SGS SPW200 User manual
FOR YOUR SAFETY
PLEASE READ THESE INSTRUCTIONS CAREFULLY
AND RETAIN THEM FOR FUTURE USE.
OWNER’S MANUAL
SPW200
PARTS WASHER
PAGE 3
PAGE 2
SPECIFICATION
MODEL No SPW200
PUMP CAPACITY 17 Litres/min
WEIGHT 25kg
DIMENSIONS:
LENGTH
WIDTH
HEIGHT
780mm
542mm
875mm
MOTOR 230V, 1ph,
50Hz
MAXIMUM WORKING CAPACITY 45 Litres
MINIMUM WORKING CAPACITY Sufficient to
cover the
pump inlet
WARNING
Read and understand instructions before use.
Use only water soluble solvents, DO NOT use flammable
solvents.Keep ignition sources away from tank and DO
NOT smoke.
WARNING
Always wear eye/face and hand protection.
Use only in a well ventilated area. DO NOT use tank
where there is (or may be) flammable vapours.
• Clean tank and replace solvent regularly to avoid concentration of
contaminants.
• Ensure fusible link (in lid strut) is intact and NEVER prop lid open.
• DO NOT leave the cleaning tank operating unattended.
• This tank is NOT suitable for paint thinners, gun wash, or air drying.
• DO NOT operate the cleaning tank when you are tired, under the influ-
ence of alcohol, drugs, or intoxication.
• When not in use switch the cleaning tank off and remove plug from
power supply.
• DO NOT operate the cleaning tank if any parts are missing or dam-
aged.
WWW.SGS-ENGINEERING.COM
PAGE 5
PAGE 4
ASSEMBLY
1. Choose a firm, flat and level surface to site the machine on, in a well-
ventilated area and away from any naked flames.
2. Assemble the legs and shelf to the parts washer as shown in the parts-
diagram, using the screws and nuts supplied.
3. Remove the pump housing cover plate and dispose of any packaging
around the pump.
4. Replace the cover plate and mount the pump housing through the slot
in the side of the tank. The switch housing protrudes through the slot
with its underside hooking over the edge of the tank.
5. Attach the earth lead from the pump to the parts washer tank.
6. Ensure all packaging is removed before filling with parts washer fluid.
OPERATION
1. Fill only with a non-flammable degreaser or cleaning agent, such as-
parts washer fluid, to just below the level of the parts shelf. DO NOT
fill with flammable solvents such as paraffin, thinners, etc. Never oper-
ate the parts washer without sufficient water.
2. Open the lid, switch the pump on and hold the part to be cleaned
under the nozzle, slowly rotate the component until clean.
3. When clean, leave to drain on the tray or in a small component con-
tainer until dry.
4. Switch off the pump and close the lid and disconnect the power sup-
ply.
5. Remove gloves and goggles, store safely.Note: Any spillages should be
mopped up immediately, so as not to cause a safety hazard.
WARNING! READ THESE ELECTRICAL SAFETY IN-
STRUCTIONS THOROUGHLY BEFORE CONNECTING
THE PRODUCT TO THE MAINS SUPPLY.
Before switching the product on, make sure that the voltage of your elec-
tricity supply is the same as that indicated on the rating plate. This product
is designed to operate on 230VAC 50Hz. Connecting it to any other power
source may cause damage.
This product may be fitted with a non-rewireable plug. If it is necessary to
change the fuse in the plug, the fuse cover must be refitted. If the fuse
cover becomes lost or damaged, the plug must not be used until a suitable
replacement is obtained.
If the plug has to be changed because it is not suitable for your socket, or
due to damage, it should be cut off and a replacement fitted, following the
wiring instructions shown below. The old plug must be disposed of safely,
as insertion into a mains socket could cause an electrical hazard.
We strongly recommend that this machine is connected to the mains sup-
ply via a Residual Current Device (RCD). If in doubt, consult a qualified
electrician. DO NOT attempt repairs yourself.
Plug must be BS1363/A
approved
ELECTRICAL CONNECTIONS
Earth
(Green & Yellow)
Blue
(Neutral)
Always fit a 3amp fuse
Live
(Brown)
WWW.SGS-ENGINEERING.COM
PAGE 7
PAGE 6
MAINTENANCE
IMPORTANT:
1. The Lid Stay incorporates a safety device in the form of a fusible link,
which closes the lid in the event of fire. The link is non-resetting and
must be replaced should it be activated.
2. Clean the pump filter regularly, by sliding it away from the pump hous-
ing and rinsing it in clean degreaser.
3. Do not allow the level of liquid in the parts washer to fall below the
pump inlet, as damage to the pump can result.
PARTS DIAGRAM
PARTS LIST
No. DESCRIPTION QTY Part No
1 COVER 1 902026
2 BASKET 1 902027
3 SPRING PAN 4 902028
4 PIN 4 902029
5 SAFETY PLATE 1 902030
6 WORK SHELF 1 902031
7 BODY 1 902032
8 SPRING WASHER 24 902033
9 HEX NUT 24 902034
10 0-RING 1 902035
11 PLUG 1 902036
12 SHELF 1 902037
13 LEG 4 902038
14 M16X12 SCREWS 24 902039
15 HEX NUT 5 902040
16 SPRING WASHER 5 902041
17 SCREW 5 902042
18 STRAIN RELIEF 2 902043
19 CABLE AND PLUG 1 902044
20 PUMP HOUSING 1 902045
21 FILTER SCREEN 1 902046
22 SWITCH 1 902047
23 SWITCH BOX 1 902048
24 FLEXIBLE PIPE 1 902049
25 ELBOW SEAT 1 902050
26 PUMP BODY 1 902051
27 PUMP BACK COVER 1 902052
28 FILTER COVER 2 902053
29 PUMP HOUSING 1 902054
30 ELBOW 1 902055
WWW.SGS-ENGINEERING.COM
EC Declaration of Conformity
This is an important document and should be retained
MANUFACTURER’S NAME:
TYPE OF EQUIPMENT:
PART NUMBER:
I, the undersigned, hereby declare that the equipment specied above
conforms to the above European Communities Directive(s) and
Standard(s).
PLACE:
DATE: (Signature)
Robert Wyatt
Company Secretary
Derby, UK
24th MAY 2018
SGS Engineering (UK) Ltd
SGS Engineering (UK) Ltd
West Side Park
Raynesway
Derby, DE21 7AZ
PARTS CLEANING TANK
SPW200
2014/35/EU Low Voltage Directive
2014/30/EU EMC Directive
2012/19/EU WEEE Directive
2011/65/EU RoHS Directive
APPLICATION OF EC COUNCIL DIRECTIVES / STANDARD:
Table of contents
Other SGS Washer manuals
Popular Washer manuals by other brands
Tricity Bendix
Tricity Bendix AW 1000 W Operating & installation instructions
Panasonic
Panasonic NA-F60L5WRB operating instructions
GE
GE WSLP1500 Dimensions and installation information
Electrolux
Electrolux EWF1284EDW Service manual
Bosch
Bosch WAN2829BSN User manual and installation instructions
LG
LG TV2516DV3B owner's manual
