Sensio SA9007 User manual

Installation

Instructions

Installation

Instructions

Product #: SA9007

Square Surface

Mount Puck Light

(1.25W)

IMPORTANT: Please read these instructions before starting installation and retain for future reference.

Components: Tools Required:

Important Safety Information

Safety Instructions

Screwdriver Bit

Drill

Please read these instructions carefully before attempting to install this product.

It is advisable to keep these instructions in a safe place for further reference. These products must not be modified; if

any modifications are made, it may invalidate the warranty and may render the product unsafe. These LED lights

operate on low voltage (24V). Do not wire the individual LED light fixtures directly to line power. This product is for

indoor use only. Keep out of moisture and use only in dry rooms.

The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go

unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be

inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any

damage is noted.

CAUTION -To reduce the risk of fire, electricshock, or injury to persons:

a) Use only insulated staples or plastic ties to secure cords

b) Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall

c) Not intended for recessed installation in ceilings, or soffits.

1.Turn off the main electrical supply for the appropriate

circuit at the breaker box.

2.This product is only suitable for connecting to a 24V DC

power source.

3.Position lights where they will not be exposed to

steam, splashes, etc.

4.The LEDs in this fixture cannot be replaced.

5. Suitable for under cabinet lighting, attached to a

mounting surface such as wood or laminate.

6.Failure to use surge protection in problem areas will

void the warranty.

7.Use only approved accessories.

8.IMPORTANT: Fixture must NOT be covered by

insulation.

Surface Light

Screws

Drill Bit

9-11mm

(3/8”-7/16”)

Adhesive

pad

Square Surface Mount Puck Light (1.25W)

Carefully remove LED light from square

cover

Screw down LED, or use adhesive pad

to affix to cabinet

Snap Square cover back on LED light

(proceed to step 5)

Mount for wire exiting side of LED light

Mark location for wire hole to be drilled Feed lead wire through hole

Snap Square cover back on LED light

Sensio America

877-501-5337

www.sensioamerica.com

•Ensure that the power is disconnected prior to cleaning.

•To keep the finish of this product, wipe over with soft cloth

periodically.

•Do not use harsh chemical solvents, it may discolor or

damage the finish.

Maintenance & Care Support

Run lead to driver

LED Power

Supply

Distributo

Connect driver to power

Mount for wire exiting under LED light

Screw down LED, or use adhesive pad

to affix to cabinet

Other Sensio Lighting Equipment manuals

Sensio

Sensio Nexus TrioTone SE11090T0 User manual

Sensio

Sensio Titan IP44 User manual

Sensio

Sensio Connex Triotone SE100490 User manual

Sensio

Sensio Neo Pro SE11598P0 User manual

Sensio

Sensio Blaze SE182720 User manual

Sensio

Sensio SE20099N0 User manual

Sensio

Sensio Titan Plus User manual

Sensio

Sensio SE14092N0 User manual

Sensio

Sensio Fino SE981320 User manual

Sensio

Sensio SE9080HD User manual

Sensio

Sensio Viva 3 User manual

Sensio

Sensio Polar IP65 User manual

Sensio

Sensio Horizon Pro SE11095P0 User manual

Sensio

Sensio Dart/Primo 2 User manual

Sensio

Sensio Neutron SE10455C0 User manual

Sensio

Sensio Luce User manual

Sensio

Sensio Vector SE181700 User manual

Sensio

Sensio Treos SE11290N0 User manual

Sensio

Sensio Linia SE980320 User manual

Sensio

Sensio Verso SE16092N0 User manual

Sensio

Sensio SE30555C0 User manual

Sensio

Sensio Gamma SE183720 User manual

Sensio

Sensio SE184720 User manual

Sensio

Sensio SE10615C0 User manual

Popular Lighting Equipment manuals by other brands

Brizo

Brizo 8SP-MU-4 manual

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 installation instructions

IKEA

IKEA BJÖRKSPIREA manual

Laserworld

Laserworld Evolution Series ES-400RGB manual

Alien

Alien RG STAR user manual

EuroLite

EuroLite LED B-40 user manual

Qazqa

Qazqa Suplux SL 3 Black 103062 instruction manual

Commercial Electric

Commercial Electric 54568141 Use and care guide

CREE LIGHTING

CREE LIGHTING 304 Series installation instructions

Goobay

Goobay 49867 user manual

ECOMAN ITALIA

ECOMAN ITALIA LED T8 instruction manual

Alkalite

Alkalite Krypton KT-81 user manual

Clas Ohlson

Clas Ohlson GU10 manual

DTS

DTS DELTA 10 F user manual

ring

ring Solar Steplight manual

One Stop Gardens

One Stop Gardens 57696 Owner's manual & safety instructions

Chauvet DJ

Chauvet DJ COREpar UV120 ILS user manual

SIREM

SIREM Swimeo A2 instructions