EN
EN - 6 EN - 7
Inserting / replacing batteries
1. Open the battery compartment cover on the bottom of the scale.
2. Remove empty batteries; use a suitable tool if necessary.
3. Insert new batteries. Observe the correct polarity, which is marked on the bottom
of the battery compartment. Attach cover plate and press down until it clicks into
place.
Basic weighing
1. Place the scale on an even, firm and stable surface.
2. Before turning on the scale, place kitchen bowl (if you wish to use one) on the
weighing area.
3. Press 1/Zto turn on the scale.
4. Wait until “0“ is displayed.
5. Place the object to be weighed on the scale (or in the bowl); the display will show
its measured weight.
Weighing mode selection
1. Press 1/Zto turn on the scale. Wait until “0“ is displayed.
2. Repeatedly press Uto select weighing mode:
for weight measuring (units are g)
for water volume measurement (units are ml)
for milk volume measurement (units are ml)
Topping up weight and tare function
These features allow you to weigh ingredients gradually added onto the scale, without
removing the previously weighed ones.
1. Place the first batch on the scale; its weight will appear on the display.
2. Press 1/Zto set display value to zero.
3. Now, more ingredients can be added. The display will show the weight of the new
ingredients.
4. Repeat steps 2 and 3 with more ingredients as necessary.
Top up: If the total sum of the weights of all batches on the scale is less than 200 g, the
topping-up function will be used automatically. The scale resets after each pressing of
the button.
On each press of 1/Z, the display will show “ ----- “ or “0“. „ ----- “ means the scale plate
is unstable; wait a moment for “0“ to show. Once “0” is displayed, an “O” icon will also
come on to the left of the display, signifying the top up function is active. Maximum
load capacity does not change.
Tara: If the total sum of the weights of all batches on the scale is more than 200 g, the
TARA function will be used automatically. On first press of 1/Z, the total weight / vol-
ume of all items will be displayed. On second press of 1/Z, the scale will reset to zero,
after which you may continue weighing. The display will show “ ----- “ or “0“. „ ----- “
means the scale plate is unstable; wait a moment for “0“ to show. Once “0” is displayed,
a “T” icon will also come on at top left of the display, signifying the Tara function is
active. Maximum load will be reduced by the total weight of all current items.
Switching weighing units
Press UNIT on the underside of the scale to switch between metric (g / ml) and impe-
rial (lb:oz / fl’oz) units of measurement. When the scale switched on, press the button.
