Sulzer CA 524 User manual

www.sulzer.com

Installation guide

81907021B (08/2019)

GSM-4G modem CA 524

81907021B

This manual, as well as the software described in it, is furnished under license and may be used or copied only in

accordance with the terms of such license. The content of this manual is furnished for informational use only, is

subject to change without notice, and should not be construed as a commitment by Sulzer. Sulzer assumes no

responsibility or liability for any errors or inaccuracies that may appear in this book.

Except as permitted by such license, no part of this publication may be reproduced, stored in a retrieval system,

or transmitted, in any form or by any means, electronic, mechanical, recording, or otherwise, without the prior

written permission of Sulzer.

Sulzer reserves the right to alter specications due to technical developments.

81907021B

3en

1 MOUNTING

1.1 Part number 28007012 contains:

1. Modem

2. Antenna

3. Power cable

4. DIN rail socket with 2 screws

1. The Modem 2. Antenna 3. Power cable 4. DIN rail socket with

2 screws

1.2 Part number 28007013 contains:

Same items as part number 28007012 above with additional RS-232 cable which also can be or-

dered separately (p/n: 43320588). See accessory list on page 7 below.

5. RS-232 cable

1.3 DIN-rail socket (no. 4)

If the modem is to be mounted on a DIN-rail; attach the DIN rail socket on the rear side of the mo-

dem. Use the two screws included to fasten the socket.

1.4 Antenna (no. 2)

Mount the antenna into the connector at the modem. Place the antenna in open environment and

shielded from precipitation. The backside of the antenna has adhesive Sellotape or Scotch tape for

mounting on a clean surface. Avoid mounting the antenna on a grounded metal plate; it short circuits

the signal.

81907021B

1.5 Power connection

Use the enclosed power cable (no. 3). Plug in the RJ6/8 connector to the power jack in the modem.

Connect the open ends to your power supply according to description below. The modem is supplied

with recommended +10 - 30 VDC (Maximum Rating +8 - 57 VDC).

Pin assignment and typical connection:

1 Blue

2 Black

3 Red

4 Green

5 Yellow

6 Brown 0 V

+10 ─ +30 V

6 5 4 3 2 1

1.6 Power Supply

NOTE: Normally the modem is supplied from same source as the control unit.

1.7 Mounting of DIN-rail holder

The DIN-rail holder is fastened with two screws enclosed in the kit to t an universal 35 mm DIN-rail

according to DIN EN 60715.

Figure 1-1 Mounting the holder for DIN-rail

1.8 Antenna

The enclosed antenna is a Dipole type T and is to be mounted on a nonmetallic surface. For metal

cabinet; use the “Smartdisc”-antenna. The Dipole-T and the Smartdisc antenna cable must not be

extended.

In the section of 4.1 Accessory List are additional antennas which can be ordered from Sulzer if the

receiving signal is not sufcient.

81907021B

5en

CA 524

2 RS-232 communication and cable congurations

Use the communication cable (section 1.2 on page 3) to connect the substation. Follow the table

below to ensure communication. The default parameters for the modem are; 115 2 0 0 baud, No parity,

8data bits, 1stop bit.

CA 524

D-Sub 9 (F)

D-Sub 9 (M)

Cable color

Connections in controllers

Signal EC 531 PC 441 PC 242 PCx

1Pink

2Brown RXD 23 51 23 47

3White TXD 24 50 24 48

4Blue RTS 25 49 25 49

5Gray GND 22 52 22 46

6 -

7Green RTS 25 49 25 49

8Yellow CTS 26 48 26 50

9 -

Antenna

CA 524

EC 531

81907021B

3 Installing the SIM card

Yellow LED

(Network status)

Green LED

(Power on/off)

SIM inserted

The SIM - with the circuit side facing towards the Sulzer logo - is inserted by gently pushing it into the

SIM card holder until it snaps hold. It is now protected from accidental removal. The SIM can be re-

moved from the card holder by using a at object such as a screwdriver to carefully press the inserted

SIM until it snaps out again.

