StarTech.com ST12MHDDCRP User manual

Manual Revision: 01/16/2013

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

ST12MHDDCRP

HDMI® Over CAT5/6 Repeater for

ST12MHDDC

*actual product may vary from photos

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Introduction ............................................................................................1

Packaging Contents ................................................................................................................................. 1

System Requirements .............................................................................................................................. 1

Preparing Your Site ................................................................................................................................... 4

Hardware Installation .............................................................................................................................. 5

Specications ..........................................................................................7

Technical Support ..................................................................................8

Warranty Information ............................................................................8

Instruction Manual

Introduction

The ST12MHDDCRP HDMI® to CAT5 Repeater works with the ST12MHDDC HDMI®

Extender Kit to add additional displays and extend the HDMI® over Cat 5/6 signal. With

2 RJ45 outputs per unit, each repeater allows you to add a display, and also daisy-chain

the signal to 2 additional ST12MHDDCRP repeaters (sold separately) at up to 330 feet

(100 meters) at each level.

Additional repeaters can be added at any time, up to a maximum of 30 broadcasting

levels to over 100 displays - allowing for a highly scalable installation that can be used

with existing network cable for a cost-eective and exible extension. Each repeater

includes mounting hardware for a clean and professional installation. Plus, because

the HDMI® signal is extended over standard Cat5/Cat6 Ethernet cable with RJ45

connectors, proprietary cables aren’t necessary which eliminates both expense and the

hassle of running specialized cable.

Ideal for High-Denition applications, the HDMI® over UTP extender supports 1080p

video resolutions, 7.1 digital audio and features built-in EDID monitor emulation,

which ensures native resolution and maximum compatibility with your display or

projector, for a convenient plug-and-play installation.

Backed by a StarTech.com 2-year warranty and free lifetime technical support.

Packaging Contents

• HDMI® Repeater

• Power Adapter

• Instruction Manual

• Foot Pad Set

System Requirements

• ST12MHDDC HDMI® Extender Kit

• HDMI® enabled display device(s) One for each Repeater (i.e. television, projector)

• Available AC electrical outlet for transmitter, receiver and optional repeaters

• HDMI® cable for each display

Instruction Manual

ST12MHDDCRP Repeater Unit

Transmitter Unit

Front View of Repeater

Front View of Transmitter

Back View of Repeater

Back View of Transmitter

1. HDMI® Out

2. Power Status LED

3. Link Status LED

4. EDID Copy Button

1. Power jack

2. HDMI® Out Link #1 (RJ-45 Connector)

3. HDMI® Out Link #2 (RJ-45 Connector)

4. HDMI® In Link (RJ-45 Connector)

ST12MHDDC HDMI Extender Kit (Sold Separately)

1. HDMI® IN

2. Power Status LED

3. Link Status LED

1. Power Jack

2. HDMI® Out Link (RJ-45 Connector)

Instruction Manual

Receiver Unit

Front View of Receiver Back View of Receiver

1. HDMI® IN

2. Power Status LED

3. Link Status LED

1. Power Jack

2. HDMI® Out Link (RJ-45 Connector)

Instruction Manual

Preparing Your Site

NOTE: This device will only work with the ST12MHDDC HDMI Extender kit. Please

review site preparation steps from the ST12MHDDC manual prior to installing

additional Repeaters.

1. Determine where the Repeater/Display will be installed in relation to the

ST12MHDDC HDMI Extender kit (sold separately) and place/mount the display

appropriately.

2. (Optional) If using additional repeater unit(s) (sold separately), determine where

the remote display(s) will be located in relation to this repeater/display and place/

mount the display(s) appropriately. Repeaters allow for an additional 330 ft. (100

meters) of Cat5/6 between each device. The Repeater(s) must be situated between

the ST121MHDDC extender and the receiver, as the receiver portion does not have

an RJ-45 out port to continue the chain.

NOTE: Ensure the Repeater Unit(s) are situated near an available AC electrical outlet.

Make sure all devices are turned o before beginning installation.

Instruction Manual

Hardware Installation

NOTE: This device will only work with the ST12MHDDC HDMI® Extender kit. Please

review the Hardware Installation steps from the ST12MHDDC manual prior to installing

additional Repeaters.

1. Install RJ-45 terminated Cat5/6 Ethernet Cable

a) Connect an RJ-45 terminated Cat5/6 Ethernet cable to the HDMI® Out Link (RJ-45

Connector) on the local Unit (Transmitter or Repeater).

NOTE: If you are using surface cabling, ensure you have enough Category 5/6

unshielded twisted pair (UTP) network cabling to connect the Transmitter Unit to

the Remote Unit’s (Repeater/Receiver) location, and that each end is terminated

with a RJ45 connector. The cabling should not go through any networking

equipment (i.e. router, switch).

