gJr:l,SYUNISEN,INC.-
®1iIIlC
Preventive Maintenance Chart
The Preventive Maintenance Chart lists the scheduled maintenance tasks for the Elliptical Edge. The chart lists the
time interval when each procedure should be performed, and provides the general steps necessary to perform the
task. In some cases, the chart references detailed maintenance procedures provided later
in
the section.
D=Daily; W=
Weekly;
Q=
Quarterly
(depending
on
the
amount
of
use,
Quarterly
procedures
may
need
to
be
performed
more
frequently).
INTERVAL
D W Q PROCEDURE
•Clean dust and dirt from the unit using asoft, clean cloth dampened with anon-abrasive liquid
cleaner. Give particular attention to the display panel, handrails and heart rate grips (if used).
•Clean dust, dirt, oils
or
other contaminants from inside the skate rails (the shuttle tracks), and
on
the shuttle rollers, using asoft, clean cloth and anon-abrasive liquid cleaner.
If
needed, remove
stubborn accumulations
by
scrubbing with asoft-bristle brush (such as atoothbrush). NEVER use
awire brush or any abrasive material to clean the skate rails
or
shuttle rollers.
IMPORTANT: Regularcleaning
of
the skate rails and shuttle rollers is CRITICAL
to
proper
op-
eration
of
the unit. Accumulations
of
dust and dirt
on
the
skate rails
or
shuttle rollers can result
in
rough operation, misalignment
of
the shuttles and excessive wear on the skate rails and shuttle
rollers.
•Vacuum the floor under and around the unit. MAKE SURE that the unit is at its maximum eleva-
tion when vacuuming (or move the unit to another location).
•Check the display panel and handrails to ensure they are securely attached to the unit. Retighten
the screws as needed.
•Inspect the Sport Utility Display panel for evidence
of
wear. Contact STAR TRAC
Customer
Support
if
replacement
of
the Sport Utility Display panel is necessary.
•Check each shuttle for misalignment
or
excessive sideplay. Realign the shuttles as needed (see
Shuttle
Alignment,
page 2.3).
•Check each stride belt for proper tension. Adjust the stride belt tension as needed (see
Adjusting
Stride
Belt
Tension,
page 2.4).
•Check the crank belt for proper tension. Adjust the crank belt tension as needed (see
Adjusting
Crank
Belt
Tension,
page 2.5).
2.2
Elliptical
Edge Service Manual
