Sharp PN-HW431 User manual
PN-HW431 Dismantle Instruction
1
Dismantle Instruction
LCD MONITOR
MODEL
PN-HW431
701
PN-HW431 Dismantle Instruction
2
Table of contents
1. Scope.................................................................................................................. 3
2. Tools for dismantling............................................................................................... 3
3. Dismantle Procedure .............................................................................................. 3
4. Back covers .......................................................................................................... 4
5. Printed circuit boards ............................................................................................. 5
6. Battery................................................................................................................ 5
7. LCD Module .......................................................................................................... 6
8. Capacitors............................................................................................................ 7
9. Parts List ............................................................................................................. 7
PN-HW431 Dismantle Instruction
3
1. Scope
This document describes dismantling instruction according to Annex VII of Directive 2012/19/EU.
2. Tools for dismantling
Below tools are required to dismantle this product.
- Screw Driver
- Nipper
3. Dismantle Procedure
This product can be dismantled by below steps.
1. Remove Back covers (section 4)
2. Remove Printed circuit boards (section 5)
3. Remove Battery (section 6)
4. Dismantle LCD (section 7)
5. Remove Electrolyte Capacitors (section 8)
PN-HW431 Dismantle Instruction
4
4. Back covers
Back cover can be removed by screw driver.
PN-HW431 Dismantle Instruction
5
5. Printed circuit boards
All PWBs can be removed by screw driver.
Main I/F PWB (1pcs) Power PWB (1pcs) LED driver PWB (1pcs)
T-CON PWB (1pcs)
6. Battery
This model uses only AAA battery for remote control.
Battery can easily be removed.
PN-HW431 Dismantle Instruction
6
7. LCD Module
- LCD Dismantle procedure
1. Remove Rear cover
2. Remove PWBs
3. Remove the Cables
LCD
PN-HW431 Dismantle Instruction
7
8. Capacitors
Electrolyte Capacitors which diameter/height is larger than 25mm is installed on Power PWB.
These capacitors can be removed by using nipper to cut the leads.
On Power PWB
9. Parts List
Parts described in Annex VII of directive 2012/19/EU are as below.
Parts
Note
LCD
43inch LCD module
Printed Circuit Boards
Main I/F PWB
Power PWB
LED driver PWB
T-CON PWB
Battery
AAA battery
Electrolyte capacitors
(height >25mm, diameter >25mm)
On Power PWB
External electric cables
2 kinds of Power Cord
- for EU
- for UK
Table of contents
Other Sharp Monitor manuals
Sharp
Sharp PN-86HC1 User guide
Sharp
Sharp PN-K321 User manual
Sharp
Sharp PN -HW431T User manual
Sharp
Sharp PN-K322B User guide
Sharp
Sharp PN-K321 User manual
Sharp
Sharp LL-T18A1 User manual
Sharp
Sharp PN-525E User manual
Sharp
Sharp LL-S201A User guide
Sharp
Sharp PN-V701 Instruction sheet
Sharp
Sharp LL-171MU User manual
Sharp
Sharp LL-T1610W User manual
Sharp
Sharp IV-08MTV User manual
Sharp
Sharp PN-E471 User manual
Sharp
Sharp PN-80TC3 User guide
Sharp
Sharp LL-151-3D User manual
Sharp
Sharp PN-E601 User manual
Sharp
Sharp PN-R903A User guide
Sharp
Sharp LL-T15V1 User manual
Sharp
Sharp PN-V551 User manual
Sharp
Sharp PN -HW861 User manual