If you are using premises cabling, ensure that the Category 5/6 unshielded

twisted pair (UTP) network cabling between the Host Unit and the

Remote Unit has been properly terminated in a wall outlet in each location and

there is a patch cable long enough to connect the Remote Unit and the Host Unit

to their respective outlets. The cabling should not go through any networking

equipment (i.e. router, switch).

b) Connect the other end of the Cat5/6 cable run to the RJ45 connector on the

Repeater unit.

c) (optional) When adding multiple repeaters, a run of Cat 5/6 cable will be

required from and to each device.

2. Install Repeater Unit(s)

a) Position the Repeater Unit near the video display (i.e. television, projector) within

330 ft. (100 meters) from the level up device be it the initial transmitter or

another repeater.

b) Connect the video source to the HDMI® Out on the Repeater Unit using an

HDMI® cable.

c) Connect the Cat5/6 cable positioned in Step 1 to the”HDMI® In Link (RJ-45

Connector)” on the Repeater. Connect the Repeater Unit power supply. The

Power LED will light, and LINK LED will turn on after a successful connection

between both units is established. This may take several seconds.

Instruction Manual

NOTE: These steps can be repeated at each level when adding additional Repeaters up

to 30 levels. Each Repeater has two HDMI® out Links (RJ-45 Connectors) allowing for

the same signal to go in 2 dierent directions at each level.

3. Install Receiver Unit

d) Position the Receiver Unit near the video display (i.e. television, projector) within

330 ft. (100 meters) from the level up device be it the initial transmitter or

another repeater.

e) Connect the video source to the HDMI® out on the Receiver Unit using an

HDMI® cable.

f) Connect the provided Receiver Unit power supply. The Power LED will light,

and Link LED will turn on after a successful connection between both units is

established. This may take several seconds.

NOTE: The ST12MHDDC receiver (sold separately) should only be used as the last

device in the chain as it does not have an HDMI® out port (RJ-45 Connector).

4. Your source video image will now appear on the Repeater unit(s) attached

video display.

Instruction Manual

Specications

Input Connectors 1x RJ-45 Female

Output Connectors 1x RJ-45 Female

1x HDMI (19 pin) Female

Max Distance 100 m / 330 ft

Maximum Digital Resolutions 1920x1200 @60Hz

Supported Resolutions

1920 x 1200

1920 x 1080

1600 x 1200

Wide Screen Supported Yes

Audio Specications 7.1 Surround Sound

Power Adapter

Input Voltage 100~240V

Input Current 0.4 A A

Output Voltage 5 AC V

Output Current 2 A A

Center Tip

Polarity Positive

Plug Type M

Table of contents

Other StarTech.com Switch manuals

StarTech.com

StarTech.com HB30AM4AB User manual

StarTech.com

StarTech.com IES81GW Guide

StarTech.com

StarTech.com ST4202USB User manual

StarTech.com

StarTech.com SV231DPU2 User manual

StarTech.com

StarTech.com SV231DDVDUA User manual

StarTech.com

StarTech.com SV431DL2DU3A User manual

StarTech.com

StarTech.com ST4200USBM User manual

StarTech.com

StarTech.com HB20A4AME User manual

StarTech.com

StarTech.com POEINJ4G User manual

StarTech.com

StarTech.com ST3300G3UA User manual

StarTech.com

StarTech.com ST4205READ User manual

StarTech.com

StarTech.com SV1115IPEXT User manual

StarTech.com

StarTech.com ICUSB2328 User manual

StarTech.com

StarTech.com VS415RVGA User manual

StarTech.com

StarTech.com DS254 System manual

StarTech.com

StarTech.com SV831DUSBUK User manual

StarTech.com

StarTech.com VS221DP User manual

StarTech.com

StarTech.com SV441DUSBI User manual

StarTech.com

StarTech.com StarView SV221DVI Manual

StarTech.com

StarTech.com HBS304A24A User manual

StarTech.com

StarTech.com 35BAYFWUSB Manual

StarTech.com

StarTech.com CAB831HD Manual

StarTech.com

StarTech.com StarView SV231 User manual

StarTech.com

StarTech.com SV211HDUC User manual

Popular Switch manuals by other brands

URC

URC Total Control MFS-8 installation manual

Azbil

Azbil HPQ-D11 user manual

Sony

Sony DFS-900M operating instructions

SICK

SICK i17S operating instructions

F&F

F&F SZR-277 quick start guide

Shure

Shure UAMS/BK user guide

Dräger

Dräger X-zone Switch Off Instructions for use

Asco

Asco Joucomatic 349 Series manual

BT Mini Hub user guide

D-Link

D-Link DES-1226G manual

Johnson Controls

Johnson Controls FS80-C installation instructions

Alcatel-Lucent

Alcatel-Lucent 7450 ESS-12 Configuration guide

MicroNet

MicroNet SP1200A user manual

Ruijie

Ruijie RG-PF2920 Series Hardware installation and reference guide

Altinex

Altinex DA1914SX user guide

MiLAN

MiLAN MIL-SM2401M user guide

RJM

RJM MASTERMIND PBC/6X user manual

Atlas

Atlas MMK-KVM8 owner's manual