_________________________________________________________________________________
TOLO SAUNA info@tolosauna.com www.tolosauna.com
3. Safety Warning
This appliance is not intended for use by person with reduced physical, sensory or mental
capabilities, under 16 years old, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Check steam room before restart the controller.
Smoking and alcohol are not allowed inside the steam room.
Leave the steam room immediately when feels uncomfortable.
A ventilation fan is required for the steam room.
This steam generator is for heating up the steam room, please don’t change its functions or
usage by yourself, unless under the help or the guide of someone who can be responsible
for the safety.
When you go out, or may not use the steam generator in long time, please DISCONNECT
the steam generator general power supply and general water supply.
4. Install Cautions
If the generator is installed at a place where difficult for customer access, the water supply
valve must be easy to access for emergencies.
GFCI must be installed on the power supply, and the power supply, power wire, fuse and
breaker must comply with the nameplate on the unit and table 2 in this manual.
The solenoid valve can endure maximum 0.8MPa (8kg/cm2) water pressure. To protect the
solenoid valve from extremely high water pressure, please turn down the inlet slightly or install
water pressure relieving valve.
Do not install saddle-backed or needle valves on the inlet. Please dredge and clean the pipe
before installation.
No block valve should be installed in the steam pipelines. Strictly no blocked or blended pipe,
otherwise have negative effect on the flow of steam and condensate. The steam pipelines
should be installed with a slight angle so that the condensate can flow back to the generator or
the steam head.
Steam generator should be installed indoor to avoid frozen. The generator should be installed
and leveled with the arrow pointing upward at an easy-access place, otherwise do not switch
on.
The steam pipeline must be copper pipes or stainless steel pipes, all other material such as
plastic, acrylic should not be used since they cannot endure 150℃or higher temperature.
All inlet and apertures should be sealed to prevent any leakage of steam and to protect the
generator and customers.
Don’t drain water to the steam room from the water tank as may cause serious scald and
damage the steam room.
All inlet water pipes and steam pipelines should be built according to the National Standard
and this should be done before sealing the wall.