3.1 Status LEDs

• A green LED; Power ON

• A yellow LED blinking every 2nd second; Network search

• A yellow LED ashes every 4th second; Connected to 2G/3G/4G network

3.2 About SIM cards

AquaWeb

Sulzer provides the AquaWeb SIM-cards. To connect your station to Aquaweb, follow the instructions

enclosed with the SIM.

SIM card from other providers

Only telematics enabled SIM card is working. Consult with the SIM provider which functions need to

be enabled on the SIM card subscription.

81907021B

7en

4 Technical data

GSM/GPRS/EDGE Quad band GSM: 850/900/1800/1900MHz

UMTS/HSPA+ (I, II, IV, V, VIII, IX, XIX) Seven band:

UMTS 800/850/900/(1700/2100)/1800/1900/2100MHz

LTE: (1, 2, 3, 4, 5, 7, 8, 12, 18, 19, 20, 28) Twelve band LTE:

700/800/850/900/1700/2100/1800/1900/2100/2600MHz

Ambient operating temperature –30 to +65 °C (–22 to +149 °F)

Automatic thermal shutdown Min: <-40 °C, Max: >+90°C (± 3°C)

(Min. <-40 °F, Max: >194 °F)

Degree of protection IP 20, NEMA: Type 1

Housing material PPO and PC

Mounting With socket; DIN Rail 35 mm

Humidity 0–90% RH non-condensing

Dimensions H x W x D: 26 x 115 x 86 mm

(1.0 x 4.5 x 3.5 inch)

Power supply Recommended +10 - 30 VDC (Maximum Rating +8 - 57 VDC)

Power consumption < 5 W

Altitude Max 2000 MASL or 6562 ft. AMSL

Compliance R&TTE, GCF, FCC, PTCRB, IC, UL

Attention If the unit is used in a manner not described in this document the protection provided by

the equipment may be impaired.

4.1 Accessory list

Part number Description Note

43320588 Modem cable with DB9M + open end This part is included in

28007013

Antenna Accessories

Part number Description Note

28007007 Low prole Smartdisc

(SMA-M) +1 dB, 2.5 m

Extension of the cable is not

recommended

28007008 Align antenna kit +6.0 ─+9.0 dBi Included in kit:

Antenna

10 m cable

2 m cable

Wall and mast mounting

equipment

4.2 Cleaning

How to clean the unit

Power off the unit and only outside/front shall be cleaned by using a dry, soft cloth. A good choice

would be the microber type of cloth and gently wipe the CA 524 unit on front in order not to scratch

the overlay. If the dry cloth did not completely remove the dirt, do not press harder in an attempt to

scrub it off. If necessary, moisten the cloth by adding a small amount of water with thin solution of

mild detergent and try again. Never use detergent with polish or solvent which can have an impact of

the plastic surface.

Sulzer Pump Solutions Ireland Ltd., Clonard Road, Wexford, Ireland

Tel. +353 53 91 63 200, www.sulzer.com

Table of contents

Other Sulzer Modem manuals

Sulzer

Sulzer ABS CA 523 User manual

Popular Modem manuals by other brands

Davicom

Davicom DM562AP Operation manual

EpiValley

EpiValley TATA indicom SXC-1080 user guide

Zte

Zte WiMAX user manual

Intelimax

Intelimax MA-2060 user manual

SMC Networks

SMC Networks D3CM1604V Administrator's manual

Telstra

Telstra Wi-Fi 4G Advanced Pro X user guide

Thrane&Thrane

Thrane&Thrane imarsat EXPLORER 300 user manual

Samsung

Samsung AceLink SAM-335A user guide

Enfora

Enfora Enabler-G Integration guide

iRZ

iRZ ATM2-232 user guide

Zhone

Zhone 6310 installation instructions

Paradyne

Paradyne Hotwire 7976 installation instructions

US Robotics

US Robotics 3453C datasheet

MaxTech

MaxTech Plug & Play Internal Voice/FAX/Data/SVD... user manual

Zte

Zte MF823 user guide

Four-Faith

Four-Faith F1403 user manual

Sierra Wireless

Sierra Wireless AIRLINK MP595W user guide

Gemtek

Gemtek WiMAX WIXFBR-103 user manual