal)

Weight: 35.06 kg

Back plate: Metal

SR16220_IM.indd 9 03/04/2018 14:06

WEEE Directive

Disposal of Unit

Disposal instructions for Swan items in accordance with the WEEE directive. Appliances

bearing the symbol shown here may not be disposed of in domestic rubbish. You are required

to dispose of old electrical and electronic appliances like this separately. Please visit www.

recyclemore.co.uk, or www.recyclenow.co.uk for access to information about the recycling

of electrical items. The WEEE directive, introduced in August 2006, states that all electrical

items must be recycled, rather than taken to landfill. Please arrange to take this appliance to

your local Civic Amenity site for recycling, once it has reached the end of its life.

BS Plug Wiring

The wires in the mains lead are coloured in accordance with the following code:

BLUE NEUTRAL

BROWN LIVE

GREEN/YELLOW EARTH

As the colours of the wire in the mains lead of this appliance may not correspond with the colour markings

identifying the terminals on your plug, proceed as follows:

The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or

coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked

with the letter L or coloured red. The wire which is coloured GREEN/YELLOW must be connected to the

terminal which is marked with the letter E or (earth symbol) and is coloured GREEN or GREEN/YELLOW.

WARNING: THIS APPLIANCE MUST BE EARTHED

SR16220_IM.indd 10 03/04/2018 14:06

Table of contents

Popular Accessories manuals by other brands

Hillco

Hillco 2810 Operator's manual

Siemens

Siemens QSA2700D Basic documentation

Contours

Contours ZY024 manual

Saivod

Saivod VS621 manual

Virtuox

Virtuox VirtuCLEAN 2.0 user manual

SCE

SCE ENVIRO-THERM SCE-TE170B24VSS user manual

Z-Wave

Z-Wave HSD-200Z user manual

turck

turck FMX-IM-2UPLI63FX quick start guide

Decagon Devices

Decagon Devices 10HS manual

UPPAbaby

UPPAbaby Cup Holder user manual

Elko

Elko SmartSensor Leakage Wireless manual

Grizzly

Grizzly H8371 instructions

Panasonic

Panasonic HG-T Series user manual

IFM Electronic

IFM Electronic Efector 250 Series Brief instructions

DigiDesign

DigiDesign 888/24 I/O installation guide

PROZIS

PROZIS QUAY user manual

patagonia

patagonia PSI Vest user manual

SFC Energy

SFC Energy EFOY GO! manual