UP-X500I Removing the rear cover unit
– 1 –
1. Removing the rear cover unit
Remove the screw 1, and remove the rear cover unit 2.
2. Removing the side cover
Slide the lever 1to release the lock. Slide the side cover 2toward
you and rotate and remove it.
3. Removing the LCD unit
3-1. Removing the top cover section
Remove each screw 1, and lift the rear side of the top cover
section 3and disconnect each connector 2and remove.
3-2. Removing the Top cover unit
Caution: Top cover unit 7is pushed down.
1. Remove the screw 1, and remove the wire holder 2.
[Screw 1is Black.]
2. Remove the screw 3, and remove the wire holder 4.
3. Remove the core 5of the T/P cable.
4. Remove four screws 6, and disassemble the top cover unit 7.
Precautions
• Before installation, be sure to turn off the power.
• Use gloves to protect your hands from being cut by the angle and
the chassis.
• Connect all the cables securely. When connecting or disconnecting
the cables, be careful not to apply stress to the cables. (It may
cause disconnection.)
• Ground the human body to prevent against troubles and dust adhe-
sion to the LCD by static electricity. When assembling the LCD, use
a discharge blower to prevent against dust intrusion.
• Be careful of the high voltage of the inverter PWB transformer.
• Place the top cabinet with LCD panel side down, Please use a clean
dust free clothe to protect the touch panel and LCD area.
1
1
2
2
1
1
1
1
12
2
3
1
23
4
5
6
6
7
